Search

Abstract: A novel liquid chromatographic (LC) method with repeated injections of Suwannee River Fulvic Acid (SRFA) was used to investigate its adsorptive fractionation by synthetic α-Al2O3. Eluent (i.e., non-retained) SRFA for each injection was monitored by two ultraviolet (UV) absorbance detection channels (300 and 365nm) and one fluorescence detection channel (λ ex =350nm, λ em =450nm). Preferential adsorption of SRFA constituents was revealed by the different responses of the three LC detection channels. Samples of non-retained SRFA from injections of three independent replicate experiments were collected and aggregated for subsequent analysis by steady state ultraviolet–visible (UV/vis) absorption spectrometry and size exclusion chromatography (SEC). The ratio of absorbance at 254 and 204nm, a surrogate for specific UV absorbance at 254nm, increased with increasing injection number for the non-retained SRFA, indicating the preferential adsorption of SRFA constituents containing aromatic moieties. SEC analysis confirmed the preferential adsorption of higher molecular weight (MW) SRFA constituents as the non-adsorbed SRFA fractions increased in MW across the series of injections. The SEC results also suggested that certain SRFA constituents in the ca. 2–5kDa MW range adsorbed in early injections were displaced by higher MW species (ca. 5–10kDa) in later injections. [Copyright &y& Elsevier]

Abstract: The capabilities of three simplified analytical equations to accurately model electrostatic interactions during proton binding and release by linear anionic polyelectrolytes in aqueous solution were evaluated. The impermeable sphere (IS), Donnan (DN), and cylindrical (CY) electrostatic models were fit to experimental acid–base titration curves of linear polyacrylamide-co-acrylate having ionizable site densities ranging from ca. 10–35%. The titrations were conducted in 0.003–0.12M NaCl solutions and the sum of squared errors from modeled and experimental data was used as a comparative index of each model’s capability. In addition, the relative size of each polyelectrolyte was estimated from its measured specific viscosity and then compared against the values obtained from the fitting procedure for the size parameter that each model contained. Although the IS and DN electrostatic models could be used to obtain reasonably good fits to each titration curve, the size parameter values obtained by each model were not reflective of the actual polyelectrolyte sizes, indicating that the models had limited physical meaning and that the size parameter was essentially just an additional fitting parameter in each model. In contrast, the CY model was not only more effective in its ability to fit the titration data but also provided a better physical representation of the polyelectrolyte size. Therefore, for polyelectrolytes that remain essentially linear or are only loosely coiled such that counter ions are free to travel throughout the polymer structure, we conclude that the CY model and its morphological representation of a cylindrical polyelectrolyte are more valid and realistic than the IS and DN models and their representation of polyelectrolytes as spheres. [ABSTRACT FROM AUTHOR]

The molecular weight (MW) fractionation of purified Aldrich humic acid (PAHA) resulting from adsorption on kaolinite and hematite was investigated for different solution pH and phosphate conditions. Adsorption was highly pH-dependent, with higher uptake at lower pH values. For all pH conditions, the weight-average MW (MWw) of residual PAHA remaining in solution after adsorption deviated from the original MWw, indicating that preferential adsorption of certain MW components occurred. The extent of preferential adsorption depended on the percent carbon adsorption at a given pH condition. For similar percent carbon adsorption ranges, a greater extent of preferential adsorption of the higher MW PAHA components was observed with higher pH values as demonstrated by the lowest residual MWw value occurring at pH 9. Detailed analyses of selected residual PAHA samples clearly showed that adsorption selectivity for particular MW components was strongly influenced by solution pH. The extent of preferential adsorption of lower MW PAHA components decreased in the presence of a small amount of phosphate. This effect was more evident for hematite than kaolinite, and became greater with lower solution pH irrespective of the mineral type. The different fractionation patterns observed for PAHA were reasonably well explained by the physicochemical trends occurring in its MWw fractions and the underlying sorption processes. [Copyright &y& Elsevier]

Molecular weight (MW) fractionation of Suwannee River fulvic acid (SRFA) and purified Aldrich humic acid (PAHA) by adsorption onto kaolinite and hematite was investigated in equilibrium and rate experiments with a size-exclusion chromatography system using ultraviolet (UV) light detection. The extent of adsorptive fractionation based on UV detection was positively correlated with the percent carbon adsorption for both humic substances (HS), although the specific fractionation pattern observed depended on the particular HS and mineral used. Higher MW fractions of SRFA, an aquatic HS, were preferentially adsorbed to both kaolinite and hematite whereas the fractionation trends for PAHA, a terrestrial peat HS, differed for the two minerals. The contrasting fractionation patterns for SRFA versus PAHA can be explained reasonably well by the different structural trends that occur in their respective MW fractions and the underlying adsorption processes. Rate studies of adsorptive fractionation revealed an initial rapid uptake of smaller HS molecules by the mineral surfaces, followed by their replacement at the surface by a much slower uptake of the larger HS molecules present in aqueous solution. [Copyright &y& Elsevier]