Search

This paper aims to solve two problems of the sandwich panel with aluminum honeycomb: material parameters solution and shape control. The accurate material parameters of the sandwich panels are the basis of shape control. Therefore, a mixed numerical-experimental method is proposed to inversely solve equivalent material parameters of the sandwich panel using genetic algorithm (GA) in the first place. Then a high efficiency FE model based on equivalent material parameters is established to study shape control of the sandwich panels. For shape control, the key issue aims to search optimum position and adjustment volume of control points where actuators are installed. Toward the end, the FE simulation method is deployed to optimize actuator position and adjustment volume one by one. Finally, an active control platform based on multi-point adjustment is developed to verify the practicability of the approach proposed in this paper. Through the experiment of shape control, the root mean square (RMS) of surface deviation of sandwich panel is decreased from 62.7μm to 15.5μm. The results show that the shape control can significantly improve the surface accuracy of the sandwich panels, and the validity of equivalent material parameters is also proved from the side.

The current work analyzes the transmission behavior of plane harmonic waves in an isotropic medium. The observation is made for homogeneous type solid in the context of generalized dual phase lag model of thermoelasticity. Concept micro-temperature, where the microelements have different temperatures has also been considered. The basic focus of thework is to predict the influence of initially applied magnetic field on plane waves through the elastic solid. We have made an attempt to find exact solution of the problem using an analytical technique of a normal mode analysis method. The theoretical results are obtained for a generalized solid in order to test the numerical calculation of a magnesium crystal. It is found that the magnetic field reduces the strength of the attenuation factor.

In this paper, uniaxial material properties, creep resistance and impact energy of the austenitic heat-resistant steel (1.4841) are experimentally determined and analysed. Engineering stress–strain diagrams and uniaxial short-time creep curves are examined with computer-controlled testing machine. Impact energy has been determined and fracture toughness assessed. Investigated data are shown in the form of curves related to ultimate tensile strength, yield strength, modulus of elasticity and creep resistance. All of these experimentally obtained results are analysed and may be used in the design process of the structure where considered material is intended to be applied. Based on these results, considered material may be classified as material of high tensile strength (688 MPa/293 K; 326 MPa/923 K) and high yield strength (498 MPa/293 K; 283 MPa/923 K) as well as satisfactory creep resistance (temperature/stress →$ \to $strain (%) at 1,200 min: 823 K/167 MPa →$ \to $0.25 %; 923 K/85 MPa →$ \to $0.2 %).

The paper presents and analyzes the experimental results of the effect of elevated temperatures on the engineering properties of steel 42CrMo4. Experimental data relating to the mechanical properties of the material, the creep resistance as well as Charpy impact energy. Temperature dependence of the mentioned properties is also shown. Some of creep curves were simulated using rheological models and an analytical equation. Finally, an assessment of fracture toughness was made that was based on experimentally determined Charpy impact energy. Based on the obtained results it is visible that the tensile strength (617 MPa) and yield strength (415 MPa) have the highest value at the room temperature while at the temperature of 700 °C (973 K) these values significantly decrease. This steel can be considered resistant to creep at 400 °C (673 K), but at higher temperatures this steel can be subjected to low levels of stress in a shorter time.