Search

Abstract: The typical electrical distribution system shows a passive characteristic in relation to power flows (i.e. unidirectional power flows from substation to loads along the feeder). However, with the inclusion of solar photovoltaic (PV) generators along the feeder, this behavior is changed, and characteristics related to power quality, such as voltage level and total harmonic distortion (THD), may be affected. This paper presents the analysis of power quality in a feeder of the urban grid in the city of the Florianopolis, Brazil, with the integration of grid-connected PV systems as distributed generation. The analysis of power quality is based on real measurements of THD on an existing 12kWp PV pilot plant installed in the urban environment, and power flow simulations of a hypothetical PV system of 4.2MWp distributed in the same area, using the ANAREDE software. The power flow simulations allowed assessing the voltage level, the direction of power flow and loading of the distribution lines. The introduction of limited amounts of PV generation as distributed generation in the urban environment was found to be beneficial in several aspects: better voltage profile; power loss reduction and improvement in total harmonic distortion of the voltage (THDv). Furthermore, photovoltaics as a distributed generation source can also postpone feeder capacity upgrading investments. [Copyright &y& Elsevier]

Abstract: The integration of photovoltaic (PV) modules on building façades and rooftops is an ideal application of solar electricity generators in the urban environment. Maximum annual performance of grid-connected PV is usually obtained with modules tilted at an angle equal to the site latitude, facing the equator. The performance of PV systems not tilted and oriented ideally can drop considerably, depending on site latitude. With grid parity – when the cost of solar electricity becomes competitive with conventional electricity – expected in many countries in the present decade, a more widespread application of PV on buildings is expected, and in this context the main goal of this paper is to demonstrate that good compromises between form and function are possible. In this work we compare the annual energy generation of a curved BIPV system installed as a car port rooftop, with an ideally-oriented and tilted, flat BIPV system installed as a building’s rooftop cover at a low-latitude site (27°S). For the one-year period analysed, the curved-shape BIPV system annual yield was 12% lower than that of the reference BIPV system, and during the summer months (November to February), the curved BIPV installation presented a higher energy yield than the latitude-tilted generator. With these results we show that a good compromise can be reached between form and function in BIPV systems. [Copyright &y& Elsevier]