Search

Safety is the most important issue in the development of nuclear energy. This paper reports experimental studies of a thermoelectric energy harvesting system designed for integration in a nuclear power plant capable of performing in radiation rich environments and producing enough power to run wireless sensors meant to increase plant safety. Furthermore, the system, which utilizes wasted heat present in coolant system piping, has the unique ability to provide power in both normal and accidental situations, to run the sensors without the need for external power. Two energy harvesting prototypes were designed utilizing a heat pipe for heat transfer. The first can supply a maximum power of 2.25 W using two Bi2Te3 thermoelectric modules of 2.79cm (1.1'') \times 2.79 cm (1.1”), in a source temperature near 250 °C. A second design was put forward to extend the application in higher-temperature primary loops, in which one PbTe-Bi2Te3 hybrid TEG module of 5.6cm (2.2'') \times 5.6 cm (2.2”) can provide a power of 3.0 W when the hot side temperature reaches 340 °C. In addition to the energy harvester, wireless communication circuits were developed along with an integrated power management circuit for wireless data transmission. A high intensity gamma radiation experiment was conducted during which each component was irradiated. A total dose of 200 kGy±10% (20M rads) was applied to the first prototype in order to approximate the expected lifetime accumulation for one implemented thermoelectric generator. Results showed that thermoelectric modules used in the prototype had no reduction in voltage output throughout irradiation. Throughout the experiment the harvester system witnessed a small voltage drop in open circuit voltage attributed to a reduction in heat pipe performance from radiation exposure. We also acquired a baseline radiation survivability level for non-hardened, non-shielded electronics of 10^2 Gy. [ABSTRACT FROM PUBLISHER]

This paper addresses the need for self-consistent simulation of mixed electrical and optical circuits and systems. Drawing on the use of modified nodal analysis (MNA) techniques ubiquitous in circuit simulation, an optical node is formulated which includes the magnitude and phase of the optical signal being simulated. This node consists of two propagating complex envelopes one for the forward direction and the other for the reverse direction. Using this formulation models are developed for a variety of devices including: lasers, photodiodes, multimode fiber, and optical connectors. The formulation allows for definition of multiple optical channels at different carrier frequencies, enables quick simulation of systems with large optical delays and optical interference effects. Several numerical examples are presented in this paper to illustrate the capability of the proposed framework and where practicable the results were compared to commercial simulators. These examples include a multimode fiber optical link, an integrated array of laser sources and a feedback controlled laser source used in a optical link with modulation achieved by the use of an electro-absorption device. [ABSTRACT FROM AUTHOR]