Search

A significant amount of green power is being installed at the distribution level through the installation of green power generation facilities in the U.S. and Canada. This paper discusses green-power-generating sources (of 10 MW or less), which are connected to the utility system at the distribution level, and their impact on the distribution system. This paper also discusses the impact of smart grid and whether this new technology can solve some of the issues raised in this paper. Distribution circuits are designed to supply radial loads. Therefore, the introduction of green generation could mean redistribution of fault and load currents on the feeder circuit, overvoltage, and ferroresonance, plus a possible loss of protection system coordination—all of which can result in customer outages. This paper discusses these issues which are generally not well understood by many distribution protection engineers and can adversely affect distribution system reliability. [ABSTRACT FROM PUBLISHER]

Traditional connection of a generating station to the transmission grid typically requires either a new transmission line to an existing substation or building a new substation to segment an existing transmission line. Both of these options are capital intensive which often hurts economic viability especially small- or medium-size nonconventional generating stations. The direct connection to an existing transmission line, without the switching station, is the most economical solution to interconnect the generating station but it desensitizes the line protection and poses a risk to the ability of the protection to detect faults, particularly ground faults involving fault resistances. Multifunction relays, combined with communication-assisted schemes, now offer innovative solutions to overcome protection desensitization concerns. This paper describes these solutions which are successfully implemented by a large Canadian electric utility over the last two decades to tap connect numerous generators to the transmission grid. [ABSTRACT FROM PUBLISHER]

Canada-wide climate change plans have been put in place in the form of legislation and emission reduction programs. As part of these measures, reduced amounts of natural gas can be vented, incinerated, or flared. These programs have a direct impact on the Canadian oil and gas industry. Other measures mandate the decommissioning of high-emission thermal power plants, such as coal-fired generation. At the same time, governments are encouraging the wide-scale adoption of distributed energy resources (DERs). Because of these changes, natural gas fired DERs have been proliferating in oilfields to consume the byproduct natural gas and most major oil and gas companies are diversifying their portfolio to include generation assets. It is a more sustainable and environmentally friendly scenario as compared to the previous status quo. From an electric utility standpoint, this represents a change in paradigm, because distribution systems are traditionally planned to be radial and only experience power flowing from the substation to the load centers. This change requires utilities to adapt to new concerns and requirements, which span from operation to health and safety hazards. Among these, anti-islanding is likely the most important concern to allow the safe and reliable operation of a distribution system. The standard method to avoid unintended islanded operation is the direct transfer trip. Under exceptional circumstances, the utility may waive this requirement if an alternative acceptable method is in use. This article addresses existing anti-islanding schemes and covers in detail an alternative anti-islanding method native to many inverters. This article contains the philosophy of such method and measurement results captured during commissioning of a DER containing the scheme. Furthermore, this article highlights the evolution of inverter-based generator technologies and how the revision of applicable standards (IEEE 1547) can improve the reliable operation of such DERs. [ABSTRACT FROM AUTHOR]