Search

As wind energy production increases, reliability and fault-tolerant operation capability of wind energy systems are becoming more important. Modern wind energy production systems use power electronic converters which are unfortunately proved to be one of their most fragile parts and responsible for most of the system downtime. Real-time fault monitoring, fault diagnosis and proper system reconfiguration in these converters are therefore mandatory for fault-tolerant operation of the converter and the whole system. In this paper, a comprehensive fault-tolerant power electronics interface for wind energy systems with doubly-fed induction generators is presented and validated. The same power production capability will be guaranteed. The proposed solution also includes a robust and very fast open-circuit switch fault diagnosis algorithm, which is not sensitive to the operation conditions and is therefore suitable for this application. Simulation, Hardware in the Loop validation and experimental tests are carried out to demonstrate the effectiveness of the proposed approach. [ABSTRACT FROM AUTHOR]

Abstract: This paper deals with reconfigurable back-to-back converter topology and control orders in Wind Energy Conversion Systems (WECS). A typical WECS with Doubly Fed Induction Generator (DFIG) in balanced conditions is concerned. Based on the classical topology, a fault tolerant converter without any redundancy has been studied. The presented fault tolerant topology allows a “five-leg” structure with converters reconfiguration after switch failure detection. Furthermore, the control strategy for classical topology can no longer be applied after fault occurrence. Thus, a “five-leg” control strategy has also been proposed. The validation of the reconfigurable digital controller for the studied WECS with DFIG topology has been performed using a Hardware-in-the-Loop (HIL) reconfigurable platform including a Field Programmable Gate Array (FPGA) chip. HIL simulation results in both healthy and fault conditions have been presented to show simultaneously the viability of the studied converters topology and the reconfigurable control. [Copyright &y& Elsevier]

Abstract: In this paper, application of a five-leg converter in Doubly Fed Induction Generator (DFIG) for Wind Energy Conversion Systems (WECS) is investigated. The five-leg structure and its PWM control are studied and performances are compared with the classical six-leg topology. The main drawback of five-leg converter with respect to the six-leg back-to-back converter is the need to increase the dc-link voltage for the same operation point, i.e. the same powers in case of WECS. So, different methods for the reduction of the required dc-link voltage in the five-leg case are studied. The five-leg converter is used to replace the conventional six-leg one, with the same ability. For the performance evaluation of this structure and its fully digital controller in a more realistic and experimental manner, Hardware in the Loop experiments is carried out. It is shown that efficient control of active and reactive powers and dc-link voltage is performed. Hardware in the Loop results demonstrate the high performance of the proposed fully digital control which is implemented on an Altera FPGA target. [Copyright &y& Elsevier]

Abstract: In this paper, a new reference current computation method suitable for shunt active power filter control under distorted voltage conditions is proposed. The active power filter control is based on the use of self-tuning filters (STF) for the reference current generation and on a modulated hysteresis current controller. This active filter is intended for harmonic compensation of a diode rectifier feeding a RL load under distorted voltage conditions. The study of the active filter control is divided in two parts. The first one deals with the harmonic isolator which generates the harmonic reference currents and is experimentally implemented in a DS1104 card of a DSPACE prototyping system. The second part focuses on the generation of the switching pattern of the inverter by using a modulated hysteresis current controller, implemented in an analogue card. The use of STF instead of classical extraction filters allows extracting directly the voltage and current fundamental components in the α–β axis without phase locked loop (PLL). The performances are good even under distorted voltage conditions. First, the effectiveness of the new proposed method is mathematically studied and verified by computer simulation. Then, experimental results are presented using a DSPACE system associated with the analogue current controller for a real shunt active power filter. [Copyright &y& Elsevier]