Search

Dielectric barrier discharges (DBDs) driven by nanosecond high-voltage pulses can be quite different from those driven by alternating current (ac) sources, on both electrical characteristics and plasma microparameters. In this article, the power measurement strategy in nanosecond pulsed coaxial DBDs is optimized. The effect of different experimental parameters on energy deposition and reduced electric field in plasma is investigated. First, the results measured using the instantaneous power (from the production of voltage and current) method and that using the v – q trace (Lissajous curve) method are compared and the source of divergence is analyzed. By comparing monitor capacitors with different materials and capacitances, it is demonstrated that the high-frequency response of the monitor capacitor is essential and the capacitance value can be adjusted according to the applied voltage, taking both the dynamic range of oscilloscope and the signal-to-noise ratio into consideration. Second, the influence of morphology of ground electrode, voltage rising time, and pulse width on energy deposition per-pulse and reduced electric field, obtained from the nitrogen spectral line-ratio, is studied. It is found that the copper foil promotes the discharge energy coupling per-pulse compared with the copper grid, while the reduced electric field obtained from the nitrogen line-ratio with the copper foil is weaker. A shorter rising time will also enhance the energy coupling per-pulse, as well as the reduced electric field. [ABSTRACT FROM AUTHOR]

The plasma produced by a pulsed generator is an efficient tool for an airflow control. In this paper, a nanosecond pulsed generator constructed with a fast solid-state switch is designed for triggering synchronous discharges in plasma synthetic jet (PSJ) actuators connected in series. The generator delivers high-voltage pulses with a peak voltage varying from 0 to 20 kV, a rise time of 20 ns, a full-width at half-maximum of 200 ns, and a wide range of pulse-repetition rate varying from 0 to 5.5 kHz. It is proved that this generator is able to trigger synchronous discharges in three PSJ actuators in atmospheric air with a peak discharge current more than 90 A and a deposited energy per pulse of 39 mJ. A schlieren system is used to observe the airflow dynamics, which shows the high synchronization among the three PSJ actuators with a time triggering delay of about 20 ns. The synchronous operation of three PSJ actuators produces a plasma jet with a maximum velocity of 60 m/s and a precursor wave with a velocity of 350 m/s. [ABSTRACT FROM AUTHOR]