Search

Tetrachloroethylene (PCE) is a widely utilized volatile chemical in industrial applications, including dry cleaning and metal degreasing. Exposure to PCE potentially presents a significant health risk to workers as well as communities near contamination sites. Adverse health effects arise not only from PCE, but also from PCE degradation products, such as trichloroethylene (TCE) and vinyl chloride (VC). PCE, TCE, and VC can contaminate water, soil, and air, leading to exposure through multiple pathways, including inhalation, ingestion, and dermal contact. This study focused on a community setting in Martinsville, Indiana, a working-class Midwestern community in the United States, where extensive PCE contamination has occurred due to multiple contamination sites (referring to 'plumes'), including a Superfund site. Utilizing proton transfer reaction time-of-flight mass spectrometry (PTR-TOF-MS), PCE, TCE, and VC concentrations were measured in the exhaled breath of 73 residents from both within and outside the plume areas. PCE was detected in 66 samples, TCE in 26 samples, and VC in 68 samples. Our results revealed a significant positive correlation between the concentrations of these compounds in exhaled breath and indoor air (Pearson correlation coefficients: PCE = 0.75, TCE = 0.71, and VC = 0.89). This study confirms the presence of PCE and its degradation products in exhaled breath in a community exposure investigation, demonstrating the potential of using exhaled breath analysis in monitoring exposure to environmental contaminants. This study showed the feasibility of utilizing PTR-TOF-MS in community investigations to assess exposure to PCE and its degradation products by measuring these compounds in exhaled breath and indoor air., (Creative Commons Attribution license.)

Significant challenges remain for the remediation of chlorinated-solvent plumes in groundwater, such as trichloroethene (TCE) and tetrachloroethene (PCE). A novel slow-release permanganate gel (SRP-G) technique may show promise for the in-situ treatment (remediation) of chlorinated contaminant plumes in groundwater. A series of laboratory experiments were conducted to characterize the primary physical factors that influence SRP-G gelation processes to optimize SRP-G performance for plume treatment. Specifically, experiments were conducted to quantify gel zeta potential, particle size distribution, and viscosity to determine SRP-G gelation characteristics and processes. These experiments tested various concentrations of two SRP-G amendment solutions (NaMnO 4 and KMnO 4 ) prepared with 30-wt.% and 50-wt.% colloidal silica to determine such influences on zeta potential, particle size distribution, and viscosity. The results of this study show that SRP-G solutions with low zeta potential and relatively high pH favor more rapid SRP-G gelation. The concomitant interaction of the predominantly negatively charged colloidal silica particles and the positively charged dissociated cations (Na + and K + ) in the SRP-G solution had the effect of stabilizing charge imbalance via attraction of particles and thereby inducing a greater influence on the gelation process. Gel particle size distribution and changes in viscosity had a significant influence on SRP-G solution gelation. The addition of permanganate (NaMnO 4 or KMnO 4 ) increased the average particle size distribution and the viscosity of the SRP-G solution and decreased the overall gelation time. SRP-G amendments (NaMnO 4 or KMnO 4 ) prepared with 50-wt.% colloidal silica showed more effective gelation (and reduced gelation time) compared to SRP-G amendments prepared with 30-wt.% colloidal silica. Under the conditions of these experiments, it was determined that both the 7-wt.% NaMnO 4 solution and 90 mg/L KMnO 4 solution using 50-wt.% colloidal silica would be the optimal injection SRP-G solution concentrations for this in-situ treatment technique., Competing Interests: Declaration of competing interest The authors declare that they have no known competing financial interests or personal relationships that could have appeared to influence the work reported in this paper., (Copyright © 2024 Elsevier Ltd. All rights reserved.)

This study aims to develop and validate a comprehensive method for assessing ecological disturbances in groundwater ecosystems caused by tetrachloroethylene (PCE) contamination, utilizing flow cytometry (FCM) fingerprint approach. We hypothesized that the ecological disturbance resulting from PCE contamination would exhibit 'press disturbance', persisting over extended periods, and inducing notable phenotypic differences in the microbial community compared to undisturbed groundwater. We collected 40 groundwater samples from industrial district with a history of over twenty years of PCE contamination, along with 56 control groundwater from the national surveillance groundwater system. FCM revealed significant alterations in the phenotypic diversity of microbial communities in PCE-contaminated groundwater, particularly during the dry season. The presence of specific dechlorinating bacteria (Dehalococcoides, Dehalogenimonas, and Geobacter) and their syntrophic partners was identified as an indicator of contamination. Phenotypic diversity measures provided clearer and more direct reflections of contamination impact compared to taxonomic diversity measures. This study establishes FCM fingerprinting as a simple, robust, and accurate method for evaluating ecological disturbances, with potential applications in early warning systems and continuous monitoring of groundwater contamination. The findings not only underscore the sensitivity of FCM in detecting phenotypic variations induced by environmental stressors but also highlight its utility in understanding the complex dynamics of microbial communities in contaminated groundwater ecosystems., Competing Interests: Declaration of competing interest The authors declare that they have no known competing financial interests or personal relationships that could have appeared to influence the work reported in this paper., (Copyright © 2024 Elsevier B.V. All rights reserved.)

The residual amount of halogenated solvents in olive oil is an important indicator of its quality. The National Olive Oil Quality Standard GB/T 23347-2021 states that the residual amount of individual halogenated solvents in olive oil should be ≤0.1 mg/kg and that the total residual amount of halogenated solvents should be ≤0.2 mg/kg. COI/T.20/Doc. No. 8-1990, which was published by the International Olive Council, describes the standard method used for the determination of halogenated solvents in olive oil. Unfortunately, this method is cumbersome, has poor repeatability and low automation, and is unsuitable for the detection and analysis of residual halogenated solvents in large quantities of olive oil. At present, no national standard method for determining residual halogenated solvents in olive oil is available in China. Thus, developing simple, efficient, accurate, and stable methods for the determination of residual halogenated solvents in olive oil is imperative. In this paper, a method based on automatic headspace gas chromatography was established for the determination of residual halogenated solvents, namely, chloroform, carbon tetrachloride, 1,1,1-trichloroethane, dibromochloromethane, tetrachloroethylene, and bromoform, in olive oil. The samples were processed as follows. After mixing, 2.00 g (accurate to 0.01 g) of the olive oil sample was added into a 20 mL headspace injection bottle and immediately sealed for headspace gas chromatography analysis. Blank virgin olive oil was used to prepare a standard working solution and the external standard method for quantification. The solvents used in the preparation of halogenated solvent standard intermediates were investigated and methanol was selected as a replacement for N , N -dimethylacetamide to prepare a halogenated solvent standard intermediate owing to its safety. The effects of different injection times (1, 2, 3, 4, 5, 6 s), equilibration temperatures (60, 70, 80, 90, 100, 110, 120 ℃), and equilibration times (4, 5, 8, 10, 20, 30, 40 min) of the headspace sampler on the detection of the residual amounts of the six halogenated solvents were investigated. The optimal injection time and equilibration temperature were 3 s and 90 ℃, respectively. The method demonstrated good analytical performance for the six halogenated solvents when the equilibration time was 30 min. A methodological study was conducted on the optimized method, and the results showed that the six halogenated solvents exhibited good linear relationships in the range of 0.002-0.200 mg/kg, with correlation coefficients of ≥0.9991. The limits of detection (LODs) and quantification (LOQs) of 1,1,1-trichloroethane and bromoform were 0.0006 and 0.002 mg/kg, respectively. The LODs and LOQs of chloroform, carbon tetrachloride, dibromochloromethane, and tetrachloroethylene were 0.0003 and 0.001 mg/kg, respectively. The average recoveries under different spiked levels were 85.53%-115.93%, and the relative standard deviations ( n =6) were 1.11%-8.48%. The established method was used to analyze 13 olive oil samples available in the market. Although no halogenated solvents were detected in these samples, a limited number of samples does not represent all olive oils. Hence, monitoring residual halogenated solvents in olive oil remains necessary for its safe consumption. The LOQs of the method for the six halogenated solvents were significantly lower than that of the COI/T.20/Doc. No. 8-1990 standard method (0.02 mg/kg). In addition, the developed method can be conducted under short operation times with high precision and degree of automation as well as good accuracy. Thus, the proposed method is suitable for the determination and analysis of the residues of the six halogenated solvents in large batches of olive oil samples.

Background: The involvement of Perchloroethylene (PCE) in the development of autoimmune diseases has been reported. However, few studies investigated immunotoxicity in PCE-exposed workers., Objective: To study changes in the oxidative stress and cytokine profile of young female dry-cleaning workers exposed to PCE., Methods: Thirty-eight exposed workers and 38 unexposed controls were recruited. All the participants were young nonsmoker females. Individual interviews were conducted by a physician. Blood samples were collected and hematological tests were performed by an automated Coulter Counter. Plasma PCE levels were determined using gas chromatography/flame ionization detection. Plasma total antioxidant capacity (TAC), Catalase (CAT), Superoxide dismutase (SOD), and Malondialdehyde (MDA) levels were measured using the colorimetric method. The levels of plasma cytokines interleukin-1β (IL-1β), IL-2, IL-4, IL-6, IL-8, tumor necrosis factor-α (TNF-α) and interferon-γ (IFN-γ) were measured by commercially kits., Results: The levels of plasma PCE averaged 561±96 ng/ml in the exposed group compared with 1.3±0.5 ng/ml in the controls. The hematological tests failed to find abnormalities in the exposed workers. Exposed workers presented significantly increased plasma levels of MDA, SOD and CAT. There were no significant differences between the two groups for level of plasma TAC. Significantly increased plasma IL-1β and TNF-α and decreased IL-2 and IL-8 levels were seen in the exposed workers. There were no significant differences between the two groups for IL-4, IL-6, and IFN-γ., Conclusion: PCE exposure resulted in changed cytokine profile in dry-cleaning workers, suggesting the potential immunotoxicity of PCE at low exposure levels.