Search

A unimorph flexural transducer design is proposed and tested with regard to mode shapes and frequencies. The transducers consist of a passive metal cap structure, and a thin piezoelectric disc, rigidly bonded to the inside. Extensive finite element (FE) modelling, and experimental 2D, time-resolved displacement measurements were done to characterise the transducers flexural properties, and to compare them to the analytical solutions of thin vibrating plates. Emphasis was put on characterising the passive layer of the unimorph structure, before bonding the piezoelectric element, to understand how the active element affects the behaviour of the flexing plate. A high power Nd:YAG laser was used to actuate the metal plate (non-contact), and the frequency content of the resulting displacement signal was analysed to identify the flexural modes. The non-axisymmetric modes, which are conventionally disregarded because of their unfavourable acoustic properties, were also taken into account. There was excellent agreement between the experimental results and the FE simulation data. There was good agreement with the analytical edge clamped plate model, but with some notable deviations, which have not previously been identified or commented upon. Specifically, the second axisymmetric mode is split into three separate modes, which is not explained by the traditional theory of vibrating plates., (Crown Copyright © 2015. Published by Elsevier B.V. All rights reserved.)

Aldose reductase (AKR1B1; ALR2; E.C. 1.1.1.21) is an NADPH-dependent carbonyl reductase which has long been associated with complications resulting from the elevated blood glucose often found in diabetics. The development of effective inhibitors has been plagued by lack of specificity which has led to side effects in clinical trials. To address this problem, a library of bead-immobilized compounds was screened against fluorescently labeled aldose reductase in the presence of fluorescently labeled aldehyde reductase, a non-target enzyme, to identify compounds which were aldose reductase specific. Picked beads were decoded via novel bifunctional bead mass spec-based techniques and kinetic analysis of the ten inhibitors which were identified using this protocol yielded IC50 values in the micromolar range. Most importantly, all of these compounds showed a preference for aldose reductase with selectivities as high as approximately 7500-fold. The most potent of these exhibited uncompetitive inhibition versus the carbonyl-containing substrate D/L-glyceraldehyde with a Ki of 1.16 microM.