Search

In xDSL systems, crosstalk can be separated into two categories, namely in-domain crosstalk and out-of-domain crosstalk. In-domain crosstalk is also refered to as self crosstalk. Out-of-domain crosstalk is crosstalk originating from outside the multi-pair system and is also denoted as external noise (alien crosstalk, radio frequency interference,…). While self crosstalk in itself can easily be canceled by a linear detector like the ZF detector, the presence of external noise requires a more advanced processing. Coordination between transmitters and receivers enables the self crosstalk and the external noise to be mitigated using MIMO signal processing, usually by means of a whitening filter and SVD. In this paper, we investigate the problem of finding the optimal power allocation in MIMO xDSL systems in the presence of self crosstalk and external noise. Optimal Tx/Rx structures and power allocation algorithms will be devised under practical limitations from xDSL systems, namely per-modem total power constraints and/or spectral mask constraints, leading to a generalized SVD-based transmission. Simulation results are given for bonded VDSL2 systems with external noise coming from ADSL2+ or VDSL2 disturbing lines, along with a comparison between algorithms with one-sided signal coordination either only at the transmit side or the receive side. [ABSTRACT FROM AUTHOR]

Crosstalk is the major source of performance degradation in VDSL. Several crosstalk cancelers have been proposed to address this. Unfortunately, they suffer from error propagation, high complexity, and long latency. This paper presents a simple, linear zero-forcing (ZF) crosstalk canceler. This design has a low complexity and no latency and does not suffer from error propagation. Furthermore, due to the well-conditioned structure of the VDSL channel matrix, the ZF design causes negligible noise enhancement. A lower bound on the performance of the linear ZF canceler is derived. This allows performance to be predicted without explicit knowledge of the crosstalk channels, which simplifies service provisioning considerably. This bound shows that the linear ZF canceler operates close to the single-user bound. Therefore, the linear ZF canceler is a low-complexity, low-latency design with predictable near-optimal performance. The combination of spectral optimization and crosstalk cancellation is also considered. Spectra optimization in a multiaccess channel generally involves a complex optimization problem. Since the linear ZF canceler decouples transmission on each line, the spectrum on each modem can be optimized independently, leading to a significant reduction in complexity. [ABSTRACT FROM AUTHOR]

Crosstalk is a major issue in modern digital subscriber line (DSL) systems such as ADSL and VDSL. Static spectrum management, which is the traditional way of ensuring spectral compatibility, employs spectral masks that can be overly conservative and lead to poor performance. This paper presents a centralized algorithm for optimal spectrum balancing in DSL. The algorithm uses the dual decomposition method to optimize spectra in an efficient and computationally tractable way. The algorithm shows significant performance gains over existing dynamis spectrum management (DSM) techniques, e.g., in one of the cases studied, the proposed centralized algorithm leads to a factor-of-four increase in data rate over the distributed DSM algorithm iterative waterfilling. [ABSTRACT FROM AUTHOR]

The classical discrete multitone receiver as used in, e.g., digital subscriber line (DSL) modems, combines a channel shortening time-domain equalizer (TEQ) with one-tap frequency-domain equalizers (FEQs). In a previous paper, the authors proposed a nonlinear bit rate maximizing (BM) TEQ design criterion and they have shown that the resulting BM-TEQ and the closely related BM per-group equalizers (PGEQs) approach the performance of the so-called per-tone equalizer (PTEQ). The PTEQ is an attractive alternative that provides a separate complex-valued equalizer for each active tone. In this paper, the authors show that the BM-TEQ and BM-PGEQ, despite their nonlinear cost criterion, can be designed adaptively, based on a recursive Levenberg-Marquardt algorithm. This adaptive BM-TEQIBM-PGEQ makes use of the same second-order statistics as the earlier presented recursive least-squares (RLS)-based adaptive PTEQ. A complete range of adaptive BM equalizers then opens up: the RLS-based adaptive PTEQ design is computationally efficient but involves a large number of equalizer taps; the adaptive BM-TEQ has a minimal number of equalizer taps at the expense of a larger design complexity; the adaptive BM-PGEQ has a similar design complexity as the BM-TEQ and an intermediate number of equalizer taps between the BM-TEQ and the PTEQ. These adaptive equalizers allow us to track variations of transmission channel and noise, which are typical of a DSL environment. [ABSTRACT FROM AUTHOR]

In discrete multitone (DMT) receivers, as for instance in asymmetric digital subscriber lines (ADSLs), the classical equalizer structure consists of a (real) time domain equalizer (TEQ) combined with complex 1-tap frequency domain equalizers (FEQs). Additionally, receiver windowing can be applied to mitigate the bad spectral containment of the demodulating DFT sidelobes. In this paper, we focus on a combined equalizer and windowing design procedure to maximize the achievable bit rate in DMT-based modems. Whereas the combination of a tEQ with a single window treats all the data carrying tones in a common way, the presented design method can also be used in a "per group" fashion, where smaller groups of tones receive each a different equalizer-window pair. When such groups contain only one single tone, the design procedure can be linked to the performance of an unbiased minimum mean square error (MMSE) per tone equalizer (PTEQ), which then also implicitly implements a per tone window. The general framework introduced in this paper allows us to treat equalizer-only and window-only designs as well, which appear as special cases in a natural way. This set of bit rate maximizing techniques can serve either as practical design methods or as upper bounds for existing (suboptimal) methods. We will also show that for the same achievable bit rate, equalizer taps can be exchanged for windowing coefficients to reduce complexity during data transmission. [ABSTRACT FROM AUTHOR]

Asymmetric digital subscriber lines (ADSLs) employ discrete multitone modulation (DMT) as transmission format, where subcarriers are assigned to the up- and/or downstream transmission direction. To separate up- and downstream signals, the ADSL standard allows the use of echo cancellation resulting in improved bit rates, reach, and/or noise margins. In DMT-based modems, typically, the mixed time/frequency (MTF) domain echo canceling scheme, as proposed by Ho et at, is implemented. This technique estimates the echo filter in the frequency domain using the least mean square (LMS) algorithm with the transmitted echo symbols as update directions. Since not every tone of the transmitted echo signal will carry data, i.e., will be excited, the MTF adaptation process does not lead to a good estimate for the echo channel, unless extra power on unused echo tones is transmitted. However, transmitting extra power on such tones is often undesired. In this paper, we present an alternative echo canceling scheme referred to as the circulant decomposition canceler (CDC), which works without extra power requirements and with comparable complexity as the method of Ho et al. Similar to MTF echo canceling, the CDC scheme can easily be incorporated into a multirate environment with different transmit and receive rates and can also cheaply be combined with per-tone equalization and double talk cancellation to allow fast tracking and/or convergence in the presence of a far-end signal. [ABSTRACT FROM AUTHOR]