Search

Abstract: The mechanisms underlying the detection of critically loaded or micro-damaged regions of bone by bone cells are still a matter of debate. Our previous studies showed that calcium efflux originates from pre-failure regions of bone matrix and MC3T3-E1 osteoblasts respond to such efflux by an increase in the intracellular calcium concentration. The mechanisms by which the intracellular calcium concentration increases in response to an increase in the pericellular calcium concentration are unknown. Elevation of the intracellular calcium may occur via release from the internal calcium stores of the cell and/or via the membrane bound channels. The current study applied a wide range of pharmaceutical inhibitors to identify the calcium entry pathways involved in the process: internal calcium release from endoplasmic reticulum (ER, inhibited by thapsigargin and TMB-8), calcium receptor (CaSR, inhibited by calhex), stretch-activated calcium channel (SACC, inhibited by gadolinium), voltage-gated calcium channels (VGCC, inhibited by nifedipine, verapamil, neomycin, and ω-conotoxin), and calcium-induced-calcium-release channel (CICRC, inhibited by ryanodine and dantrolene). These inhibitors were screened for their effectiveness to block intracellular calcium increase by using a concentration gradient induced calcium efflux model which mimics calcium diffusion from the basal aspect of cells. The inhibitor(s) which reduced the intracellular calcium response was further tested on osteoblasts seeded on mechanically loaded notched cortical bone wafers undergoing damage. The results showed that only neomycin reduced the intracellular calcium response in osteoblasts, by 27%, upon extracellular calcium stimulus induced by concentration gradient. The inhibitory effect of neomycin was more pronounced (75% reduction in maximum fluorescence) for osteoblasts seeded on notched cortical bone wafers loaded mechanically to damaging load levels. These results imply that the increase in intracellular calcium occurs by the entry of extracellular calcium ions through VGCCs which are sensitive to neomycin. N-type and P-type VGCCs are potential candidates because they are observed in osteoblasts and they are sensitive to neomycin. The calcium channels identified in this study provide new insight into mechanisms underlying the targeted repair process which is essential to bone adaptation. [Copyright &y& Elsevier]

Abstract: The two main types of mechanical stimuli used in cellular-level bone mechanotransduction studies are substrate strain and flow-induced shear stress. A subset of studies has investigated which of these stimuli induces the primary mechanotransduction effect on bone cells. The shortcomings of these experiments are twofold. First, in some experiments the magnitude of one loading type is able to be quantitatively measured while the other loading mode is only estimated. Second, the two loading modes are compared using different bioreactors, representing different cellular environments and substrates to which the cells are attached. In addition, none of these studies utilized bioreactors which apply controlled magnitudes of substrate strain and flow-induced shear stress differentially and simultaneously. This study presents the design of a multimodal loading device which can apply substrate stretch and fluid flow simultaneously while allowing for real-time cell imaging. The mechanical performance of the bioreactor is validated in this study by correlating the output levels of flow-induced shear stress and substrate strain with the input levels of displacement and displacement rate. The magnitudes of cross-talk loading (i.e. flow-induced strain, and strain-induced fluid flow) are also characterized and shown to be magnitudes lower than physiological levels of loading estimated to occur in bone in vivo. [Copyright &y& Elsevier]

Abstract: The mechanisms by which bone cells sense critically loaded regions of bone are still a matter of ongoing debate. Animal models to investigate response to microdamage involve post mortem immunohistological analysis and do not allow real-time monitoring of cellular response during the emergence of the damage in bone. Most in vitro mechanical stimulation studies are conducted on non-bone substrates, neglecting the damage-related alterations in the pericellular niche and their potential effects on bone cells. The current study reports spontaneous efflux of calcium ions (Ca2+) (1.924±0.742 pmol cm−2 s−1) from regions of devitalized bone matrix undergoing post-yield strains, induced by a stress concentrator. When these samples are seeded with MC3T3-E1 osteoblasts, the strain-induced Ca2+ efflux from bone elicits cell response at the stress concentration site as manifested by activation of intracellular calcium signaling (increase in fluorescence by 52%±27%). This activity is associated with extracellular calcium because the intracellular calcium signaling in response to mechanical loading subsides when experiments are repeated using demineralized bone substrates (increase in fluorescence by 6%±10%). These results imply a novel perspective where bone matrix acts as an intermediary mechanochemical transducer by converting mechanical strain into a chemical signal (pericellular calcium) to which cells respond. Such a mechanism may be responsible for triggering repair at locations of bone matrix undergoing critical deformation levels. [Copyright &y& Elsevier]

Abstract: A prominent opacity is evident in the process zone of notched thin wafers of bone loaded in tension. Being recoverable upon unloading, this opaque zone can be stained only when the sample is under load, unlike the classically reported forms of damage which take up the stain in the unloaded state. Furthermore, despite the stain uptake, microcracks are absent in the stained area examined by high magnification optical microscopy and atomic force microscopy (AFM). Therefore, the size scale and the electric charge of the features involved in the process zone were probed at the submicron level by using a wide range of fluorescent dyes of different molecular weights and charges. It was observed that negatively charged dyes penetrate the process zone and that dyes greater than 10kDa (about 10–20nm in size) were unable to label the process zone. Digital image correlation (DIC) measurements indicated that the opacity initiates at about 1% principal strain and the strain accumulates up to 14%. While the opacity was largely recoverable upon unloading, the core regions which experienced large strains had permanent residual strains up to 2%, indicating that the observed deformation phenomenon can be interlocked within bone matrix without the formation of microcracks. Based on the similarity of size and their known affinity for negatively charged species, exposure of mineral nanoplatelets is proposed as prime candidates. Therefore, the deformation process reported here may be associated with debonding of mineral crystals from the neighboring collagen molecules. Overall, post-yield deformation of bone at the micron scale takes place by large strain events which are accommodated in bone matrix by the generation of nanoscale positively charged interfaces. [Copyright &y& Elsevier]

Abstract: Topographical cues from the extracellular microenvironment can influence cellular activity including proliferation and differentiation. Information on the effects of material topography on tenogenic differentiation of human mesenchymal stem cells (human MSCs) is limited. A methodology using the principles of isoelectric focusing has previously been developed in our laboratory to synthesize electrochemically aligned collagen (ELAC) threads that mimics the packing density, alignment and strength of collagen dense connective tissues. In the current study, human MSCs were cultured on ELAC and randomly oriented collagen threads and the effect of collagen orientation on cell morphology, proliferation and tenogenic differentiation was investigated. The results indicate that higher rates of proliferation were observed on randomly oriented collagen threads compared to ELAC threads. On the other hand, tendon specific markers such as scleraxis and tenomodulin, were significantly increased on ELAC threads compared to randomly oriented collagen threads. Additionally, osteocalcin, a specific marker of bone differentiation was suppressed on ELAC threads. Previous studies have reported that BMP-12 is a key growth factor to induce tenogenic differentiation of MSCs. To evaluate the synergistic effect of BMP-12 and collagen orientation, human MSCs were cultured on ELAC threads in culture medium supplemented with and without BMP-12. The results revealed that BMP-12 did not have an additional effect on the tenogenic differentiation of human MSCs on ELAC threads. Together, these results suggest that ELAC induces tenogenic differentiation of human MSCs by presenting an aligned and dense collagen substrate, akin to the tendon itself. In conclusion, ELAC has a significant potential to be used as a tendon replacement and in the development of an osteotendinous construct towards the regeneration of bone–tendon interfaces. [Copyright &y& Elsevier]

A simple, disposable, and integrated electronic-tube cap (E-tube cap) for DNA detection at the point-of-care was designed, fabricated, and tested. The E-tube cap contains a 3D printed electrode substrate for DNA extraction and label-free pH sensing detection. One Flinders Technology Associates (Whatman FTA) membrane was incorporated into the 3D printed electrode substrate for the isolation, concentration, and purification of DNA. The E-tube cap with captured DNA by the membrane was inserted directly into a reaction tube for loop-mediated isothermal amplification (LAMP). The isothermal amplification process was monitored in real-time by a 3D printed electrochemical electrode coated with pH-sensitive material (carbon/iridium oxide layer). The pH sensing electrode showed an excellent linear response within the pH range of 6–9 with a slope of −31.32 ± 0.5 mV/pH at room temperature. The utility of the integrated E-tube cap was demonstrated by detecting the presence of lambda DNA spiked in saliva samples with a sensitivity of 100 copies per mL sample within 30 min. Such a simple, rapid, and affordable diagnostic device is particularly suitable for point-of-care molecular diagnostics of infectious diseases. [Display omitted] • A simple and integrated electronic-tube cap (E-tube cap) was developed for DNA detection in saliva samples. • A 3D printed electrode is able to perform DNA extraction, isothermal amplification, and electrochemical detection. • Real-time, quantitative electrochemical detection of nucleic acid without need of electrochemical label. • Simple pH sensing electrode showed a linear response within the pH range of 6–9 with a slope of −31.32 ± 0.5 mV/pH. • A detection sensitivity of 100 copies/mL has been achieved for lambda DNA detection in saliva sample within 30 min. [ABSTRACT FROM AUTHOR]