Search

Li 2 TiO 3 -based materials are gaining momentum in the field of microwave dielectric ceramics for their moderate dielectric constant and high-quality factor. Herein, a novel oxyfluoride ceramic Li 3 TiO 3 F in the Li 2 TiO 3 –LiF system was successfully prepared by a traditional ceramic method. The synthesis process of Li 3 TiO 3 F ceramic was optimized to obtain improved microstructure and desired microwave dielectric properties (MDP) by means of material characterization techniques, such as thermogravimetric-differential thermal analysis, X-ray diffraction, scanning electron microscopy, Raman spectroscopy, and X-ray photoelectron spectroscopy. A cubic rock salt structure for Li 3 TiO 3 F ceramic was confirmed by Rietveld refinement results. The ceramic sintered at 900 °C showed the most favorable MDP of ε r = 17.28, quality factor (Q × f) = 96,280 GHz, and τ f = −32.7 ppm/°C, obtaining a microstructure superior to that of Li 2 TiO 3. Moreover, the ceramic exhibited favorable chemical compatibility with Ag at 900 °C, indicating a great potential for the use of Li 3 TiO 3 F ceramic as substrates in low temperature cofired ceramic (LTCC) technology. More importantly, the results of this work offered the option of using low temperature firing of ceramic by forming a solid solution between the oxide and the fluoride. [ABSTRACT FROM AUTHOR]

In this paper, a series of Li 2 Zn[Ti 1- x (Co 1/3 Nb 2/3) x ] 3 O 8 (0.0 ≤ x ≤ 0.4) ceramics were prepared via the conventional solid-state method. The influences of (Co 1/3 Nb 2/3)4+ complex ions on the phase composition, spectral characteristics, microstructure, and microwave dielectric properties of Li 2 Zn[Ti 1- x (Co 1/3 Nb 2/3) x ] 3 O 8 ceramics were studied systematically. XRD analysis accompanied with Rietveld refinements showed that pure Li 2 ZnTi 3 O 8 solid solution ceramics with the cubic spinel structure were obtained at x = 0.2–0.4. New Raman-active mode of about 858 cm−1 should be attributed to the vibrations of NbO 6 due to the high bond energy of Nb–O bonds, exerting a certain impact on the structure and performance of Li 2 Zn[Ti 1- x (Co 1/3 Nb 2/3) x ] 3 O 8 ceramics. XPS results indicated that Nb5+ ion donor suppressed the deoxidation process and therefore resulted in the disappearance of Ti3+ ion and oxygen vacancy. The downward trend variation in the ε r value with the increase of (Co 1/3 Nb 2/3)4+ content could be explained by the presence of "compressed" cations and "rattling" cations effect. In addition, the Q × f of the current ceramics was closely dependent on relative density, grain size, FWHM, and oxygen vacancy. Good combined microwave dielectric properties of ε r = 24.5, Q × f = 91,250 GHz, and τ f = −16.8 ppm/°C were achieved for the Li 2 Zn[Ti 0.8 (Co 1/3 Nb 2/3) 0.2 ] 3 O 8 ceramic sintered at 1120 °C. High quality factor gives evidence that the Li 2 Zn[Ti 0.8 (Co 1/3 Nb 2/3) 0.2 ] 3 O 8 ceramic is an appealing candidate for highly selective microwave devices. [ABSTRACT FROM AUTHOR]

In this study, LiF was utilized to decrease sintering temperature, improve microstructure, enhance Q × f , and regulate τ f of Li 2 Ti 0.9 (Zn 1/3 Ta 2/3) 0.1 O 3 (abbreviated as LTZT) ceramics. A complete solid solution together with a phase transition from monoclinic to cubic rock salt structure occurred. The cell volume of LTZT ceramics decreased as the LiF content increased. Relatively dense and uniform microstructures were observed for the ceramics as the LiF content was not less than 2 wt%. The dielectric constant of LTZT ceramics initially increased and then decreased with the increasing LiF content. The FWHM of the Raman band at about 808 cm−1 was closely related to the Q × f value. Notably, the samples with 3 wt% LiF exhibited the highest relative density of 97.4 % and satisfactory microwave dielectric properties of ε r = 23.14 ± 0.16, Q × f = 110,090 ± 1100 GHz, and τ f = +3.25 ± 1.45 ppm/°C when sintered at 950 °C. Good chemical compatibility with silver indicated the ceramic is a promising candidate in LTCC applications. [ABSTRACT FROM AUTHOR]