Search

This paper presents a simple but complete design method to obtain arbitrary vortex design tube-axial fans starting from fixed size and rotational speed. The method couples the preliminary design method previously suggested by the authors with an original revised version of well-known blade design methods taken from the literature. The aim of this work is to verify the effectiveness of the method in obtaining high-efficiency industrial fans. To this end, the method has been applied to a 315 mm rotor-only tube-axial fan having the same size and rotational speed, and a slightly higher flow rate coefficient, as another prototype previously designed by the authors, which was demonstrated experimentally to noticeably increase the pressure coefficient of an actual 560 mm industrial fan. In contrast, no constraints are imposed on the hub-to-tip ratio and pressure coefficient. The new design features a hub-to-tip ratio equal to 0.28 and radially stacked blades with aerodynamic load distribution corresponding to a roughly constant swirl at rotor exit. The ISO-5801 experimental tests showed fan efficiency equal to 0.68, which is 6% higher than that of the previous prototype. The pressure coefficient is lower, but still 12% higher than that of the benchmark 560 mm industrial fan. [ABSTRACT FROM AUTHOR]

Proper cooling of the hot components and an optimal temperature distribution at the turbine inlet are fundamental targets for gas turbine combustors. In particular; the temperature distribution at the combustor discharge is a critical issue for the durability of the turbine blades and the high performance of the engine. At present, CFD is a widely used tool to simulate the reacting flow inside gas turbine combustors. This paper presents a numerical analysis of a single can type combustor designed to be fed both with hydrogen and natural gas. The combustor also features a steam injection system to restrain the NOx pollutants. The simulations were carried out to quantify the effect of fuel type and steam injection on the temperature field. The CFD model employs a computationally low cost approach, thus the physical domain is meshed with a coarse grid. A full-scale test campaign was performed on the combustor: temperatures at the liner wall and the combustor outlet were acquired at different operating conditions. These experimental data, which are discussed, were used to evaluate the capability of the present CFD model to predict temperature values for combustor operation with different fuels and steam to fuel ratios. [ABSTRACT FROM AUTHOR]