Search

The effects of resonant magnetic perturbations on the turbulent transport of fast ions in tokamak devices are investigated using a theoretical transport model of test-particle type. The direct numerical simulation method is used to compute, via the transport model, the diffusion coefficients. The numerical results are in good agreement with other, analytically derived, estimations. It is found that finite Larmor radius effects algebraically decrease the transport, while the amplitude of magnetic perturbations has an opposite effect. In the presence of stochastic dynamics, the asymmetric toroidal magnetic field induces a small, radial, outward pinch. A synergistic mechanism of non-linear coupling between the effects of turbulence and those of magnetic perturbations enhances the radial diffusion. General scaling laws are proposed for the transport coefficients.

According to a recent paper [Hu et al., Phys. Plasmas 26, 120702 (2019)], mode penetration at the top of the pedestal is a necessary and sufficient condition for the suppression of edge localized modes (ELMs) by a resonant magnetic perturbation (RMPs) in an H-mode tokamak discharge. This paper employs asymptotic matching theory to model a particular DIII-D discharge in which ELMs were suppressed by an externally generated, static, n = 2, RMP whose amplitude was modulated at a frequency of 1 Hz. It is demonstrated that the response of the plasma to the applied RMP, in the immediate vicinities of the rational (i.e., resonant) surfaces, is governed by nonlinear, rather than by linear, physics. This is the case because the magnetic island widths associated with driven reconnection exceed the linear layer widths, even in cases where driven reconnection is strongly suppressed by plasma rotation. The natural frequency at a given rational surface (i.e., the helical frequency at which the locally resonant component of the RMP would need to propagate in order to maximize driven reconnection) is found to be offset from the local E × B frame in the ion diamagnetic direction. The size of the offset is mostly determined by neoclassical poloidal rotation. Finally, the predictions of a fully nonlinear plasma response model are found to be broadly consistent with the DIII-D experimental data.

Edge-localized mode (ELM) suppression by resonant magnetic perturbations (RMPs) generally occurs over very narrow ranges of the plasma current (or magnetic safety factor q_{95}) in the DIII-D tokamak. However, wide q_{95} ranges of ELM suppression are needed for the safety and operational flexibility of ITER and future reactors. In DIII-D ITER similar shape plasmas with n=3 RMPs, the range of q_{95} for ELM suppression is found to increase with decreasing electron density. Nonlinear two-fluid MHD simulations reproduce the observed q_{95} windows of ELM suppression and the dependence on plasma density, based on the conditions for resonant field penetration at the top of the pedestal. When the RMP amplitude is close to the threshold for resonant field penetration, only narrow isolated magnetic islands form near the top of the pedestal, leading to narrow q_{95} windows of ELM suppression. However, as the threshold for field penetration decreases with decreasing density, resonant field penetration can take place over a wider range of q_{95}. For sufficiently low density (penetration threshold) multiple magnetic islands form near the top of the pedestal giving rise to continuous q_{95} windows of ELM suppression. The model predicts that wide q_{95} windows of ELM suppression can be achieved at substantially higher pedestal pressure in DIII-D by shifting to higher toroidal mode number (n=4) RMPs.

Edge localised modes (ELMs) are a concern for future devices, such as ITER, due to the large transient heat loads they generate on the divertor surfaces which could limit the operational time of the device. This paper discusses the application of resonant magnetic perturbations (RMPs) as a mechanism for ELM control on MAST. Experiments have been performed using an n=3 toroidal mode number perturbation and measurements of the strike point splitting performed. The measurements have been made using both infrared and visible imaging to measure the heat and particle flux to the divertor. The measured profiles have shown clear splitting in L-mode which compares well with the predication of the splitting location from modelling including the effect of screening. The splitting of the strike point has also been studied as a function of time during the ELM. The splitting varies during the ELM, being the strongest at the time of the peak heat flux and becoming more filamentary at the end of the ELM (200 microseconds after the peak midplane D(alpha) emission). Variation in the splitting profiles has also been seen, with some ELMs showing clear splitting and others no splitting. A possible explanation of this effect is proposed, and supported by modelling, which concerns the relative phase between the RMP field and the ELM filament location., Comment: 26 pages, 26 figures. Presented at the Stochasticity in Fusion Plasmas Workshop, Aachen, March 2013

Edge localised modes (ELMs) are a concern for future devices as they can limit the operational lifetime of the divertor. The mitigation of ELMs can be performed by the application of resonant magnetic perturbations (RMPs) which act to degrade the pressure gradient in the edge of the plasma. Investigations of the effect of RMPs on MAST have been performed in a range of plasmas using perturbations with toroidal mode numbers of n=3, 4 and 6. It has been seen that the RMPs increase the ELM frequency, which gives rise to a corresponding decrease in the ELM energy. The reduced ELM energy decreases the peak heat flux to the divertor, with a three fold reduction in the ELM energy, generating a 1.5 fold reduction in the peak heat flux. Measurements of the divertor heat flux profile show evidence of strike point splitting consistent with modelling using the vacuum code ERGOS., Comment: 13 pages, 7 figures

The peak pressure gradient in the pedestal (dPe/d{\psi}) on MAST varies little between edge localized modes (ELMs), although it varies between discharges due factors such as gas fuelling and plasma current. The pressure pedestal width in flux space on the high-field side (HFS), both during the inter-ELM period and amongst different plasma discharges is consistent with a scaling of . In flux space very similar dPe/d{\psi} and {\Delta}pe are observed on the HFS and low-field side (LFS) in single null configuration. This symmetry is broken by the application of resonant magnetic perturbations (RMPs). During ELM mitigation by application of RMPs changes in the edge transport barrier position and width are observed. These changes are dependent on the intensity of the RMP and on the toroidal location with respect to the RMP phase. An outward displacement of up to 30 mm and increase in the edge pedestal width of up to 50% with respect to the coils case off are observed. Increased particle transport causes a decrease in ne,ped, and hence Pe,ped, as is observed on other devices. The combination of an increase in {\Delta}pe on the LFS and decrease in Pe,ped results in significantly reduced LFS dPe/d{\psi} when these perturbations are applied to the plasma edge. A decrease in dPe/d{\psi} on the HFS is also observed due to RMP; however, this decrease is caused solely by the Pe,ped decrease whilst no expansion of {\Delta}pe on the HFS is observed., Comment: 26 pages, 11 figures. This is an author-created, un-copyedited version of an article accepted for publication in Plasma Physics and Controlled Fusion. IOP Publishing Ltd is not responsible for any errors or omissions in this version of the manuscript or any version derived from it

The application of resonant magnetic perturbations (RMPs) with a toroidal mode number of n=3 to connected double null plasmas in the MAST tokamak produces up to a factor of 9 increase in Edge Localized Mode (ELM) frequency and reduction in plasma energy loss associated with type-I ELMs. A threshold current for ELM mitigation is observed above which the ELM frequency increases approximately linearly with current in the coils. The effect of the RMPs is found to be scenario dependent. In one scenario the mitigation is only due to a large density pump out event and if the density is recovered by gas puffing a return to type I ELMs is observed. In another scenario sustained ELM mitigation can be achieved irrespective of the amount of fuelling. Despite a large scan of parameters complete ELM suppression has not been achieved. The results have been compared to modelling performed using either the vacuum approximation or including the plasma response. The requirement for a resonant condition, that is an optimum alignment of the perturbation with the plasma, has been confirmed by performing a scan in the pitch angle of the applied field., Comment: 39 pages,19 figures

It is well known that externally generated resonant magnetic perturbations (RMPs) can form islands in the plasma edge. In turn, large overlapping islands generate stochastic fields, which are believed to play a role in the avoidance and suppression of edge localized modes (ELMs) at DIII-D. However, large coalescing islands can also generate, in the middle of these stochastic regions, KAM surfaces effectively acting as ‘barriers’ against field-line dispersion and, indirectly, particle diffusion. It was predicted in Ali and Punjabi (2007 Plasma Phys. Control. Fusion 49 1565–82) that such magnetic barriers can form in piecewise analytic DIII-D plasma equilibria. In this work, the formation of magnetic barriers at DIII-D is corroborated by field-line tracing calculations using experimentally constrained EFIT (Lao et al 1985 Nucl. Fusion 25 1611) DIII-D equilibria perturbed to include the vacuum field from the internal coils utilized in the experiments. According to these calculations, the occurrence and location of magnetic barriers depend on the edge safety factor q 95. It was thus suggested that magnetic barriers might contribute to narrowing the edge stochastic layer and play an indirect role in the RMPs failing to control ELMs for certain values of q 95. The analysis of DIII-D discharges where q 95 was varied, however, does not show anti-correlation between barrier formation and ELM suppression.

This work addresses the question of the relation between strike-point splitting and magnetic stochasticity at the edge of a poloidally diverted tokamak in the presence of externally imposed magnetic perturbations. More specifically, ad-hoc helical current sheets are introduced in order to mimic a hypothetical screening of the external resonant magnetic perturbations by the plasma. These current sheets, which suppress magnetic islands, are found to reduce the amount of splitting expected at the target, which suggests that screening effects should be observable experimentally. Multiple screening current sheets reinforce each other, i.e. less current relative to the case of only one current sheet is required to screen the perturbation., Comment: Accepted in the Proceedings of the 19th International Conference on Plasma Surface Interactions, to be published in Journal of Nuclear Materials. Version 2: minor formatting and text improvements, more results mentioned in the conclusion and abstract