Search

Paper, a readily available renewable resource, comprises of interwoven cellulosic fibers, which can be functionalized to develop interesting low-cost adsorbent material for water purification. In this study, polyethyleneimine (PEI)-functionalized paper was used for the removal of hazardous pollutants such as Au and Ag nanoparticles, Cr(VI) anions, Ni 2+ , Cd 2+ , and Cu 2+ cations from spiked water samples. Compared to untreated paper, the PEI-coated paper showed significant improvement in adsorption capacities toward the pollutants investigated in this study. Kinetics, isotherm models, pH, and desorption studies were carried out to study the adsorption mechanism of pollutants on the adsorbent surface. Adsorption of pollutants was better described by pseudo-second order kinetics and Langmuir isotherm model. Maximum adsorption of anionic pollutants was achieved at pH 5 while that of cations was at pH > 6. Overall, the PEI-functionalized paper showed interesting Langmuir adsorption capacities for heavy metal ions such as Cr(VI) (68 mg/g), Ni 2+ (208 mg/g), Cd 2+ (370 mg/g), and Cu 2+ (435 mg/g) ions at neutral pH. In addition, the modified paper was also used to remove Ag-citrate (79 mg/g), Ag-PVP (46 mg/g), Au-citrate (30 mg/g), Au-PVP (17 mg/g) nanoparticles from water. Desorption of NPs from the adsorbent was done by washing with 2 M HCl or thiourea solution, while heavy metal ions were desorbed using 1 M NaOH or HNO 3 solution. The modified paper retained its extraction efficiencies upon desorption of pollutants. [ABSTRACT FROM AUTHOR]

The presence of toxic metals on paper pulp and the migration of these metals to food from the food package is receiving significant attention. The final exposure levels for consumers depend on two main processes. First the potential of metals to bind paper pulp during manufacture. Second, the metal potential to migrate from paper to food during storage and use.Binding and unbinding processes are modelled for cadmium kinetics through kinetic approaches.The cadmium concentration in paper pulp is estimated from the cadmium concentration in the water–pulp liquor during manufacture, the temperature, and contact time. Two food simulants have been employed for desorption studies, water and acetic solution (3%, w/w). As expected, under acidic conditions desorption is total and rapid (close to 100% desorption reached in a few minutes). However, the desorption of cadmium into the neutral food simulant depends on the initial cadmium concentration in the paper pulp, temperature and contact time. Surface response curves for each combination are presented.Temperature did not affect cadmium binding, but played a significant role for the desorption processes into the neutral food simulant.The proposed equations offer a good fitting of the experimental values, with p<0.001 and residuals within a factor of 3 for over 99% of the measured data. These models allow estimations of the expected exposure levels in consumers, on the basis of manufacture and use conditions. Linking the expected exposure with toxicity thresholds, such as the admissible daily intake (ADI), would allow a scientific assessment of the maximum acceptable cadmium levels in water–pulp liquors during manufacture and in the final paper pulp on the basic of the use patterns of each food packaging material. [Copyright &y& Elsevier]

This paper deals with the study of volatile compounds present in a set of three paper and board (P&B) samples of different composition, surface treatment, grammage and thickness. The volatile compounds released by the packaging material (P&B) can be trapped on the food and may then affect the safety and health of consumers. To evaluate if the recycled P&B could be used as food packaging material, adsorption studies have been performed with a selection of chemical substances. The adsorption isotherms are provided. Partition coefficients between paper and air have been calculated for a series of volatile compounds used as model compounds to represent different families of contaminants commonly present in P&B. Values from 4 to 3243 were obtained at different temperatures. The analysis of volatile compounds have been carried out by automatic headspace coupled on-line with GC/MS in SIM mode. The results obtained are shown and discussed. [Copyright &y& Elsevier]