Search

Abstract: Feasibility of electrokinetic (EK) process combined with Fenton-like reaction was investigated for the removal of phenanthrene in a two-dimensional cell. Sandy soil and bentonite were selected as a model soil and a filling material to inhibit the leak of electrolyte solution within the electrode reservoirs into the soil by hydraulic pressure difference, respectively. The effects of parameters including current, electroosmotic flow (EOF), electrolyte pH, and moisture content on the removal efficiency were examined under constant voltage. At the end of operation for 21 days, the concentration of phenanthrene near the anode was lower than the other positions of soil specimen and increased gradually towards the cathode because hydrogen peroxide solution was supplied from anode to cathode region following the direction of EOF. The concentration of phenanthrene at the bottom soil was lower than that at the top soil. Because capillary attraction in the sandy soil with high porosity was too low to maintain appropriate moisture at the top of the cell, EOF moved through the bottom soil with higher moisture content. Overall removal efficiency at 140 V was 81.6%, which was higher than 68.9% at 100 V because total EOF increased by a factor of 1.5 upon increase of the voltage from 100 to 140 V. In addition, power consumptions at 100 and 140 V were 7.2 and 19.4 kWh, respectively. [Copyright &y& Elsevier]

Removal of hydrophobic organic contaminants (HOCs) using surfactant-enhanced electrokinetic (EK) method was studied in a model system. Kaolinite and phenanthrene were selected as a model clay soil and a representative HOC, respectively. Three different types of surfactants: APG (alkyl polyglucoside), Brij30 (polyoxyethylene-4-lauryl ether), and SDS (sodium dodecyl sulfate), were used to enhance the solubility of HOC. Characteristics of surfactants, such as surface tension, HOC solubility, and biodegradability were measured. In the case of Brij30 solution, phenanthrene solubility was higher than that of others. After 4 days, APG and Brij30 were degraded by 65% and 26% of the initial amount, respectively. However, degradation of SDS was hardly detected. Electroosmotic flow (EOF) of Brij30 solution was lower than others when the 0.1M NaCl was used as electrolyte. Addition of the acetate buffer solution increased the EOF of Brij30 solution and enhanced removal of phenanthrene. Among three different surfactants tested, APG showed the highest removal efficiency. [Copyright &y& Elsevier]

Abstract: Removal characteristics of polycyclic aromatic hydrocarbons (PAHs) from low-permeable soil using a surfactant-enhanced electrokinetic (EK) process were investigated. Phenanthrene and kaolinite were selected as a representative PAH and a model soil. A nonionic surfactant, alkyl polyglucosides (APG), and an anionic surfactant, Calfax 16L-35, were used to enhance the solubility of phenanthrene. The two surfactants showed similar solubilization capacities for phenanthrene, while only APG was affected by sorption. When surfactants were applied to EK process, the electrical potential gradient was lower than that of water. The electroosmotic flow (EOF) decreased as the concentration of surfactant increased. In the case of APG, the removal efficiency of phenanthrene increased with the surfactant concentration. The APG micelles containing phenanthrene easily migrated to the cathode reservoir by EOF. On the other hand, Calfax 16L-35 did not enhance the removal efficiency even at the highest concentration, because most of Calfax 16L-35 remained in soil, and only small amount existed in effluent. It was thought that, during electrokinetic process, Calfax 16L-35 was adsorbed onto soil and the migration of the surfactant from cathode to anode was superior to EOF due to anionic charges of Calfax 16L-35. A nonionic surfactant, APG, seems to be suitable for surfactant-enhanced electrokinetic remediation. [Copyright &y& Elsevier]