Search

Herein, the structural defects of metal-free polymeric carbon nitrides were controlled by making use of different precursors in their syntheses, i.e. melamine (CN-M) and thiourea (CN-T), as well as a 1:1 mixture of them (CN-1M:1 T). By controlling the structural defects, the electronic, morphological and chemical properties were modified. Additionally, the activities of synthesized PCNs were evaluated for amoxicillin photodegradation under visible light irradiation (16 mW cm -2 ). The results of photocatalytic tests showed that CN-T material has better efficiency (100 % removal within 48 h), which is directly related to the greater number of defects present in its structure with consequent improvement of electron-hole pairs separation efficiency. The CN-T material showed excellent stability with only 13 % decrease in its photocatalytic activity after the third cycle. A mechanism for amoxicillin degradation by CN-T was proposed based on the ESI-MS and the in situ EPR allied with spin trapping method investigations., (Copyright © 2020 Elsevier B.V. All rights reserved.)

In this work, the potential to use an iron mining waste (IW), rich in α-Fe 2 O 3 and α-FeOOH, for the development of composites based on graphitic carbon nitride (CN) is demonstrated. These materials were synthesized through a simple thermal treatment at 550 °C of a mixture containing melamine and different IW mass percentages, giving rise to the catalysts xIWCN (where x is related to the initial mass percentage of IW). The iron phases of the precursor were partially transformed throughout the formation of the composites, in such a way that a mixture of α-Fe 2 O 3 and γ-Fe 2 O 3 was observed in their final composition. Furthermore, structural defects were produced in the carbonaceous matrix of the materials, causing the fragmentation of g-C 3 N 4 and an increase of surface area. The catalytic activities of these composites were evaluated in reactions of peroxymonosulfate activation for the degradation of paracetamol. Among these materials, the composite 20IWCN showed the best catalytic activity, being able to degrade almost 90 % of the total paracetamol in only 20 min of reaction. This catalyst also demonstrated high chemical stability, being successfully utilized in five consecutive reaction cycles, with negligible iron leaching., (Copyright © 2020 Elsevier B.V. All rights reserved.)

This research describes a solid-phase microextraction device using carbon nanomaterials supported on steel threads. The device was used to pre-concentrate and extract 24 pesticides in water. The carbon nanomaterials were obtained by a chemical vapor deposition (CVD) process, using methane and acetonitrile as carbon source. The different pesticides were separated, detected, and quantified using gas chromatography coupled to mass spectrometry (GC-MS). The system, optimized and validated in the laboratory, presented good results. Linearity was between 0.0007 and 50.00 μg L -1 , with determination coefficients greater than 0.9. The detection and quantification limits were in the range of 0.0002-1.1309 μg L -1 and 0.0007-3.7320 μg L -1 , respectively. The studied pesticides presented recovery values in the range of 70 ± 8 to 123 ± 18%. Carbon nanomaterials exhibited high thermal and mechanical resistance, as the same fiber could be used for approximately 300 extractions. The device was applied to analyze environmental water samples collected from the São Francisco river basin in Brazil and in the Chinampas in Mexico City., (Copyright © 2020 Elsevier B.V. All rights reserved.)