Search

Core-shell nanowires offer great potential to enhance the efficiency of light-emitting diodes (LEDs) and expand the attainable wavelength range of LEDs over the whole visible spectrum. Additionally, nanowire (NW) LEDs can offer both improved light extraction and emission enhancement if the diameter of the wires is not larger than half the emission wavelength (λ/2). However, AlGaInP nanowire LEDs have so far failed to match the high efficiencies of traditional planar technologies, and the parameters limiting the efficiency remain unidentified. In this work, we show by experimental and theoretical studies that the small nanowire dimensions required for efficient light extraction and emission enhancement facilitate significant loss currents, which result in a low efficiency in radial NW LEDs in particular. To this end, we fabricate AlGaInP core-shell nanowire LEDs where the nanowire diameter is roughly equal to λ/2, and we find that both a large loss current and a large contact resistance are present in the samples. To investigate the significant loss current observed in the experiments in more detail, we carry out device simulations accounting for the full 3D nanowire geometry. According to the simulations, the low efficiency of radial AlGaInP nanowire LEDs can be explained by a substantial hole leakage to the outer barrier layer due to the small layer thicknesses and the close proximity of the shell contact. Using further simulations, we propose modifications to the epitaxial structure to eliminate such leakage currents and to increase the efficiency to near unity without sacrificing the λ/2 upper limit of the nanowire diameter. To gain a better insight of the device physics, we introduce an optical output measurement technique to estimate an ideality factor that is only dependent on the quasi-Fermi level separation in the LED. The results show ideality factors in the range of 1-2 around the maximum LED efficiency even in the presence of a very large voltage loss, indicating that the technique is especially attractive for measuring nanowire LEDs at an early stage of development before electrical contacts have been optimized. The presented results and characterization techniques form a basis of how to simultaneously optimize the electrical and optical efficiency of core-shell nanowire LEDs, paving the way to nanowire light emitters that make true use of larger-than-unity Purcell factors and the consequently enhanced spontaneous emission. [ABSTRACT FROM AUTHOR]

Photoinduced intramolecular electron-transfer (ET) and energy-transfer (EnT) processes in two rotaxanes, one containing both zinc porphyrin and C60fullerene moieties incorporated around the Cu(I) bisphenanthroline core [(ZnP)2−Cu(I)(phen)2−C60] and a second complex lacking the fullerene [(ZnP)2−Cu(I)(phen)2], were studied by time-resolved electron paramagnetic resonance (TREPR) spectroscopy at 9.5 GHz (X-band) combined with a selective photoexcitation of the rotaxane moieties. The experiments were carried out in isotropic toluene and ethanol and in anisotropic nematic liquid-crystal (E-7) media over a wide range of temperatures corresponding to the different states of the solvents. The TREPR results are compared with those obtained previously by optical methods in dichloromethane at room temperature. It is demonstrated that the efficiencies and pathways of the light-driven ET and EnT processes in both rotaxanes strongly depend on the properties of their microenvironment, resulting in the formation of distinct charge-separated states under different experimental conditions. The complementary results revealed by the optical and TREPR techniques are attributed to the relatively high conformational mobility of the mechanically interlocked rotaxane systems. Because of the solute−solvent interactions, the rotaxanes are able to change conformation in different microenvironments, which affects the parameters of the photoinduced processes occurring in these systems. [ABSTRACT FROM AUTHOR]