Search

To suppress catalytic coking, TiO 2 passivation films were deposited on the inner walls of SS316 stainless steel tubes by atomic layer deposition (ALD). Indentation test results showed a platform on the indentation curve of TiO 2 films grown over 2000 ALD cycles due to internal stress-induced microcracks. In coking experiments, the TiO 2 -coated tubes exhibited a higher heat flux and lower pressure difference than bare ones. Analysis of the coking surface revealed that TiO 2 thin film passivation can reduce the size and number of particulate deposits. At the same time, passivation treatment inhibits the formation of filamentous carbon and improves anti-coking performance by reducing the ability of the tube to adsorb amorphous deposition products. The coking surfaces of TiO 2 -coated tubes had less graphitization, indicating that the coking products had fewer defects and lower activated carbon contents., Competing Interests: The authors declare no competing financial interest., (© 2020 American Chemical Society.)

Controllable growth of metal nanostructures on epitaxial graphene (EG) is particularly interesting and important for the applications in electric devices. Bi nanostructures on EG/SiC are fabricated through thermal decomposition of SiC and subsequent low-flux evaporation of Bi. The orientation, atomic structure, and thickness-dependent electronic states of Bi are investigated by scanning tunneling microscopy/spectroscopy. It is found that metallic Bi nanoflakes and nanorods prefer to grow on the SiC buffer layer region with higher diffusion barrier, but Bi nanoribbons are formed on regularly ordered EG. Although the thicker Bi nanoribbons of 11 monolayers on EG are still metallic, the thinner ones become semiconducting owing to the interfacial effect. This indicates that the electronic states and physical properties of Bi are substrate-dependent. The results are helpful for the design of Bi- and graphene-based electronic and spintronic devices.

Surface-enhanced Raman scattering (SERS) has proven to be an effective technique for identifying and providing fingerprint structural information on various analytes in low concentration. However, this analytical technique has been plagued by the ubiquitous presence of organic contaminants on roughened SERS substrate surfaces, which not only often result in poorer detection sensitivity but also significantly affect the reproducibility and accuracy of SERS analysis. Herein, we developed a clean, stable, and recyclable three-dimensional (3D) chestnutlike Ag/WO 3-x (0 < x < 0.28) SERS substrate by simple hydrothermal reaction and subsequent green in situ decoration of silver nanoparticles. None of the organic additives were used in synthesis, which ensures the substrate surfaces are completely clean and free of interferences from impurities. The innovative design combines the SERS enhancement effect and self-cleaning property, making it a multifunctional and reusable SERS platform for highly sensitive SERS detection. Using malachite green as a model target, the as-prepared SERS substrates exhibited good reproducibility (relative standard deviation of 7.5%) and pushed the detection limit down to 0.29 pM. The enhancement factor was found to be as high as 1.4 × 10 7 based on the analysis of 4-aminothiophenol. The excellent regeneration performance indicated that the 3D biomimetic SERS substrates can be reused many times. In addition, the fabricated substrate was successfully employed for detecting thiram in water with a detection limit of 0.32 nM, and a good linear relationship was obtained between the logarithmic intensities and the logarithmic concentrations of thiram ranging from 1 nM to 1 μM. More importantly, the resultant SERS-active colloid can be used for accurate and reliable determination of thiram in real fruit peels. These results predict that the proposed SERS system have great potential toward rapid, reliable, and on-site analysis, especially for food safety and environmental supervision.

Surface-enhanced Raman scattering (SERS) has been considered as a promising sensing technique to detect low-level analytes. However, its practical application was hindered owing to the lack of uniform SERS substrates for ultrasensitive and reproducible assay. Herein, inspired by the natural cactus structure, we developed a cactus-like 3D nanostructure with uniform and high-density hotspots for highly efficient SERS sensing by both grafting the silicon nanoneedles onto Ag dendrites and subsequent decoration with Ag nanoparticles. The hierarchical scaffolds and high-density hotspots throughout the whole substrate result in great amplification of SERS signal. A high Raman enhancement factor of crystal violet up to 6.6 × 10(7) was achieved. Using malachite green (MG) as a model target, the fabricated SERS substrates exhibited good reproducibility (RSD ∼ 9.3%) and pushed the detection limit down to 10(-13) M with a wide linear range of 10(-12) M to 10(-7) M. Excellent selectivity was also demonstrated by facilely distinguishing MG from its derivative, some organics, and coexistent metal ions. Finally, the practicality and reliability of the 3D SERS substrates were confirmed by the quantitative analysis of spiked MG in environmental water with high recoveries (91.2% to 109.6%). By virtue of the excellent performance (good reproducibility, high sensitivity, and selectivity), the cactus-like 3D SERS substrate has great potential to become a versatile sensing platform in environmental monitoring, food safety, and medical diagnostics.

Three-dimensional (3D) hierarchical nanostructures have been considered as one of the most promising surface-enhanced Raman spectroscopy (SERS) substrates because of the ordered arrangement of high-density hotspots along the third dimension direction. Herein, we reported a unique 3D nanostructure for SERS detection based on silver nanoparticles (AgNPs) decorated zinc oxide/silicon (ZnO/Si) heterostructured nanomace arrays. They were prepared by two steps: (1) Si nanoneedles were grafted onto ZnO nanorod arrays via a catalyst-assisted vapor-liquid-solid (VLS) growth mechanism. (2) AgNPs were rapidly immobilized on the surface of nanomaces by a facile galvanic displacement reaction. The fabricated substrates were employed to detect rhodamine 6G (R6G) with a detection limit down to 10(-16) M, and exhibited a high-enhanced performance (enhancement factor (EF) as high as 8.7 × 10(7)). To illustrate the potential value of the prepared substrates, the different concentrations of melamine aqueous solution (from 10(-4) to 10(-10) M) were detected, and a quantitative relationship between the SERS spectrum intensity and the melamine concentration had been established. In addition, the measure of melamine residual in pure milk was carried out successfully, and the results indicated that the prepared 3D nanomace substrates had great potential in food inspection, environment protection, and a few other technologically important fields.