Search

Abstract: Diazomethane is a highly explosive and toxic gas routinely employed for the quantitative and clean derivatization of phenols. We investigated the commercially available trimethylsilyldiazomethane in the presence of diisopropylethylamine as a safe, non-explosive and less-toxic alternative using six phenolic polychlorinated biphenyls as model analytes and fluoro-tagged analogues as internal standards. We compared yields and derivatization times of each method employing a liver microsomal extract as a real matrix. Steric hindrance and electronic properties of the analytes were also investigated. The alternative method afforded equal to higher derivatization yields with increased reaction times, up to 100min, while explosion and toxic exposure risks were minimized and cost efficiency was increased above 25%. These findings demonstrate that non-explosive trimethylsilyl diazomethane produces comparable derivatization results to the dangerous diazomethane under the conditions studied. [ABSTRACT FROM AUTHOR]

Abstract: Although ingestion is the major route of exposure to polychlorinated biphenyls (PCBs), dietary factors altering their absorption and excretion are only poorly understood. In the present study, (±)-PCB 136 was administered orally to female C57BL/6 mice fed an unrefined (URD, 10% fat) or high fat (HFD, 40% fat) diet to investigate the effect of the dietary fat content on the disposition of PCBs. Three days after administration, PCB levels in the adipose tissue were significantly lower in HFD animals than URD animals, partly due to a higher excretion rate of PCB 136 in the HFD group. (+)-PCB 136 was enriched in all organs and in feces. In both groups, enantiomeric fractions in feces increased each day after administration. We hypothesize that low EF (enantiomeric fraction) values in feces excreted within 24h of exposure are due to the presence of undigested, racemic PCB. Higher EF values in feces excreted after two and three days are due to excretion of previously absorbed PCBs. Overall, our study suggests that the EF value may be a good tool to investigate the absorption and excretion of PCBs in vivo. [Copyright &y& Elsevier]

Abstract: PCBs, a group of 209 individual congeners, are ubiquitous environmental pollutants and classified as probable human carcinogens. One major route of exposure is by inhalation of these industrial compounds, possibly daily from inner city air and/or indoor air in contaminated buildings. Hallmarks of aging and carcinogenesis are changes in telomere length and telomerase activity. We hypothesize that semi-volatile PCBs, like those found in inner city air, are capable of disrupting telomerase activity and altering telomere length. To explore this possibility, we exposed human skin keratinocytes to a synthetic Chicago Airborne Mixture (CAM) of PCBs, or the prominent airborne PCB congeners, PCB28 or PCB52 for up to 48 days and determined telomerase activity, telomere length, cell proliferation, and cell cycle distribution. PCBs 28, 52 and CAM significantly reduced telomerase activity from days 18–48. Telomere length was shortened by PCB 52 from day 18 and PCB 28 and CAM from days 30 on. All PCBs decreased cell proliferation from day 18; only PCB 52 produced a small increase of cells in G0/G1 of the cell cycle. This significant inhibition of telomerase activity and reduction of telomere length by PCB congeners suggest a potential mechanism by which these compounds could lead to accelerated aging and cancer. [Copyright &y& Elsevier]

Abstract: Polychlorinated biphenyls (PCBs) are a class of persistent organic pollutants with myriad biological effects, including carcinogenicity. We present data showing gender-specific genotoxicity in Fischer 344 transgenic BigBlue rodents exposed to 4-chlorobiphenyl (PCB3), a hydroxylated metabolite, and the positive control 3-methylcholanthrene (3-MC) where female rats are more resistant to the genotoxic effects of the test compounds compared to their male counterparts. This difference is further highlighted through our examination of gene expression, organ-specific weight changes, and tissue morphology. The purpose of the present study was to explore the complex and multifaceted issues of lower molecular weight PCBs as initiators of carcinogenesis, by examining the mutagenicity of PCB3, a hydroxylated metabolite (4′-OH-PCB3), and 3-methylcholanthrene (3-MC, positive control) in a transgenic rodent model. Previous findings indicated that PCB3 is mutagenic in the liver of male BigBlue transgenic rats under identical exposure conditions. We expected that female rats would be equally, if not more sensitive than male rats, since a 2-year carcinogenesis bioassay with Sprague–Dawley rats and commercial PCB mixtures reported much higher liver cancer rates in female than in male rats. The current study, however, revealed a similar trend in the mutation frequencies across all four treatment groups in females as reported previously in males, but increased variability among animals within each group and a lower overall effect, led to non significant differences in mutation frequencies. A closer analysis of the possible reasons for this negative result using microarray, organ weight and histology data comparisons shows that female Fischer 344 rats 1) had a higher baseline mutation frequency in the corn oil control group and greater variability than male rats; 2) responded with robust gene expression changes, which may also play a role in our observation of 3) highly increased liver, spleen, and lung weight in 3-MC and PCB3-treated female rats and thus changed distribution and kinetics of the test compounds. Our analysis indicates that female transgenic BigBlue Fischer 344 rats are more resistant to PCB3 and 3-MC genotoxicity compared to their male counterparts. [Copyright &y& Elsevier]

Abstract: Studies of environmental and toxic effects of polychlorinated biphenyls (PCBs) are ideally performed with PCB mixtures reflecting the composition of environmental PCB profiles to mimic actual effects and to account for complex interactions among individual PCB congeners. Unfortunately, only a few laboratory studies employing synthetic PCB mixtures have been reported, in part because of the challenges associated with the preparation of complex PCB mixtures containing many individual PCB congeners. The objective of this study was to develop a PCB mixture that resembles the average PCB profile recorded from 1996 to 2002 at a satellite station of the Integrated Atmospheric Deposition Network located at the Illinois Institute of Technology (IIT) in Chicago, Illinois, using commercial PCB mixtures. Initial simulations, using published Aroclor profiles, showed that a mixture containing 65% Aroclor 1242 and 35% Aroclor 1254 was a good approximation of the target profile. A synthetic Chicago air mixture (CAM) was prepared by mixing the respective Aroclors in this ratio, followed by GC/MS/MS analysis. Comparison of the PCB profile of the synthetic mixture with the target profile suggests that the synthetic PCB mixture is a good approximation of the average IIT Chicago air profiles (similarity coefficient cos θ =0.82; average relative percent difference=84%). The synthetic CAM was also a reasonable approximation of the average of 184 PCB profiles analyzed in 2007 at 37 sites throughout Chicago as part of the University of Iowa Superfund Basic Research Program (isbrp), with a cos θ of 0.70 and an average relative percent difference of 118%. While the CAM and the two Chicago air profiles contained primarily di- to pentachlorobiphenyls, higher chlorinated congeners, including congeners with seven or eight chlorine atoms, were underrepresented in the synthetic CAM. The calculated TCDD toxic equivalency quotients of the synthetic CAM (2.7 ng/mg PCB) and the IIT Chicago air profile (1.6 ng/mg PCB) were comparable, but lower by two orders of magnitude than the isbrp Chicago air profile (865 ng/mg PCB) due to surprisingly high PCB 126 levels in Chicago air. In contrast, the calculated neurotoxic equivalency quotients of the CAM (0.33 mg/mg PCB) and the two Chicago air profiles (0.44 and 0.30 mg/mg PCB, respectively) were similar. This study demonstrates the challenges and methods of creating and characterizing synthetic, environmental mixtures of PCBs. [Copyright &y& Elsevier]