Search

This article investigated the effect of geometric structural parameters on flow patterns and pressure drops and gas–liquid mixing effects of gas–liquid mixing devices. The computational fluid dynamics software FLUENT was used to calculate the airflow inside the mixer of a compressed air–foam gas–liquid mixing device with different cone angles, foam flow rates, air inlet inclination angles, and pipeline diameters. The results obtained are the pressure distribution, the liquid volume fraction, and the liquid phase streamlines in the mixing device. The numerical simulation results showed that for a gas–liquid mixing device, the optimal inlet inclination angle was 60°–70°, and the mixing effect of an equal diameter mixer was better than that of a variable diameter mixer, but it would reduce the mixing efficiency of the air and foam. The optimal pipeline diameter of the conveying pipeline was 190 mm, and the optimal cone angle of the mixing device was 55°. [ABSTRACT FROM AUTHOR]

Ultra-high purity elemental sources have long been considered a prerequisite for obtaining low impurity concentrations in compound semiconductors in the world of molecular beam epitaxy (MBE) since its inception in 1968. However, we demonstrate that a "dirty" solid precursor, ruthenium(III) acetylacetonate [also known as Ru(acac)3], can yield single-phase, epitaxial, and superconducting Sr2RuO4 films with the same ease and control as III–V MBE. A superconducting transition was observed at ∼0.9 K, suggesting a low defect density and a high degree of crystallinity in these films. In contrast to the conventional MBE, which employs the ultra-pure Ru metal evaporated at ∼2000 °C as a Ru source, along with reactive ozone to obtain Ru → Ru4+ oxidation, the use of the Ru(acac)3 precursor significantly simplifies the MBE process by lowering the temperature for Ru sublimation (less than 200 °C) and by eliminating the need for ozone. Combining these results with the recent developments in hybrid MBE, we argue that leveraging the precursor chemistry will be necessary to realize next-generation breakthroughs in the synthesis of atomically precise quantum materials. [ABSTRACT FROM AUTHOR]

Early detection and monitoring of heavy load induced plastic deformation in the structure is crucial for timely intervention before cracking occurs and the material completely fails. Ultrasound can be used for detecting plastic deformation provided the mechanical modulus, which can be probed via changes in velocities. This work presents a measurement scheme that makes use of optically detected, laser-induced surface acoustic waves (SAWs) for remote, real-time, online monitoring of the wave velocity during the elastic–plastic transition occurring in an aluminum plate undergoing a uniaxial tensile test and a dynamic fatigue test. Monochromatic SAWs were photoacoustically generated in a wavelength-controlled way through a transient thermal grating based laser ultrasonics excitation scheme. The SAWs were detected by a home-built photorefractive interferometer. The results reveal both regions of acceleration and slowing down, indicating that the material first stiffens and then starts to form microcracks that make it behave effectively softer for propagating SAWs. [ABSTRACT FROM AUTHOR]