Search

Series active power filters (APF) are an important solution to deal with power quality issues in weak grids under the presence of non-linear loads. The use of voltage feedback from the critical-load-bus (cload-bus) in the series APF allows for a control strategy that has performance and processing power advantages, when compared to other strategies in literature, but can cause saturation of injection transformers. This paper presents a control strategy that uses cload-bus voltage feedback with an additional control loop of the dc current in the output of the series APF voltage source converter (VSC), to avoid injection transformer saturation. The controlled dc current is additionally used for balancing the split dc-bus capacitors voltage in the VSC. The series APF and the proposed control strategy are modeled using small signal analysis for allowing controller design. Experimental results from a 3 kVA prototype are presented, with cload-bus voltage total harmonic distortion improving from 9% to 3% in each phase, while achieving the objectives of improved cload voltage waveform, controlled transformer dc current, and balanced dc-bus capacitors voltage. [ABSTRACT FROM AUTHOR]

This paper presents a simplified control technique for a dual three-phase topology of a unified power quality conditioner—iUPQC. The iUPQC is composed of two active filters, a series active filter and a shunt active filter (parallel active filter), used to eliminate harmonics and unbalances. Different from a conventional UPQC, the iUPQC has the series filter controlled as a sinusoidal current source and the shunt filter controlled as a sinusoidal voltage source. Therefore, the pulse width modulation (PWM) controls of the iUPQC deal with a well-known frequency spectrum, since it is controlled using voltage and current sinusoidal references, different from the conventional UPQC that is controlled using nonsinusoidal references. In this paper, the proposed design control, power flow analysis, and experimental results of the developed prototype are presented. [ABSTRACT FROM PUBLISHER]

This paper presents the dynamic modeling and digital control of a single-stage isolated current rectifier with power factor correction based on the integration of full-bridge and flyback converters. This converter is designed to operate with adjustable output voltage so that it can operate in two distinct operation modes, depending on the input and output voltages. Therefore, small-signal state-space average models are obtained for the converter operating in step-down and step-up operation modes, and analysis and design of the digital control system are included for different operating points. Experimental results based on a 3-kW prototype are presented to validate the proposed control system under distinct conditions. [ABSTRACT FROM PUBLISHER]