Search

The capabilities of two-dimensional separation using a high irradiance laser ionization orthogonal time-of-flight mass spectrometer (LI-O-TOFMS) were demonstrated in this paper. Ions were separated via their initial kinetic energy in one dimension and their mass-to-charge ratios in the other dimension. Investigation of the transient ion profiles after laser pulses revealed that the separation of analyte ions from multiply charged ions and gas species ions was achieved. Comparison of mass spectra in the normal accumulation mode and in the two-dimensional separation mode indicated that the relative sensitivity coefficients are stable and close to their true values in the two-dimensional separation mode, especially for trace elements that are prone to interference. 10.1021/ac902981j

The simultaneous determination of nonmetallic elements in solid samples is difficult owing to their discrepant physical and chemical properties. We developed a high-irradiance laser ionization orthogonal time-of-flight mass spectrometry (LI-O-TOFMS) system and applied it for the determination of nonmetallic elements in solids. Helium was used as the buffer gas at 250 Pa in the source chamber; the laser irradiance was about 7 x 1010 W/[cm.sup.2]. A series of artificial standards containing B, C, N, O, F, Si, P, S, CI, As, Br, Se, I, and Te were used. Explicit spectra were obtained with only a little interference from gas species and doubly charged matrix ions. Standardless semiquantitative analysis could be accomplished with a novel sampling methodology to obtain near-uniform sensitivity coefficients for different elements. Limits of detection (LOD) at microgram per gram level and a dynamic range of 6 orders of magnitude were achieved for most nonmetallic elements. 10.1021/ac9026912

A compact high-irradiance laser ionization time-of-flight mass spectrometry system has been developed for the multielemental analysis of solids. Helium was introduced into the ion source as a buffer gas to cool high kinetic energy ions and suppress the interference of multicharged ions. A special pulse train repelling mode was used to achieve explicit spectra. Two quantitative methods are described for the laser ionization mass spectrometry in this paper. The first of these is the routine calibration curve quantitation, in which various matrix-matched standards are required; the second method, which is based on the uniform correlation between the signal and elemental concentration of different samples, is more convenient and covers a typical dynamic range of 6 orders. All the investigations and results indicate satisfactory performance of the newly developed instrument and its applicability for simultaneous multielemental analysis of solid samples.

The poultry industry has used organoarsenicals, such as 3-nitro-4-hydroxyphenylarsonic acid (Roxarsone, ROX), to prevent disease and to promote growth. Although previous studies have analyzed arsenic species in chicken litter after composting or after application to agricultural lands, it is not clear what arsenic species were excreted by chickens before biotransformation of arsenic species during composting. We describe here the identification and quantitation of arsenic species in chicken litter repeatedly collected on days 14, 24, 28, 30, and 35 of a Roxarsone-feeding study involving 1600 chickens of two strains. High performance liquid chromatography separation with simultaneous detection by both inductively coupled plasma mass spectrometry and electrospray ionization tandem mass spectrometry provided complementary information necessary for the identification and quantitation of arsenic species. A new metabolite, N-acetyl-4-hydroxy-m-arsanilic acid (N-AHAA), was identified, and it accounted for 3-12% of total arsenic. Speciation analyses of litter samples collected from ROX-fed chickens on days 14, 24, 28, 30, and 35 showed the presence of N-AHAA, 3-amino-4-hydroxyphenylarsonic acid (3-AHPAA), inorganic arsenite (As(III)), arsenate (As(V)), monomethylarsonic acid (MMA(V)), dimethylarsinic acid (DMA(V)), and ROX. 3-AHPAA accounted for 3-19% of the total arsenic. Inorganic arsenicals (the sum of As(III) and As(V)) comprised 2-6% (mean 3.5%) of total arsenic. Our results on the detection of inorganic arsenicals, methylarsenicals, 3-AHPAA, and N-AHAA in the chicken litter support recent findings that ROX is actually metabolized by the chicken or its gut microbiome. The presence of the toxic metabolites in chicken litter is environmentally relevant as chicken litter is commonly used as fertilizer.

The separation of classical, aromatic, oxidized, and heteroatomic (sulfur-containing) naphthenic acid (NA) species from unprocessed and ozone-treated oil sands process-affected water (OSPW) was performed using silver-ion (Ag-ion) solid phase extraction (SPE) without the requirement of pre-methylation for NAs. OSPW samples before SPE and SPE fractions were characterized using ultra performance liquid chromatography ion mobility time-of-flight mass spectrometry (UPLC-IM-TOFMS) to corroborate the separation of distinct NA species. The mass spectrum identification applied a mass tolerance of ±1.5 mDa due to the mass errors of NAs were measured within this range, allowing the identification of O2S-NAs from O2-NAs. Moreover, separated NA species facilitated the tandem mass spectrometry (MS/MS) characterization of NA compounds due to the removal of matrix and a simplified composition. MS/MS results showed that classical, aromatic, oxidized, and sulfur-containing NA compounds were eluted into individual SPE fractions. Overall results indicated that the separation of NA species using Ag-ion SPE is a valuable method for extracting individual NA species that are of great interest for environmental toxicology and wastewater treatment research, to conduct species-specific studies. Furthermore, the separated NA species on the milligram level could be widely used as the standard materials for environmental monitoring of NAs from various contamination sites.

This paper investigates the oxidation of oil sands process-affected water (OSPW) by potassium ferrate(VI). Due to the selectivity of ferrate(VI) oxidation, two-ring and three-ring fluorescing aromatics were preferentially removed at doses <100 mg/L Fe(VI), and one-ring aromatics were removed only at doses ≥100 mg/L Fe(VI). Ferrate(VI) oxidation achieved 64.0% and 78.4% removal of naphthenic acids (NAs) at the dose of 200 mg/L and 400 mg/L Fe(VI) respectively, and NAs with high carbon number and ring number were removed preferentially. (1)H nuclear magnetic resonance ((1)H NMR) spectra indicated that the oxidation of fluorescing aromatics resulted in the opening of some aromatic rings. Electron paramagnetic resonance (EPR) analysis detected signals of organic radical intermediates, indicating that one-electron transfer is one of the probable mechanisms in the oxidation of NAs. The inhibition effect of OSPW on Vibrio fischeri and the toxicity effect on goldfish primary kidney macrophages (PKMs) were both reduced after ferrate(VI) oxidation. The fluorescing aromatics in OSPW were proposed to be an important contributor to this acute toxicity. Degradation of model compounds with ferrate(VI) was also investigated and the results confirmed our findings in OSPW study.

Ultraperformance liquid chromatography ion mobility time-of-flight mass spectrometry (UPLC-IM-TOFMS), integrating traveling wave ion mobility spectrometry (TWIMS) with negative electrospray ionization (ESI) mode, was used to achieve two-dimensional (2D) separation (drift vs retention times) of naphthenic acids (NAs). Unprocessed and ozonated commercial NAs were used for method development. Only O2-NAs were found in unprocessed NAs with ozonation creating O3-NAs and O4-NAs. Unprocessed and ozonated oil sands process-affected waters (OSPW) were examined to validate the method for complex matrix NAs. Ozonation increased the x number for Ox-NAs (2 ≤ x ≤ 5) and also impacted the -Z number distribution. OSPW extracted using dichloromethane removed the potential for sample matrix impacts and was used for MS/MS NAs characterization. The Ox-NAs (2 ≤ x ≤ 6) were identified with O2-NAs separated into three clusters indicating isobaric and isomeric species. MS/MS was used to verify compounds, while also indicating the presence of CH3CH2S- NAs groups. This result may be useful for future studies of sulfur-NAs fate, toxicity, and treatment. Overall, the value-added information provided by UPLC-IM-TOFMS makes it a promising analytical technique for analysis of NAs in complex OSPW samples. Moreover, this methodology can be used for other matrices to investigate relative molecular sizes and to separate complex species (e.g., fatty acids, lipids), making it beneficial for environmental and bioanalytical applications.

Exposure to chlorination disinfection byproducts (DBPs) is potentially associated with an increased risk of bladder cancer. Four halobenzoquinones (HBQs) have been detected in treated drinking water and have shown potency in producing reactive oxygen species and inducing damage to cellular DNA and proteins. These HBQs are unstable in drinking water. The fate and behavior of these HBQs in drinking water distribution systems is unclear. Here we report the high-resolution mass spectrometry identification of the transformation products of HBQs as halo-hydroxyl-benzoquinones (OH-HBQs) in water under realistic conditions. To further examine the kinetics of transformation, we developed a solid-phase extraction with ultrahigh-performance liquid chromatography tandem mass spectrometry (SPE-UHPLC-MS/MS) method to determine both the HBQs and OH-HBQs. The method provides reproducible retention times (SD < 0.05 min), limits of detection (LODs) at subnanogram per liter levels, and recoveries of 68%-96%. Using this method, we confirmed that decrease of HBQs correlated with increase of OH-HBQs in both the laboratory experiments and several distribution systems, supporting that OH-HBQs were more stable forms of HBQ DBPs. To understand the toxicological relevance of the OH-HBQs, we studied the in vitro toxicity with CHO-K1 cells and determined the IC50 of HBQs and OH-HBQs ranging from 15.9 to 72.9 μM. While HBQs are 2-fold more toxic than OH-HBQs, both HBQs and OH-HBQs are substantially more toxic than the regulated DBPs.

We report here the characterization of twelve halobenzoquinones (HBQs) using electrospray ionization (ESI) high resolution quadrupole time-of-flight mass spectrometry. The high resolution negative ESI spectra of the twelve HBQs formed two parent ions, [M + H(+) + 2e(-)], and the radical M(-•). The intensities of these two parent ions are dependent on their chemical structures and on instrumental parameters such as the source temperature and flow rate. The characteristic ions of the HBQs were used to develop an ultra pressure liquid chromatography-tandem mass spectrometry (UPLC-MS/MS) method. At the UPLC flow rate (400 μL/min) and under the optimized ESI conditions, eleven HBQs showed the stable and abundant transitions [M + H(+) + 2e(-)] → X(-) (X(-) representing Cl(-), Br(-), or I(-)), while dibromo-dimethyl-benzoquinone (DBDMBQ) showed only the transition of M(-•) → Br(-). The UPLC efficiently separates all HBQs including some HBQ isomers, while the MS/MS offers exquisite limits of detection (LODs) at subng/mL levels for all HBQs except DBDMBQ. Combined with solid phase extraction (SPE), the method LOD is down to ng/L. The results from analysis of authentic samples demonstrated that the SPE-UPLC-MS/MS method is reliable, fast, and sensitive for the identification and quantification of the twelve HBQs in drinking water.

An elemental imaging method using a laser ionization orthogonal time-of-flight mass spectrometer system was developed for the simultaneous detection of all metal and nonmetal elements. The instrument control and data processing were realized by self-developed programs. This system is capable of simultaneous detection of metal and nonmetal elements, with a spatial resolution of 50 μm, the lowest detection limits of 3 × 10(-7) g/g (Li), and a dynamic range of 7 orders of magnitude. Moreover, this technique does not require standards for quantitative analysis and can be a powerful and versatile tool for elemental imaging.