Search

This work studies the fatigue behavior of biodegradable composites of thermoplastic starch (TPS) reinforced with different amounts of date palm fibers (DPF) (20, 50, and 70 wt%). Composite with 50 wt% fiber content had higher static and fatigue strengths compared to other composites. The alternating stress at which the composites lasted for 10 7 cycles was about 16% of the flexural strength. Mathematical models following the assumptions of D’Amore et al. (1996) and Mao and Mahadevan (2002) were shown to give a good agreement with experimental results of the residual strengths under various fatigue cycles and of the fatigue damage index at different levels of stresses.

In this study, the electromechanical properties of two different three-dimensional (3D) printed continuous wire polymer composites (CWPC) were characterized and compared. The two composite materials were copper wire polylactic acid (PLA) composite (rigid material) and copper wire polyurethane (PU) composite (flexible material). The electromechanical measurements were based on piezoresistive properties of the sensor at which the mechanical strain and the electrical resistance were correlated under a uniaxial loading condition. Both types of materials exhibited a direct linear relationship between the two quantities, indicating the ability of CWPC to be used for strain sensing applications. The gauge factor (GF) sensitivity was compared for the two types of materials. It was found that there is no statistical significance difference between the GF of PLA CWPC (1.36 ± 0.14) and PU CWPC (1.29 ± 0.07)); therefore, the sensing property depends mainly on the wire integrated into the 3D-printed structure rather than the matrix. Thus, different matrices can be used to fit different applications. An analytical model for GF showed agreement with the experimental results for both materials. PU CWPC showed significant improvement in both Young’s modulus (E) and ultimate tensile strength (UTS) (210.5 % and 31.86 %, respectively), compared with pure PU, while the change in Poisson’s ratio (ν) was insignificant. Young’s modulus of PLA CWPC was significantly increased by 80.3 % compared with PLA, while UTS and ν did not significantly change. The experimental mechanical properties showed good agreement with data from the analytical models. The outcome of this study focused on the manufacturing of 3D-printed functionalized structure for strain sensing applications with improved mechanical properties. The wide range of attained strain allowed their use in different applications based on the range of strain needed, such as rigid sports equipment and flexible wearable sensors.