Search

We report the effects of annealing on the morphology and crystallization kinetics for the high-κ gate dielectric replacement candidate hafnium oxide (HfO2). HfO2 films were grown by atomic layer deposition (ALD) on thermal and chemical SiO2 underlayers. High-sensitivity x-ray diffractometry shows that the as-deposited ALD HfO2 films on thermal oxide are polycrystalline, containing both monoclinic and either tetragonal or orthorhombic phases with an average grain size of ∼8.0 nm. Transmission electron microscopy shows a columnar grain structure. The monoclinic phase predominates as the annealing temperature and time increase, with the grain size reaching ∼11.0 nm after annealing at 900 °C for 24 h. The crystallized fraction of the film has a strong dependence on annealing temperature but not annealing time, indicating thermally activated grain growth. As-deposited ALD HfO2 films on chemical oxide underlayers are amorphous, but show strong signatures of ordering at a subnanometer level in Z-contrast scannin...

A study was undertaken to determine the efficacy of various underlayers for the nucleation and growth of atomic layer deposited HfO2 films. These were compared to films grown on hydrogen terminated Si. The use of a chemical oxide underlayer results in almost no barrier to film nucleation, enables linear and predictable growth at constant film density, and the most two-dimensionally continuous HfO2 films. The ease of nucleation is due to the large concentration of OH groups in the hydrous, chemical oxide. HfO2 grows on chemical oxide at a coverage rate of about 14% of a monolayer per cycle, and films are about 90% of the theoretical density of crystalline HfO2. Growth on hydrogen terminated Si is characterized by a large barrier to nucleation and growth, resulting in three-dimensional, rough, and nonlinear growth. Thermal oxide/oxynitride underlayers result in a small nucleation barrier, and nonlinear growth at low HfO2 coverages. The use of chemical oxide underlayers clearly results in the best HfO2 layers. Further, the potential to minimize the chemical oxide thickness provides an important research opportunity for high-κ gate dielectric scaling below 1.0 nm effective oxide thickness.

We demonstrate significantly improved thermal stability of the amorphous phase for hafnium-based gate dielectrics through the controlled addition of Al2O3. The (HfO2)x(Al2O3)1−x films, deposited using atomic layer deposition, exhibit excellent control over a wide range of composition by a suitable choice of the ratio between the Al and Hf precursor pulses. By this method, extremely predictable hafnium aluminate compositions are obtained, with Hf cation fractions ranging from 20% up to 100%, as measured by medium energy ion scattering. Using x-ray diffraction, we show that (HfO2)x(Al2O3)1−x films with Hf:Al∼3:1 (25% Al) remain amorphous up to 900 °C, while films with Hf:Al∼1:3 (75% Al) remain amorphous after a 1050 °C spike anneal.