Search

Organometallic lead halide perovskites are excellent light harvesters for high-efficiency photovoltaic devices. However, as the key component in these devices, a perovskite thin film with good morphology and minimal trap states is still difficult to obtain. Herein we show that by incorporating a low boiling point alkyl halide such as iodomethane (CH3I) into the precursor solution, a perovskite (CH3NH3PbI3-xClx) film with improved grain size and orientation can be easily achieved. More importantly, these films exhibit a significantly reduced amount of trap states. Record photoluminescence lifetimes of more than 4 μs are achieved; these lifetimes are significantly longer than that of pristine CH3NH3PbI3-xClx films. Planar heterojunction solar cells incorporating these CH3I-mediated perovskites have demonstrated a dramatically increased power conversion efficiency compared to the ones using pristine CH3NH3PbI3-xClx. Photoluminescence, transient absorption, and microwave detected photoconductivity measurements all provide consistent evidence that CH3I addition increases the number of excitons generated and their diffusion length, both of which assist efficient carrier transport in the photovoltaic device. The simple incorporation of alkyl halide to enhance perovskite surface passivation introduces an important direction for future progress on high efficiency perovskite optoelectronic devices.

Organic electronics have gained widespread attention due to their flexibility, lightness, and low-cost potential. It is attractive due to the possibility of large-scale roll-to-roll processing. However, organic electronics require additional development before they can be made commercially available and fully integrated into everyday life. To achieve feasibility for commercial use, these devices must be biocompatible and flexible while maintaining high performance. In this study, biocompatible silk fibroin (SF) was integrated with a mesh of silver nanowires (AgNWs) to build up flexible organic solar cells with maximum power conversion efficiency of up to 6.62%. The AgNW/SF substrate exhibits a conductivity of ∼11.0 Ω/sq and transmittance of ∼80% in the visible light range. These substrates retained their conductivity, even after being bent and unbent 200 times; this surprising ability was attributed to its embedded structure and the properties of the specific SF materials used. To contrast, indium tin oxide on synthetic plastic substrate lost its conductivity after the much less rigid bending. These lightweight and silk-based organic solar cells pave the way for future biocompatible interfaces between wearable electronics and human skin.