Search

In this paper, a new HVDC shunt tap is proposed. The proposed configuration consists of a unidirectional hybrid modular DC–DC converter followed by a voltage source converter for DC–AC conversion to feed a local AC network connected to the tap output terminals. The proposed DC–DC converter consists of a high-voltage valve, and series-connected unidirectional half-bridge Sub-Modules (SMs). Unlike Marx generator circuit concept, the DC–DC conversion in the proposed configuration is achieved by enabling simultaneous charging of series-connected capacitors (i.e. SMs capacitors), and sequential discharging of capacitors. Compared to Marx-generator based switched capacitor DC–DC converters, the proposed configuration has a lower number of semiconductor devices, which affects positively the system cost, and reduces the control complexity. Detailed illustration, design, and control of the proposed approach are presented. Simulation results are presented to validate the proposed approach. [ABSTRACT FROM AUTHOR]

This paper introduces a non-communication based protection algorithm for Multi-Terminal High Voltage Direct Current (MTHVDC) transmission lines. The algorithm relies on using electrical current data at one end for identification of the fault zone without communication between relays. The concept is to use the fault generated transients to differentiate between internal and external faults. Shunt capacitors with predetermined values are installed at the boundary between each two HVDC line sections to assist, together with the busbar stray capacitance, in the classification of internal faults. The high frequency transients will reach the relaying point without any attenuation if the fault is internal; nevertheless, the high frequency transients will be highly attenuated if the fault is external due to the stray capacitance and the installed shunt capacitor at the connection busbar. Discrete Wavelet Transform (DWT) is used to analyze the fault current signals. MTHVDC system modeling and relay design are carried out in the MATLAB/SIMULINK environment. The results of the proposed algorithm were highly reliable regarding different types of faults with different fault resistances and at various locations. [ABSTRACT FROM AUTHOR]

This paper presents a technique for differential protection of Multi-terminal High Voltage Direct Current (MTHVDC) transmission lines. The proposed technique depends on the electrical current data at both ends of each line section. Discrete Wavelet Transform (DWT) is used to detect DC faults as well as filter out the high frequency transients superimposed on the current signals. An operating signal and a restraining signal are used in this technique to discriminate between internal faults and external faults through their ratio in each section of the MTHVDC. The operating and restraining signals depend on energy contents of the de-noised current signals at both ends of each line section. MTHVDC modeling and relay design are carried out in the MATLAB environment. The results demonstrate the high reliability of the proposed relay in the zonal protection of MTHVDC. [ABSTRACT FROM AUTHOR]