Search

Nanocrystalline Pb1−3x/2GdxTiO3 (where x=0.01) abbreviated as PGT has been synthesised by high energy ball milling at room temperature. Milling was continuous and X-ray analysis shows that single phase tetragonal structure of nanocrystalline PGT was formed after 15 h milling. The average crystallite size was found to be 17 nm. The frequency dependent ac conductivity of the PGT ceramic was studied in the range 100–525°C. Complex impedance analysis suggested the dielectric relaxation to be of non-Debye type. The activation energy was found to be 1.04 ev. The mechanism of charge transport in nanocrystalline PGT was successfully explained by correlated hopping model.

The new possibility of side-on laser ignition of p-11B with negligible radioactivity encouraged to study the fusion of solid state p-7Li fuel that again turns out to be only about 10 times more difficult than the side-on ignition of solid deuterium-tritium using petawatt-picosecond laser pulses at anomalous interaction conditions if very high contrast ratio. Updated cross sections of the nuclear reaction are included.

In addition to the matured “laser inertial fusion energy” with spherical compression and thermal ignition of deuterium-tritium (DT), a very new alternative for the fast ignition scheme may have now been opened by using side-on block ignition aiming beyond the DT-fusion with igniting the neutron-free reaction of proton-boron-11 (p-11B). Measurements with laser pulses of terawatt power and ps duration led to the discovery of an anomaly of interaction, if the prepulses are cut off by a factor 108(contrast ratio) to avoid relativistic self focusing in agreement with preceding computations. Applying this to petawatt (PW) pulses for Bobin-Chu conditions of side-on ignition of solid fusion fuel results after several improvements in energy gains of 10,000. This is in contrast to the impossible laser-ignition of p-11B by the usual spherical compression and thermal ignition. The side-on ignition is less than ten times only more difficult than for DT ignition. This is essentially based on the instant and direct conversion the optical laser energy by the nonlinear force into extremely high plasma acceleration. Genuine two-fluid hydrodynamic computations for DT are presented showing details how ps laser pulses generate a fusion flame in solid state density with an increase of the density in the thin flame region. Densities four times higher are produced automatically confirming a Rankine-Hugoniot shock wave process with an increasing thickness of the shock up to the nanosecond range and a shock velocity of 1500 km/s which is characteristic for these reactions.

An anomalously strong increase of nuclear fusion gains for laser driven compression and thermal ignition of hydrogen-boron11 has been discovered from computations by using the latest results of Newins and Swain about details of a resonance maximum of the astrophysical S-function at 148 keV for the reaction cross-sections. Extensive computations based on volume ignition showed some usual improvements of the fusion gains. However, for a very narrow range of parameters, the increase of the gain was found to be higher by more than a factor 6. This is very unusual in all similar computations and is related to retrograde properties which were known for other parameter values. On top it is most important that the anomalous range is in the practically very interesting range for incorporation of laser pulse energies of few megajoules. The gains of up to 20 may be of interest for power generation in future by the high density fusion scheme.

In contrast to the usual laser fusion scheme with spherical irradiation and very high compression and ignition of fuel, the alternative scheme with side-on ignition of uncompressed solid density of fuel (Chu) may lead to a solution by using the now available picosecond laser pulses with higher than petawatt power. A necessary condition is to use clean laser pulses with better than 108contrast ratio for suppression of relativistic self-focusing. When updating the analysis of Chu for fusion of deuterium-tritium and proton-11B, one problem is that the correct use of the stopping power of the alpha particles had to be solved. Discrepancies are evaluated in view of the stopping power at the low temperature range of the plasmas where the change of the emitted bremsstrahlung is involved.

Energy production by laser driven fusion energy is highly matured by spherical compression and ignition of deuterium-tritium (DT) fuel. An alternative scheme is the fast ignition where petawatt (PW)-picosecond (ps) laser pulses are used. A significant anomaly was measured and theoretically analyzed with very clean PW-ps laser pulses for avoiding relativistic self focusing. This permits a come-back of the side-on ignition scheme of uncompressed solid DT, which is in essential contrast to the spherical compression scheme. The conditions of side-on ignition thresholds needed exorbitantly high energy flux densities E*. These conditions are now in reach by using PW-ps laser pulses to verify side-on ignition for DT. Generalizing this to side-on igniting solid state density proton-Boron-11 (HB11) arrives at the surprising result that this is one order of magnitude more difficult than the DT fusion. This is in contrast to the well known impossibility of igniting HB11 by spherical laser compression and may offer fusion energy production with exclusion of neutron generation and nuclear radiation effects with a minimum of heat pollution in power stations and application for long mission space propulsion.

The anomaly at laser plasma interaction at laser pulses of TW to PW power and ps duration led to a very unique generation of quasi-neutral plasma blocks by a skin layer interaction avoiding the relativistic self-focusing. This is in contrast to numerous usual experiments. The plasma blocks have ion current densities above 1011A/cm2and may be used for a fast ignition scheme with comparably low compression of the deuterium tritium (DT) fuel. The difficulty is that a very high energy flux densityE* of the ions is necessary according to the hydrodynamic theory (Bobin, 1971, 1974; Chu, 1972). This theory did not include the later discovered collective effect for the stopping power of the alpha particles. One problem is being discussed, whether the Bethe-Bloch binary collision theory or the collective collision theory of Gabor has to be applied. The inclusion of the collective effect results in a reduction of the threshold value ofE* for ignition by a factor of about fife.

Controlled fusion energy from burning hydrogen with boron-11 is of interest because no neutrons are produced. Following the scheme of ignition by spherical irradiation by laser or particle beams, one has to deal with exorbitant conditions of densities and input energies. A new approach following the scheme of block ignition with laser pulses of picosecond (ps) duration and more than petawatt (PW) power led to the possibility of plane geometry irradiation of the fuel using the anomalous effect of block ignition for deuterium tritium (DT) based on updated conditions for the initial computations. We present the extension for H-11B resulting in a very less dramatic difference to DT than in the case of spherical pellet geometry. Ignition thresholds may be only about one order of magnitude higher and the needed temperatures of about 50 keV are no problem for the skin layer acceleration by nonlinear forces (SLANF) for the block generation.

Fast ignition for fusion energy by using petawatt-picosecond (PW-ps) laser pulses was modified due to an anomaly based on extremely clean suppression of prepulses. The resulting plasma blocks with space charge neutral ion current densities above 1011Amp/cm2may be used to ignite deuterium-tritium at densities at or little above solid state density. The difficulty is to produce extremely high energy flux densities of the blocks. Results are reported how the threshold can be reduced by a factor up to fife if the inhibition factor for thermal conductivity due to electric double layers is included in the hydrodynamic analysis.