Search

Tunable Diode Laser Absorption Spectroscopy (TDLAS) based gas sensing technology, has widespread applications, ranging from use in biomedical industry to aerospace applications. An experimental set-up was established to measure concentration of oxygen gas in the range 0–100% using TDLAS technique. The oxygen absorption at 760.241 nm was scanned with a tunable DFB laser, and wavelength modulation spectroscopy was used to obtain the harmonics (1f, 2f, 3f & 4f) of the oxygen absorption signal. The modulation parameters such as the modulation voltage, modulation frequency, reference phase, time constant of lock in amplifier, the tuning voltage, and the tuning frequency were optimized to obtain the harmonics of high amplitude and narrow half width. Keeping the experimental parameters constant, the oxygen concentration measurements were obtained by the following three methodologies, viz, (i) using only the 2nd harmonic, (ii) using the 2nd and 4th harmonics and, (iii) using the 1st and 2nd harmonics. The results of these measurements were compared and the merits and drawbacks of these methods are discussed.

Multiwalled carbon nanotube (CNT) arrays were grown by catalytic thermal decomposition of acetylene, over Fe-catalyst deposited on Si-wafer in the temperature range 700–750 °C. The growth parameters were optimized to obtain dense arrays of multiwalled CNTs of uniform diameter. The vertical cross-section of the grown nanotube arrays reveals a quasi-vertical alignment of the nanotubes. The effect of varying the thickness of the catalyst layer and the effect of increasing the growth duration on the morphology and distribution of the grown nanotubes were studied. A scotch-tape test to check the strength of adhesion of the grown CNTs to the Si-substrate surface reveals a strong adhesion between the grown nanotubes and the substrate surface. Transmission electron microscopy analysis of the grown CNTs shows that the grown CNTs are multiwalled nanotubes with a bamboo structure, and follow the base-growth mechanism.

Electrical resistance measurements are reported for amorphous $In_{20}Te_{80}$ and $Cu_{25}Au_5Te_{70}$ alloys up to a pressure of 80 Kbar using a Bridgman anvil apparatus and a four lead arrangement to measure resistances. The amorphous samples are produced by liquisol quenching. The resistance shows time dependent changes which are analysed in detail. The contention that there is a pressure-induced transformation from the amorphous to the crystalline phase is confirmed by X-ray diffraction of samples recovered after they were pressurised to 35 Kbar in a hydrostatic environment.