Search

A split dc-link dual-active-bridge (SDLDAB)-based multiport converter (MPC) is proposed in this article. The intended application of the SDLDAB converter is to interface two solar photovoltaic (PV) modules and a battery bank with a dc microgrid. Depending upon the prevailing atmospheric condition, these two solar PV modules can be operated at their maximum power points. This is achieved by maintaining appropriate voltages at the input terminals of the two PV modules. A high-frequency transformer is employed to provide high voltage gain between the dc microgrid and PV as well as battery ports. A direct power flow path is established between the solar PV modules and the battery without involving the transformer. The transformer current is minimized by appropriately modulating the switching sequence of the SDLDAB. Detailed simulation studies are carried out to predict the performance of the system. A laboratory prototype of the SDLDAB having 1-kW power rating is fabricated. The performance of the MPC is validated by carrying out detailed experimental studies on the developed prototype. [ABSTRACT FROM AUTHOR]

An optimized configuration of bidirectional Z-source circuit breaker using a coupled inductor is introduced for the fault isolation in low-voltage dc microgrid. The proposed circuit breaker is designed to operate with a single coupled inductor for bidirectional power flow. Use of the single coupled inductor for the power flow in both the directions reduces the component count. In this article, the operating principle of the breaker is explained for a short-circuit fault condition and breaker design criteria are derived. The performance of the circuit breaker is evaluated by carrying out a MATLAB simulation study. The functional prototype is developed to validate the breaker capabilities. Experimental results show that the fault is cleared within few microseconds. Additionally, the breaker is tested under the step load change condition for a current five times the steady-state rated current of the breaker and results are satisfactory. [ABSTRACT FROM AUTHOR]

A single-stage, bidirectional, current-source converter (CSC) topology to interface a dc microgrid with an ac grid is reported in the literature. In this topology, under a balanced grid voltage condition, the dc-link inductor current can be regulated over a wide range—from zero to rated value—while the ac-side current has low harmonic distortion. However, unbalanced grid voltages result in second-harmonic pulsation in the current and power on the dc side of the converter. In addition, the ac-side currents will be unbalanced due to the presence of a negative-sequence component. This would result in undesired tripping of the converter if one of the phase currents exceeded its rated value. Various control loop structures for the operation of voltage-source converter under unbalanced grid voltage conditions are reported in the literature. However, use of similar control loop structures for CSC may lead to unstable operation. Therefore, a control scheme to inject balanced three-phase currents into the ac grid under an unbalanced grid voltage condition is proposed in this paper. The stability of the proposed control scheme is studied using a small-signal model of the converter. Performance of the proposed control scheme is studied using MATLAB/Simulink and is experimentally validated. [ABSTRACT FROM AUTHOR]