Search

Objectives: Recently, a device for detecting occlusal caries lesions based on laser fluorescence measurements (DIAGNOdent) has been introduced. The reliability (reproducibility) and validity of this laser-fluorescence device were investigated., Methods: In the in vitro part of the study, 49 permanent molars were measured by two observers using two DIAGNOdent devices. In addition, visual inspection was performed. The teeth were sectioned to measure the actual depth and area of the caries lesions. In the in vivo part of the study, 45 sites at the occlusal surfaces of permanent molar teeth in 13 patients were measured by two observers using two DIAGNOdent devices, manufactured in two successive years., Results: The reliability of both DIAGNOdent devices expressed in the intraclass correlation coefficient (ICC=0.90 for observer 1, and 0.88 for observer 2) was high, and so was the interobserver reliability (ICC=0.85 for the 1998-device, ICC=0.90 for the 1999-device). The correlation between DIAGNOdent measurements and the actual depth of the caries lesions was lower than that of visual inspection by one observer, yet higher than that of a second observer. The specificities of visual inspection (0.94 and 0.88) were higher than those of the DIAGNOdent devices, whereas the sensitivities of the DIAGNOdent devices (0.93-1.00) exceeded those of visual inspection The validity of the DIAGNOdent, expressed as the area under the receiver operating characteristic curve, was not statistically significantly different from that of visual inspection (P>0.05). The DIAGNOdent measurements showed a higher association with the enamel part of the caries lesion than with the dentinal part., Conclusions: The DIAGNOdent is suitable for monitoring small caries lesions. Because of the high reproducibility of DIAGNOdent devices produced in successive years, a DIAGNOdent device may be replaced by a new one. Due to the higher specificity, visual inspection should be preferred to diagnose occlusal caries lesions in populations with a low caries prevalence.

Introduction: Problems that may arise in resin composite Class 2 restorations include microleakage and postoperative sensitivity. However, limited in-vivo research is conducted to evaluate these processes., Aim: The aim of this study was to assess postoperative sensitivity, microleakage and the pooling of adhesives in relation to Class 2 box-type composite restorations placed in vivo using various adhesive systems and application techniques., Materials and Methods: One hundred and forty-four Class 2 box restorations were placed in the mesial and distal surfaces of 72 premolar teeth in-vivo using one of three combinations of adhesive systems and three filling techniques. After 6 weeks of clinical service postoperative sensitivity was recorded. The teeth were then extracted, immersed in a dye solution and sectioned. Microleakage and pooling of the adhesive was recorded. Statistical analysis involved logistic regression and chi2 tests to identify differences between groups at p < 0.05., Results: Of the 144 restorations, 65 showed minimal cervical leakage in enamel, 5 suffered leakage into dentin and 74 were free of microleakage. No statistically significant differences were found in cervical microleakage between the adhesive systems or between filling procedures. Occlusal microleakage in the enamel was present in 16 of the 160 restorations. Liner Bond 2 restorations leaked significantly more at the occlusal surface (p < 0.05). Pooling of the adhesive was significantly less when PhotoBond was used. No spontaneous postoperative sensitivity was reported. Twenty-eight restorations were sensitive to loading. Postoperative sensitivity was significantly less in patients with Liner Bond 2 restorations., Conclusions: The adhesive systems used in this study showed minimal leakage into dentin in vivo. Using Liner Bond 2, restorations exhibited more occlusal leakage but were significantly less sensitive to loading.

Objectives: Attempts have been made to develop diagnostic methods which enable an early diagnosis of occlusal lesions which are not detectable by visual inspection. The aim of this study was to compare the performance of visual inspection focused on finding signs of fissure decalcification and discoloration, visual inspection upon fibre-optic transillumination (FOTI), and electrical conductance measurements (ECMs) in predicting the onset of occlusal caries in 6- and 11-year-old children., Methods: Fifty children aged 5-7 and 11-15 years, having first or second permanent molar teeth that were not exposed to the oral environment for more than half a year, participated in the study. Following baseline data recording, the diagnostic measurements were repeated six times at 6-month intervals over a period of 2.5 years., Results: Data were collected at predefined sites in the fissures. During the study, 220 of the 652 sites, i.e. 75 of 197 molars in 31 of the 50 children were judged to require a sealant or a sealant restoration. Two examiners jointly decided on the decay status at the sites. Survival plots showed that ECMs were superior to FOTI and fissure discoloration in predicting the onset of occlusal caries, although the differences were small., Conclusion: ECM is a better predictor of occlusal caries than fissure discoloration and FOTI, although the differences among the performance of the three methods in this study were very small. A cost-effective analysis is envisaged to obtain insight into the practical value of ECMs in the prediction of occlusal caries and, thus, into the effectiveness of sealant application.

Objectives: The aim of this study was to assess the effect of a chlorhexidine varnish on occlusal caries incidence when applied 6-monthly into the fissures of erupting and freshly erupted permanent molars., Methods: In a double-blind clinical trial, 332 children aged 5/6 and 11/12 years attending a Child Dental Health Centre were randomly assigned to a control and an experimental group. Criteria for inclusion in the study were that all first permanent molars in 5-6-year-olds and all second permanent molars in 11-12-year-olds either had recently erupted, or were in a stage of eruption, or would erupt within half a year. At baseline, counts of dmfs/DMFS and mutans streptococci in saliva were recorded. During a maximum of 3 years, every 6 months the occlusal surfaces of molars in the experimental group received a 40% chlorhexidine varnish application, whereas those in the control group received a placebo varnish application., Results: Data of 316 children were analysed and ANOVA showed no significant occlusal caries reduction in this sample of Dutch 5/6- and 11/12-year-old children. After stratification into low and high caries risk groups, a statistically significant caries-reducing effect on occlusal caries in permanent molars was found in the group of children with > or = 10(6) mutans streptococci per ml saliva (P < 0.05)., Conclusion: Six-monthly application of chlorhexidine varnish has no caries-reducing effect on occlusal caries in recently erupted permanent molars in a population with low caries prevalence.

Objectives: The purpose of this study was to compare microleakage, gap formation, thickness of the adhesive layer and its radiographic appearance associated with four adhesive restorative procedures for class I cavities., Methods: Adhesive systems with easy handling characteristics were selected for the restoration of class I cavities in extracted third molars. Bitewing radiographs were taken of each tooth and four observers were asked to assess the presence of the adhesive layer. Microleakage, gap width and the thickness of the adhesive layer of each restoration were measured upon sectioning of the teeth., Results: Microleakage in the experimental restorations was minimal. The thickness of the adhesive layers and gap formation varied among different adhesive systems. The adhesive system with self-etching primer produced the highest percentage gap-free restorations. Thick adhesive layers could be detected on the radiograph. ROC analysis of the results validates the diagnosis from the radiograph., Conclusions: The four restorative systems performed well in the prevention of microleakage. The use of a resin modified glass-ionomer cement base did not prevent gap formation compared with the all-etch bonding systems used in this study. The presence of an adhesive layer contributed to the prevention of gap formation, independently of the bonding system used. Thick adhesive layers could be detected on the radiograph.

The detection of small carious lesions at occlusal surfaces is a difficult task, particularly in low caries prevalence populations and individuals. The aim of this study was to evaluate the performance of electrical resistance measurements (ERM) in diagnosing small dentinal lesions at one site per occlusal surface in low caries prevalence populations when used adjunct to visual inspection, and to compare the performance of ERM to that of radiographic examination. The occlusal surfaces of 81 third permanent molar teeth extracted from young adolescents were diagnosed by four examiners, who measured the electrical resistance of enamel on a one measurement per surface basis, and furthermore assessed the occlusal surfaces visually and radiographically. The teeth were sectioned for validation by histological examination. The ERM had the highest sensitivity (0.67), and visual inspection had the highest specificity (0.89). ROC analysis showed no statistically significant differences between the performance of the observers when using visual inspection and ERM (z-score test; P > 0.05). One examiner performed statistically significantly better by measuring the electrical resistance of enamel than by radiographic examination (P < 0.05). The average sensitivity and specificity of the three diagnostic systems were used to express the positive and negative predictive values as a function of caries prevalence. At a caries prevalence of 0.2 the negative predictive values for visual inspection, ERM and radiographic examination were 0.88, 0.91 and 0.89, and the positive predictive values were 0.53, 0.48 and 0.42 respectively.(ABSTRACT TRUNCATED AT 250 WORDS)

The developments that have been taking place in radiographic caries diagnosis, within the context of the changes occurring in both the disease process and the available technology, are reviewed. The decline in caries prevalence seen in many western countries has been accompanied by changes in the pattern and behaviour of lesions. More lesions are now seen on occlusal surfaces, more are concealed (and thus imperceptible to conventional diagnostic techniques), while the average progression rates for approximal lesions have also slowed. Systems employed for caries diagnosis must take account of these changes and the varying needs of users employing different diagnostic thresholds. This paper reviews and discusses developments in: conventional film radiography; xeroradiography; indirect digital imaging (with computer image analysis and subtraction radiography), and direct digital imaging. It is concluded that: for the detection in high caries prevalence groups of both approximal caries (especially small lesions in enamel) and dentinal occlusal lesions in teeth with little or no surface breakdown, radiography is still a significant and reasonably accurate diagnostic method; and that, in spite of the more limited resolution, digital imaging methods seem to perform as well or better than conventional film radiography. Digital systems possess a number of advantages, primarily the possibility for image enhancement and significant dose reduction. It may be predicted that digital imaging techniques will enter the clinical routine in the near future.

The aim of this study was to evaluate the accuracy of approximal caries diagnosis from digitized radiographs and digitally modified radiographic images, compared with conventional radiography. Twenty bitewing radiographs were digitized and from the digitized radiographs mirror-images were produced, resulting in 40 digital images. The caries progress at three approximal surfaces was graded by 12 dentists from conventional radiographs, digital unmodified images and digitally modified images. The image modifications were derived from the cumulative probability of grey values in the original digital image using one of five probability distributions: uniform, exponential, Rayleigh, hyperbolic cube root and hyperbolic logarithmic. Interobserver agreement was substantial. The unmodified digital images produced sensitivities comparable to radiographs but their specificities were lower. When the diagnostic task was to discriminate between 'caries' and 'no caries', the exponential, hyperbolic cube root and hyperbolic logarithmic modifications and radiographs performed equally well. With the decision cut off between 'dentinal caries' and 'no dentinal caries', the sensitivity of the hyperbolic logarithmic type of modification was statistically significantly superior to that of radiographs, but this modification was also associated with a statistically significant reduction of specificity. It is concluded that in particular the hyperbolic logarithmic modification can be an alternative to conventional radiography in incipient approximal caries diagnosis and restorative decision making.

The aesthetic properties of three recently marketed Type II glass polyalkenoate (ionomer) cements were evaluated in a combined laboratory and clinical study. The materials investigated were Fuji Cap II, ChemFil II in capsules and Ketac-fil Aplicap. The aesthetic properties of a glass ionomer restoration were represented by its translucency, the colour match with surrounding enamel and marginal adaptation. The translucency of all shades of the selected glass ionomer cements was measured under laboratory conditions and expressed as the optical density on transillumination. Colour match and marginal adaptation were evaluated in a clinical study. Twenty Class V restorations of each of the three products were placed. After finishing, the marginal adaptation was rated by two clinicians and colour slides of the restoration were made. Five clinicians assessed the colour match of the restorations from colour slides. ChemFil II and Ketac-fil Aplicap shades were considerably more translucent than the Fuji Cap II shades. The colour match of the ChemFil II restorations was significantly better than the Fuji Cap II and Ketac-fil Aplicap restorations. Marginal adaptation was judged excellent for all three products.