Search

In recent years, modular multilevel converter (MMC) is considered for medium-voltage variable speed drives (VSD) due to its modularity and higher reliability. However, the major drawback of the MMC-based VSD is the higher capacitor ripple voltage at lower operating speeds. In literature, this ripple voltage is reduced by injecting a high-frequency circulating current into each arm. This additional circulating current increases the overall current rating of the devices, inductors, and capacitors. Alternatively, the capacitor ripple voltage can be reduced at the lower output frequency by reducing the dc-bus voltage. This paper proposes a new configuration using a multipulse diode-bridge rectifier to reduce the dc-bus voltage when the drive is operated at lower speeds. Therefore, the capacitor ripple voltage decreases without injecting any circulating current. In addition, a new technique is proposed to maintain the peak-to-peak value of the submodule capacitor ripple voltage constant at near-zero speed. The proposed converter with 24-pulse rectifier configuration is simulated in MATLAB/Simulink, and the experimental validation is carried out on a prototype with 12-pulse rectifier. [ABSTRACT FROM AUTHOR]

Axial flux-segmented rotor-switched reluctance motor (SSRM) topology could be a potential candidate for in-wheel electric vehicle application. This topology has the advantage of the increased active surface area for the torque production as compared to the radial flux SSRM for a given volume. To improve the performance of axial flux SSRM (AFSSRM), various stator slot/rotor segment combinations and winding polarities are studied. It is observed that the torque ripple is high for the designed three-phase, 12/8 pole AFSSRM. Therefore, the influence of the stator pole and rotor segment arc angles on the average torque and the torque ripple is studied. In addition, the adjacent rotor segments are displaced with respect to the stator, to reduce the torque dips in the phase commutation region. The proposed arrangement is analyzed using the quasi-3-D finite-element method-based simulation study and it is found that the torque ripple can be reduced by 38%. Furthermore, the low-frequency harmonic content in the torque output is analyzed and compared. The variation of the axial electromagnetic attractive force with displaced rotor segments is discussed. The effectiveness of the proposed technique is verified experimentally. [ABSTRACT FROM PUBLISHER]

Motors for in-wheel electric vehicle application should have high specific torque. In addition, these motors should be rugged, insensitive to vibration, and temperature variation. Therefore, segmented rotor switched reluctance motor (SSRM) could be an attractive alternative to permanent magnet-based motors, which are being used for this application. A limitation of SSRM is that it requires full pitch winding for its operation. Since, in-wheel motors have high diameter to axial length (D/L) ratio, SSRM of these dimensions would be bulky and has high copper loss due to full pitch winding. Hence, in this paper, a novel SSRM with nonoverlapping winding is proposed. This motor is an axial flux SSRM (AFSSRM) with toroidal winding arrangement. It has single-stator, dual-rotor configuration with 12 stator poles and 16 rotor segments on each rotor disc. Design procedure for AFSSRM is developed and a flowchart describing the design algorithm is presented. A finite element method-based simulation is carried out to verify the performance of the proposed AFSSRM. In order to validate the performance of the motor, a prototype is fabricated and experimental results are presented. [ABSTRACT FROM AUTHOR]