Search

The selection of an appropriate turbulence/transition model is critical when simulating the hypersonic flows based on the Reynolds-averaged Navier–Stokes (RANS) equation. In particular, a deep understanding of the validity, reliability, and limitations of existing models is an essential prerequisite to facilitate their further development. This paper reports on the assessment of two models dedicated to hypersonic boundary layer transition analysis. Both models are compared with two other models that are widely used in this field. The double ramp and shock wave laboratory scramjet intake cases are used for the validation and evaluation of the predictive performance of both models via comparison against experimental data. The results reveal that the appropriate selection of the transition model is critical to the attainment of accurate results. Moreover, the forebody of the scramjet combustion propulsion-01 (SCP-01) flight vehicle, which is a research model, is analyzed as a case study. The air intake performance of the SCP-01, as predicted by four models, is compared and analyzed at different flight altitude and Mach number conditions. The results reveal that the accuracy of the prediction of boundary layer and separated flow transitions significantly affects the flow field and corresponding air intake performance. Furthermore, the uncertainty of results obtained using the two models increases significantly with an increase in altitude. Finally, the reliability and limitations of the transition models considered in this study are examined. [ABSTRACT FROM AUTHOR]

Magnetohydrodynamic (MHD) control of hypersonic laminar separation flows is investigated in this paper. A series of numerical simulations over various geometry configurations, namely, a compression corner and a double wedge ramp hypersonic inlet, have been conducted by application of an external electromagnetic field. Results show that the performance of MHD separation flow control is mainly determined by flow acceleration of the Lorentz force directed in the streamwise direction. The Joule heating term always brings negative effects on the MHD separation flow control and increased the static pressure locally, where the electromagnetic field is applied. With an external electromagnetic field applied, the low velocity fluid in the boundary layer can be accelerated. Moreover, there exists a best location for the MHD zone to be applied and completely eliminate the separation of the flow from the surface. [ABSTRACT FROM AUTHOR]

A computational-based investigation has been carried out to examine the heat transfer effects of normal and tangential blowing on blunt surfaces exposed to high Mach number flows. Experimental results from such studies where a controlled outflow is imposed upon a surface under hypersonic conditions are few and far between. Simple 3D axisymmetric configurations supporting flat front surfaces suited to accommodate uniform frontal flow or round-nosed conical bodies with a stepped shoulder to provide uniform parallel flow to the conical surface were selected from a NASA experiment for validation purposes. Uniform outflow of 0.55 to 1.0 kg/s was applied in the presence of the prevailing free stream of M=6.8 to assess the extent of heat transfer rate alleviation. The numerical simulation confirmed the experiment that the application of outflow in both cases leads to the surface heat transfer relief. [ABSTRACT FROM AUTHOR]