Search

In some conditions, the flux in the core of current transformers (CT) increases. If this increase in flux leads to saturation of the protective core, it can create a lot of problems in power system protection. One of the hardware solutions to prevent the occurrence of core saturation in CT is the fixed switched resistor demagnetization method. Due to disadvantages such as dependence on CT parameters and inefficiencies in severe core saturation, the use of this method has not been expanded. This paper proposes a new method to improve the fixed switched resistor demagnetization method. In the proposed method, instead of using a fixed resistor in the circuit topology, an adjustable resistor with an auxiliary transformer is used. In the previous method, the control process is based on flux estimation from the secondary terminal voltage. The control process in the proposed method is based on the second derivative of CT secondary current. To verify the effectiveness of the suggested method, first simulation is done using COMSOL and MATLAB softwares and then all necessary electronic and control circuitry are designed and built. Experimental test is carried out on a 20 kV- 500/5 A CT. The simulation and experimental results show that this method prevents the CT from saturation in case of short circuit faults. The main advantages of this method are independent to CT parameters and efficient in severe core saturation. [ABSTRACT FROM AUTHOR]

In helical flux compression generators, the ohmic and intrinsic flux losses limit severely the performance of them. One of the sources of intrinsic flux losses is the turn skipping flux loss. This paper first introduces an accurate criterion for the prevention of the turn skipping phenomenon in these generators. Then, a novel method is presented to calculate the flux loss due to this phenomenon. In addition, an equivalent resistance is introduced to consider the effect of turn skipping flux loss on the generator performance. The calculation results show that, as soon as the turn skipping occurs, about 30% of a turn flux is lost and this value is increased rapidly with eccentricity increasing. Therefore, it is necessary to prevent this phenomenon as far as possible. The calculated output current of the simulated generator also shows that the maximum current when considering the turn skipping loss is about 15% of the maximum current in the case of ignoring it. Based on the authors' knowledge, quantification of the turn skipping flux losses has not been presented previously in the open literature. [ABSTRACT FROM PUBLISHER]