Search

Evaluating the wettability state of reservoir rocks is key for understanding and optimizing waterflooding and improved oil recovery techniques that imply the use of low-salinity water. Aside from established petrophysical techniques, such as Amott imbibition tests, we evaluated the Washburn capillary rise method as a low-cost, easy-to-implement, and rapid screening tool for probing the wettability state of rock samples. The well-known limitations of this method are discussed and circumvented. We show that measuring the capillary rise of two liquids -brine and n -octane-is required to assess the evolution of the wettability state of a material induced by various treatments. The wettability state is quantified by the adhesion tension of brine to the solid. The higher the adhesion tension of brine, the more water-wet the sample. An increase in oil-wetness is observed when the sample is contacted with a crude oil or its released waters; an increase in water-wetness is obtained by postcontacting the oil-wet sample with low-salinity brine or surfactant solutions. The Washburn capillary rise is revealed to be a robust method for screening wettability alteration. With a typical duration of 1-10 min, it allows reproducibility check and screening of a wide range of brine compositions in a reasonable time frame. Therefore, it is a relevant tool to identify the most favorable brine compositions to be tested afterward with more time-consuming techniques, such as Amott tests and corefloods., Competing Interests: The authors declare no competing financial interest., (© 2024 The Authors. Published by American Chemical Society.)

The colloidal stability of non-motile algal cells in water drives their distribution in space. An accurate description of the interfacial properties of microalgae is therefore critical to understand how microalgae concentrations can change in their biotope or during harvesting processes. Here, we probe the surface charges of three unicellular algae─ Chlorella vulgaris , Nannochloropsis oculata , and Tetraselmis suecica ─through their electrophoretic mobility. Ohshima's soft particle theory describes the electrokinetic properties of particles covered by a permeable polyelectrolyte layer, a usual case for biological particles. The results appear to fit the predictions of Ohshima's theory, proving that all three microalgae behave electrokinetically as soft particles. This allowed us to estimate two characteristic parameters of the polyelectrolyte external layer of microalgae: the volume charge density and the hydrodynamic penetration length. Results were compared with transmission electron microscopy observations of the algal cells' surfaces, and in particular of their extracellular polymeric layer, which was identified with the permeable shell evidenced by electrophoretic measurements. Noticeably, the algal surface potentials estimated from electrophoretic mobility using the soft particle theory are less negative than the apparent zeta potentials. This finding indicates that electrostatics are expected to play a minor role in phenomena of environmental and industrial importance, such as microalgae aggregation or adhesion.

Three pentyl and three aryl 1-O-monoglyceryl ethers prepared via a green catalytic route were investigated as hydrotropic solvents. Their amphiphilicities were quantified by comparing their so-called "fish" diagrams constructed with oils of increasing hydrophobicity (EACN). For the same number of carbon atoms, the presence of a methyl substituent in β position makes the hydrotrope slightly more hydrophobic, as evidenced by the more hydrophobic optimal oil. Branched isomers are also less efficient since they require higher concentrations to get microemulsions. The presence of an aromatic moiety within the hydrophobic chain increases the solubility of the hydrotrope in water in comparison to the alkyl derivative that has the same number of carbon atoms. It also modifies significantly the associative behavior in oil/water systems: Benzylglycerol monoether is able to form Winsor III systems, just as the pentyl derivatives, but with much more polar oils, whereas phenylglycerol is not. In oil/water systems, all glycerol-derived amphiphiles exhibit a twice-lower temperature-sensitivity compared to their ethyleneglycol counterparts. The pentyl and benzyl 1-O-monoglyceryl ethers can be classified as amphiphilic solvents, or "solvo-surfactants", as regards to their surface-active properties and good solubilizing abilities.

2,7-Octadienyl ethers of tri- and tetraethylene glycol (C(8:2)E(3) and C(8:2)E(4)) have been synthesized by the atom-economical butadiene telomerization of the corresponding poly(ethylene glycols). On one hand, this synthetic path is attractive because it is expeditious and environmentally benign, and on the other hand, it provides unconventional amphiphiles for which the lipophilic chains possess two double bonds. These two unsaturations increase the global hydrophilicity of the compound, which is also highlighted by the modelization of the compounds using the conductor-like screening model for real solvents (COSMO-RS). The behavior of C(8:2)E(3) and C(8:2)E(4) in binary amphiphile/water and ternary amphiphile/oil/water systems is therefore greatly modified compared to that of the conventional fully saturated homologues (C(8)E(3) and C(8)E(4)) that are easily obtained after hydrogenation. This results in a lowered efficiency of the unsaturated compounds for oil solubilization. The usual Winsor-type microemulsion systems are formed, and for the same oil, the DLS investigation of the microstructure of the Winsor I microemulsion does not highlight any difference in the self-association between the unsaturated and saturated compounds.

The equilibrium phase behavior of the well-defined system tetraethyleneglycol decyl ether (C(10)E(4))/n-octane/water (SOW) at variable temperature (T) was revisited by careful analysis of the three bidimensional cuts, namely, the gamma (at constant water-oil ratio), chi (at constant surfactant concentration), and Delta (at constant temperature) plots. A straightforward methodology is reported to determine the frontiers of the triphasic (Winsor III) domain on any cut of the SOW-T phase prism. It comes from the systematic analysis of another cut, here gamma at different water-oil ratios and chi at different surfactant concentrations from the knowledge of Delta cuts at different temperatures. The method has been validated through comparison with experimental results. It enables one to show, for the first time, the evolution of a SOW system three-phase body contours with (i) water-oil ratio, (ii) surfactant concentration, and (iii) temperature. It exhibits a strong impact of the surfactant affinity for the pure oil and water phases on the shape of the phase diagrams. The systematic study of the effect of the surfactant concentration on the aspect of the chi plot sheds light on an unusual shape found at low surfactant concentration.

The hydrotropic properties of short-chain monoalkyl ethers of isosorbide have been studied with emphasis on the difference between the two regioisomers (2-O- and 5-O-monoalkylisosorbide, C(i)Iso-exo and C(i)Iso-endo, respectively). On the one hand, the partitioning in a water/cyclohexane system has been measured, and on the other hand, the "optimal formulation" of C(i)Iso/oil/water systems has been determined by changing the oil polarity. In both cases, whatever the alkyl chain length (four or five carbons), C(i)Iso-exo appears to be less hydrophilic due to an intramolecular hydrogen bond that makes the free hydroxyl group less available. With one substituted position, the hydrophilicity contribution of isosorbide is slightly higher than the one of two ethylene glycols when the exo hydroxyl remains free, whereas it is closer to one ethylene glycol when this hydroxyl is substituted. With regard to the sensitivity to temperature, the hydrophilicity loss on heating seems to be similar for both isomers and close to what is obtained for poly(ethylene glycol) derivatives if we consider the evolution of the partition coefficients. In C(i)Iso-endo/oil/water systems, however, the variation of the optimal oil with temperature tends to show that the isosorbide derivatives are approximately 2 times less sensitive than their poly(ethylene glycol) counterparts to temperature changes.

In the context of environmental concerns for the production of surface active species, the introduction of a carbonyl function into the skeleton of ethyleneglycol-derived solvo-surfactants is a way to access cleavable compounds with presumed enhanced biodegradability. Ethylene glycol monobutyrate (C(3)COE(1)) was synthesized and compared to its ether counterparts, ethylene glycol monopropyl (C(3)E(1)) and monobutyl ethers (C(4)E(1)), to assess the effect of the insertion of a carbonyl function in the skeleton of short-chain ethoxylated amphiphilic compounds. In aqueous solutions, the ester has intermediate behavior between that of the two ethers with regard to surface tension, solubilization of Me-naphtalene in water, and self-diffusion by PGSE NMR. In ternary systems, C(3)COE(1) and C(3)E(1) have the same optimal oil (EACN = 2.8), which is much more polar than that of C(4)E(1) (EACN = 8.5). With regard to the ability to form structured systems, the behavior in water does not differ significantly for the three compounds, and the transition between nonassociating solvents and amphiphilic solvents, sometimes called solvo-surfactants, is gradual. In ternary systems, however, only C(4)E(1) and C(3)COE(1) form a third phase near the optimal formulation, which tends to show that C(3)COE(1) possesses the minimum amphiphilicity to get a structuration. Self-diffusion NMR studies of the one-phase domains do not, however, allow us to distinguish between different degrees of organization in the three systems.

The binary phase diagram of tetraethylene glycol decanoyl ester (C9COE4) was investigated in the micellar region by PGSE-NMR (pulse field gradient spin echo nuclear magnetic resonance) and in the lamellar liquid crystalline state by 2H NMR. Its behavior was compared to the ether counterpart, tetraethylene glycol decanoyl ether (C10E4), whose phase diagram is well-described. The determination of the self-diffusion coefficient as a function of concentration permitted not only a determination of the critical micellar concentration (cmc) values but also the determination of the size and shape of micelles formed by both compounds. The evolution of the self-diffusion coefficients in the vicinity of the cloud point was also studied, showing no micellar growth with increasing temperature. 2H NMR analyses at the border of and within the liquid crystalline region gave an insight into the lamellar phase structure. We investigated in detail the lamellar phase of both compounds by comparing the values of quadrupolar splittings (Deltanu) measured under the same conditions. Lower Deltanu values were found for the ester compared to the ether: since the ester probably binds more water than the ether, these lower Deltanu values would indicate a lower order parameter in the liquid crystal phase. NMR techniques, either PGSE-NMR or 2H NMR, were confirmed as useful tools to characterize aqueous phase behavior of surfactants, providing supplementary information to the classical techniques such as visual observations, polarized optical microscopy (POM), and surface tension measurements. They also provide a unique insight into the molecular organization in the different phases formed.