Search

The use of HTS (high-temperature superconductor) coils for accelerator magnets decreases significantly the power consumption and operating cost. Therefore, a preliminary study was launched and a prototype of a dipole magnet with HTS coils has been designed and fabricated by NSRRC and HTS-110 Ltd. Although 2G YBCO wire is expected to be used in future HTS applications, it currently requires more joints to form the completed coils. For this reason, we chose 1G BSCCO wires for the HTS coils. Two single-stage pulse-tube refrigerators with one compressor serve to cool the HTS coils of the magnet, but we shall use LN2 to replace the pulse-tube refrigerators in the future. The HTS magnet is designed to provide a stable field of strength 1.19 T with field homogeneity better than 1.5\times 10^-4 in the range of the transverse direction -20\leq x\leq 20\ mm when it operates at 50 K with a current of 110 A. To compare with the field features of copper-coil dipole magnets, a Hall-probe measurement system was used to measure the detailed magnetic field and B-I characteristics of the HTS dipole magnet at NSRRC. [ABSTRACT FROM PUBLISHER]

A 130-pole superconducting undulator with NbTi wires was wound and tested at National Synchrotron Radiation Research Center (NSRRC). The magnetic field was measured with a cryogenic mini-Hall sensor in a vertical dewar. The difference of total length between the nominal design and that measured experimentally with the Hall probe is approximately 1.2 mm; this discrepancy arises from the thermal contribution during the field measurement in the test dewar. The reliability of the measurement system is confirmed, and is discussed in terms of the field-mapping spectrum. The measurement of the field strength revealed a non-uniform distribution of the field in the 1 m long arrays. An iron pole piece was used to shim the on-axis field strength of the undulators. We discuss the thermal effect of the measurement system, a useful shimming method and its results for the superconducting undulator. [ABSTRACT FROM AUTHOR]

A compact three-pole superconducting magnet with an aluminum warm beam duct was designed and fabricated as an X-ray source in a 1.5 GeV Taiwan Light Source (TLS) or the 3 GeV Taiwan Photon Source (TPS). Three pairs of racetrack NbTi superconducting coils were connected to one main power supply to create a central field of over 6.5 T. Two low current trim power supplies were connected in parallel to the two side pairs of the coil to eliminate the first and second field integrals. The wavelength shifter magnet was cooled in a pool boiling helium bath. Helium boils off at 1.3 L/hr. The vapor-cooled current lead is used to pass the 350 A excitation current. The magnetic field strength was measured at room temperature using a Hall probe and a stretched wire system. The magnet was tested successfully to 308 A, at which the central field exceeded 6.5 T, and the peak field on coil was 8.2 T. The design and construction of the magnet and the cryostat, the quenching protection, and field measurement results will be presented and discussed. [ABSTRACT FROM AUTHOR]