Search

In the present paper our aim is to investigate the effect of the spray time of the aluminium coated layers on the microstructure and corrosion behaviour. For this purpose we use the self-generated atmospheric plasma spray system for coating of aluminium on the carbon steel substrate. The different thicknesses of coating are created. To evaluate this effect we use the several analyses such as X-ray diffraction, scanning electron microscope, Micro hardness analysis by Vickers method, Adhesion strength analysis and electrochemical polarization test. The results are very interesting and show that due to low porosity, thicker layers are more homogeneous. The nanoparticles are observed in the thicker layers. The micro hardness tests show that the thicker layers have the better micro hardness value. Next, the adhesion strength tests illustrate that the highest adhesion strength are for longer spray times. On the other hand, the corrosion resistance behaviour of the coating is investigated by electrochemical polarization test. It is shown that the corrosion resistance increases by increasing the thickness due to low percentage of porosity. Keywords: Plasma spray, Thickness, Aluminium, Micro hardness, Corrosion resistance

The circuit parameters are investigated in a Mather-type plasma focus device. The experiments are performed in the SABALAN-I plasma focus facility (2 kJ, 20 kV, 10 µF). A 12-turn Rogowski coil is built and used to measure the time derivative of discharge current (dI/dt). The high pressure test has been performed in this work, as alternative technique to short circuit test to determine the machine circuit parameters and calibration factor of the Rogowski coil. The operating parameters are calculated by two methods and the results show that the relative error of determined parameters by method I, are very low in comparison to method II. Thus the method I produces more accurate results than method II. The high pressure test is operated with this assumption that no plasma motion and the circuit parameters may be estimated using R-L-C theory given that C0 is known. However, for a plasma focus, even at highest permissible pressure it is found that there is significant motion, so that estimated circuit parameters not accurate. So the Lee Model code is used in short circuit mode to generate the computed current trace for fitting to the current waveform was integrated from current derivative signal taken with Rogowski coil. Hence, the dynamics of plasma is accounted for into the estimation and the static bank parameters are determined accurately. Keywords: Plasma focus, Short circuit, High pressure, Rogowski coil, Circuit parameters, Lee Model

This article has been retracted: please see Elsevier Policy on Article Withdrawal (https://www.elsevier.com/about/our-business/policies/article-withdrawal).This article has been retracted at the request of the Editors-in-Chief.After a thorough investigation, the Editors have concluded that the acceptance of this article was based upon the positive advice of at least one illegitimate reviewer report. The report was submitted from an email account which was provided to the journal as a suggested reviewer during the submission of the article. Although purportedly a real reviewer account, the Editors have concluded that this was not of an appropriate, independent reviewer.This manipulation of the peer-review process represents a clear violation of the fundamentals of peer review, our publishing policies, and publishing ethics standards. Apologies are offered to the reviewers whose identities were assumed and to the readers of the journal that this deception was not detected during the submission process.Further, the corresponding author was not able to explain the reason for adding the author M. Ghoranneviss to the revised article.

This article has been retracted: please see Elsevier Policy on Article Withdrawal (https://www.elsevier.com/about/our-business/policies/article-withdrawal).This article has been retracted at the request of the Editors-in-Chief.After a thorough investigation, the Editors have concluded that the acceptance of this article was based upon the positive advice of at least one illegitimate reviewer report. The report was submitted from an email account which was provided to the journal as a suggested reviewer during the submission of the article. Although purportedly a real reviewer account, the Editors have concluded that this was not of an appropriate, independent reviewer.This manipulation of the peer-review process represents a clear violation of the fundamentals of peer review, our publishing policies, and publishing ethics standards. Apologies are offered to the reviewers whose identities were assumed and to the readers of the journal that this deception was not detected during the submission process.

This article has been retracted: please see Elsevier Policy on Article Withdrawal (http://www.elsevier.com/locate/withdrawalpolicy).This article has been retracted at the request of the Editors-in-Chief.The article duplicates significant parts of a paper that had already appeared in the Journal of Alloys and Compounds 648 (2015) 1104–1108 http://dx.doi.org/10.1016/j.jallcom.2015.07.063. One of the conditions of submission of a paper for publication is that authors declare explicitly that the paper is not under consideration for publication elsewhere. Re-use of any data should be appropriately cited. As such this article represents an abuse of the scientific publishing system. The scientific community takes a very strong view on this matter and apologies are offered to readers of the journal that this was not detected during the submission process.

In this study, the three structures of the symmetric paper supercapacitors based on the carbon nanotubes (CNTs), graphite nanoparticles (GNPs) and graphene electrodes have been fabricated. In the supercapacitors was used of polyvinyl alcohol (PVA)/phosphoric acid (H3PO4) as a gel electrolyte and the BaTiO3 film as a separator film. The carbon nanomaterials, gel electrolyte surface, and electrode films were characterized by scanning electron microscopy (SEM) and transmission electron microscope (TEM). The specific capacitance of the symmetric paper supercapacitors using charge-discharge technique and C-V curves at the voltage scan rates 20 mV/s and 150 mV/s have been investigated. The symmetric paper supercapacitor based on the CNTs electrode showed higher specific capacitance 411 F g−1, compared to GNPs and graphene supercapacitors. Also by electrochemical impedance spectroscopy, the Nyquist curves of the symmetric paper supercapacitors have been plotted. For the symmetric paper supercapacitors based on the GNPs, graphene and CNTs electrodes the equivalent series resistance (ESR) resistance was 210 Ω, 96 Ω and 101 Ω respectively. The flexible symmetric paper supercapacitor based on BaTiO3/PVA/CNTs structure denotes a new type of the flexible supercapacitor that can be applied to the soft electronic.

This article has been retracted: please see Elsevier Policy on Article Withdrawal (https://www.elsevier.com/about/our-business/policies/article-withdrawal).This article has been retracted at the request of the Editors-in-Chief.After a thorough investigation, the Editors have concluded that the acceptance of this article was based upon the positive advice of at least two illegitimate reviewer reports. The reports were submitted from email accounts which were provided to the journal as suggested reviewers during the submission of the article. Although purportedly real reviewer accounts, the Editors have concluded that these were not of appropriate, independent reviewers.This manipulation of the peer-review process represents a clear violation of the fundamentals of peer review, our publishing policies, and publishing ethics standards. Apologies are offered to the reviewers whose identities were assumed and to the readers of the journal that this deception was not detected during the submission process.No reason has been provided for the addition of the author name A. Salar Elahi to the authorship of the revised article.

This article has been retracted: please see Elsevier Policy on Article Withdrawal (https://www.elsevier.com/about/our-business/policies/article-withdrawal).This article has been retracted at the request of the Editors-in-Chief.After a thorough investigation, the Editors have concluded that the acceptance of this article was based upon the positive advice of at least one illegitimate reviewer report. The report was submitted from an email account which was provided to the journal as a suggested reviewer during the submission of the article. Although purportedly a real reviewer account, the Editors have concluded that this was not of an appropriate, independent reviewer.This manipulation of the peer-review process represents a clear violation of the fundamentals of peer review, our publishing policies, and publishing ethics standards. Apologies are offered to the reviewers whose identities were assumed and to the readers of the journal that this deception was not detected during the submission process.