Search

Abstract: A radio over fiber system using the fluorinated based polymer multimode fibers (PMMF) is presented in this paper for the enhancement of the indoor coverage of the multiband orthogonal frequency division multiplexing ultra-wideband standard (MB-OFDM UWB) inside a building. A preliminary part related the cost analysis owing to glass and polymer multimode fiber deployment inside a fiber network is reported. The study of the physical properties of the polymer optical fibers (core diameter, numerical aperture, differential mode delays, modal bandwidth…) is firstly performed in order to effectively exhibit the potentialities and the robustness of such fibers to be used in a low cost radio over fiber system. The DMD measurements of four fluorinated based polymer optical fiber are reported. The designed system operates at 850nm with commercial off the shelf (COTS) devices combined to the intensity modulation/direct detection technique. The opportunity of using polymer fibers and COTS components to improve the indoor coverage of the MB-OFDM UWB standard is so reported by the measurement of the Error Vector Magnitude or the Relative Constellation Error variation as a function of the system parameters (RF power, optical attenuation, fiber length…) as well as the compliance of the eye diagram with the mask testing. By the way, the transmission performance of both 200 and 480Mbps signals is demonstrated over up to 200m link length of polymer multimode fibers: transmission penalties are quantified by relative constellation error with values under the standard requirements. A comparative study with classical OM2 50μm based glass multimode fiber having the same bandwidth/length product than the PMMF is done. [Copyright &y& Elsevier]

In this paper, we report the elaboration of Cu(In,Ga)S 2 chalcopyrite thin films via a sol–gel process. To reach this aim, solutions containing copper, indium and gallium complexes were prepared. These solutions were thereafter spin-coated onto the soda lime glass substrates and calcined, leading to metallic oxides thin films. Expected chalcopyrite films were finally obtained by sulfurization of oxides layers using a sulfur atmosphere at 500 °C. The rate of gallium incorporation was studied both at the solutions synthesis step and at the thin films sulfurization process. Elemental and X-ray diffraction (XRD) analyses have shown the efficiency of monoethanolamine used as a complexing agent for the preparation of CuIn (1− x ) Ga x S 2 thin layers. Moreover, the replacement of diethanolamine by monoethanolamine has permitted the substitution of indium by isovalent gallium from x = 0 to x = 0.4 and prevented the precipitation of copper derivatives. XRD analyses of sulfurized thin films CuIn (1− x ) Ga x S 2, clearly indicated that the increasing rate of gallium induced a shift of XRD peaks, revealing an evolution of the lattice parameter in the chalcopyrite structure. These results were confirmed by Raman analyses. Moreover, the optical band gap was also found to be linearly dependent upon the gallium rate incorporated within the thin films: it varies from 1.47 eV for x = 0 to 1.63 eV for x = 0.4. [ABSTRACT FROM AUTHOR]