Search

By measuring the open-circuit radial stray magnetic flux density (RSMFD) of three spatial points, a novel diagnostic method for the eccentricity of interior permanent magnetic motors (IPMSMs) in electric vehicles is proposed. Outperforming traditional methods, the proposed method can noninvasively diagnose not only the severities of static eccentricity (SE), dynamic eccentricity (DE), and mixed eccentricity (ME), but also the eccentricity location. In this article, diagnosis results are described through three eccentricity parameters: SE ratio, DE ratio, and SE angle. First, an analytical model of the open-circuit RSMFD of the IPMSM is proposed, with its accuracy validated by experiments. The pattern of the impact of the eccentricity parameters on the open-circuit RSMFD is analyzed to form the basis of the proposed method. Then, an eccentricity prototype motor, which can continuously emulate the eccentricity according to any listed eccentricity parameters, is developed. A test rig is built to collect the open-circuit RSMFD and validate the analytical calculation results. Finally, an eccentricity diagnostic model based on the open-circuit RSMFD is established. The diagnosis results proved the noninvasiveness, effectiveness, and viability of the proposed method. [ABSTRACT FROM AUTHOR]

The dual-stator winding induction generator (DWIG) is an alternative main generator in a variable frequency ac power system. So far, the existing studies have not covered the issue of DWIGs excitation controllability, which is a matter of importance for airworthiness. In this article, we develop an impedance-based modeling and analysis technique to investigate DWIGs excitation controllability. Two related topics are presented: the spontaneous self-excitation analysis in uncontrolled system and the implicit internal self-excitation pattern analysis in actively controlled system. In the topic about spontaneous self-excitation, a virtual impulse source technique is developed to derive the impedance-based method properly in the analysis for uncontrolled DWIG. In the second topic, the analysis performed in the presence of a closed-loop controller figures out the same underlying mechanism in both the plant's open-loop stability and the spontaneous self-excitation. The experimental results verify the proposed analysis and techniques that benefit the comprehensive understanding and practical application of DWIG-based power system. [ABSTRACT FROM AUTHOR]

In an interior permanent magnet synchronous motor (IPMSM) with segmented skewed poles, the armature reaction magnetic field (AR-MF) changes nonlinearly due to the saturation of the rotor magnetic barrier. Meanwhile, this varies under different excitation currents. As a result, it is difficult to be calculated by means of analytical methods. In this paper, the calculation model of AR-MF of IPMSM is first established by vector superposition method, without considering the saturation effect of rotor and the slotting effect of stator. In the second step, the virtual magnetic field of the rotor is introduced to quantitatively calculate the influence of local inhomogeneous saturation on the AR-MF. The latter is derived by combining both the subdomain method and equivalent magnetic circuit method. The complex relative permeance is also introduced to establish the AR-MF accounting for the stator slotting effect. To validate the AR-MF calculation method proposed, an 8-pole 48-slot IPMSM with segmented skewed poles is considered as a case study, showing a comparison by both with finite element (FE) results and the electromagnetic torque measured on a test bench. The model proposed in this paper shows high accuracy and fast computation with respect to FE analysis. [ABSTRACT FROM AUTHOR]

In order to better address the problem of many high-order harmonics’ concentration in the output voltage, a novel five-phase piecewise-random-switching-frequency space vector pulse width modulation (PRSF-SVPWM) strategy is proposed for a five-phase voltage source inverter. Compared to the conventional random switching frequency SVPWM (RSF-SVPWM), the entire fundamental period of this method is divided into two half-fundamental periods, so the original switching frequency in a single fundamental period is randomized in segments respectively. During this process, parameters named the offset frequency and random frequency are defined and assigned reasonably. In this way, high-frequency harmonics in one period are spread into a wider range. Subsequent simulation and experimental results verify that the proposed random modulation strategy can further reduce amplitudes of harmonics near switching frequency and its integer multiples, even though within a narrow switching frequency range, and a satisfactory effect of high-order harmonic dispersion is finally obtained, which contributes to the application and popularization of random pulse width modulation strategies. [ABSTRACT FROM AUTHOR]

In this article, a rotor position tracking control (RPTC) strategy is proposed to effectively reduce the speed fluctuation for a direct-drive permanent magnet synchronous motor servo system operating at a low speed with different torque disturbances. In this article, considering the derivative relationship between the rotor position and speed, a speed command is converted to a real-time rotor position trajectory, and then a position-current two-loop control with the RPTC controller is proposed based on the internal model method to smoothly track the rotor position. In addition, the parameter design of the RPTC controller from the perspectives of robust stability and antidisturbance capability is investigated as well. The comparative simulation and experimental results demonstrate that, at a low speed, the proposed RPTC strategy has a good speed performance for both periodic and nonperiodic torque disturbances. Moreover, it enjoys a simple implementation for not requiring the precise speed feedback and specific torque disturbance information. [ABSTRACT FROM AUTHOR]

In this article, a virtual cogging torque (VCT) control method to reduce the speed ripple of direct-drive permanent magnet synchronous machine servo system under low-speed conditions is proposed. Compared with other factors, at low speeds, the cogging torque is the main factor that deteriorates the drive performance, even induces speed oscillations. Especially in this article, due to volume limitation, the cogging torque is designed larger than normal one in order to remove the need of brake. Based on the model of permanent magnet synchronous motor, the cause and effect of the cogging torque are analyzed. Inspired by the characteristic of cogging torque, the VCT control method is proposed and investigated to significantly reduce the speed ripple at low speeds. The main idea of this proposed control method is to produce a proper VCT and continuously move the corresponding virtual stable equilibrium point to drive the rotor smoothly. In addition to the principle of this control method, its analysis and implementation are studied as well. Simulation and experimental results from the prototype demonstrate that the proposed control method is correct and valid, and it is simple and effective to smooth the speed at low-speed operations. [ABSTRACT FROM AUTHOR]

This paper presents an integrated control strategy for a starter/generator (S/G) system based on five-phase dual-stator winding induction machine (FPDWIM). The FPDWIM has a cage-type rotor and two sets of stator windings. One is a five-phase control winding (CW), and the other is a five-phase power winding (PW). In the starting mode, the FPDWIM works as a motor. The CW provides both active power and reactive power to drive the engine. In the generating mode, the CW mainly handles reactive power while the PW outputs active power. To achieve the integration of the starting and generating controls, indirect CW-flux-oriented control (ICWFOC) to operate in both starting and generating modes is proposed in this paper. In starting mode, the CW current and flux are controlled to output a constant starting torque; while in the generating mode, both CW and PW dc bus voltages are regulated. In this way, the principles and structures of the control strategies in both modes are compatible, resulting in a simpler implementation and improved performance. With the proposed control strategy, the system can complete the starting–generating operation with a smoother transition process. Simulation and experimental results are compared to validate the proposed control strategy. [ABSTRACT FROM AUTHOR]

The starter/generator (SG) system is widely used in various applications, including more-electric/hybridelectric aircraft (MEA/HEA) and hybrid electric vehicles (HEVs). The electric machine operates as a motor to provide the required torque to start the engine. Once the engine starts, the same electric machine transforms to a generator to produce electrical power. With the advantages of a simple and robust structure, low cost and maintenance, and a good overload capability, the cage-type induction machine (IM) is a competitive candidate for SG systems. [ABSTRACT FROM AUTHOR]

This paper presents a five-phase dual random space vector pulsewidth modulation (FPDR-SVPWM) strategy with an optimized probability density function (PDF) for a five-phase voltage-source inverter, and its performance and evaluation are also analyzed. Based on the nearest four vectors modulation method, the FPDR-SVPWM strategy, combined with random switching frequency and random zero vector, is investigated to significantly reduce the amplitude of high-order harmonics near the switching frequency and its integer multiples. For the nonsinusoidal power supply, third harmonic injection is introduced in this modulation strategy as well. Considering the effect of random numbers on the performance, an optimized Beta distribution is studied in detail. In order to analyze harmonic dispersion degree qualitatively and quantitatively, the power spectral density and the harmonic spread factor are both employed to assess the performance of the FPDR-SVPWM strategy. A series of results of simulation in MATLAB and experiments based on field programmable gate array demonstrate that the proposed modulation strategy is correct and valid, and it distributes high-order harmonics into a wide range without affecting the fundamental wave and third harmonic. [ABSTRACT FROM AUTHOR]

Dual stator-winding induction generator (DWIG) is attractive in stand-alone power systems, and the aim of this paper is to develop the dc generating system of five-phase DWIG with an open phase. First, the relationship between flux and torque is constructed based on the reduced-order transformation, modified flux, and current. Second, the relation between modified voltage and current on the dq plane is constructed. The current of fundamental plane is used for the control loop of the power-winding voltage and control-winding voltage, respectively. Third, the current of the modified secondary subspace plane is used to control the five-phase DWIG operation at minimum control-winding loss. Finally, the simulation and experimental results are given to verify that the amplitude of phase current and output voltage can be regulated effectively by the proposed control strategy. [ABSTRACT FROM AUTHOR]

Dual stator-winding induction generator (DWIG) is one kind of emerging multiport electrical machine. It has become a promising direction in the last two decades, especially for stand-alone power systems and renewable energy power systems. This paper mainly focuses on the DWIG with similar-poles stator windings and cage-type rotor. An overview of DWIG and its system is given. Recent advances of this generator in system topologies, mathematical model, optimal design, control strategies, and performance analysis are presented. The developments and potential applications of the DWIG-based system are also discussed. [ABSTRACT FROM AUTHOR]

In this paper, the five-phase dual stator-winding induction generator dc generating system with the static excitation controller is presented, and two kinds of control strategies for this system are proposed. In this generator, the cage-type rotor is employed, and two sets of five-phase windings are placed in the stator, namely, the power winding and control winding. Using the instantaneous power theory, the control-winding-flux-oriented control (CWFOC) strategy without harmonic injection is obtained. To improve power density, the CWFOC with harmonic injection is proposed as well. For these two strategies, the detailed implementation is studied. The results (simulation and experiment) support the correctness and effectiveness of the proposed control strategies, and the corresponding results show that, using the CWFOC strategy with harmonic injection, the output power of this system can be improved by about 11%. [ABSTRACT FROM PUBLISHER]