Search

In this paper, typical strengths, fault levels, and source impedances are thoroughly analyzed and calculated for the study of quality of supply in 230/400 V 50 Hz distribution systems. Considering all the disparity in distribution network design, this study is based on a comprehensive database containing typical arrangements and equipment in U.K./European systems, as well as on fully documented generic network models supplying four residential load subsectors in the U.K., i.e., from metropolitan to rural areas. Thus, this paper proposes an alternative method for determining reference values of network supply impedances and short-circuit fault levels at different points and locations of the medium-to-low voltage distribution system. The aim of this study is to provide a wider range of benchmark values than those stipulated in the IEC 60725 Standard, which only defines a single-reference threshold of public supply impedances for all types of distribution systems and residential customers. In order to assist network operators in the planning and design of their distribution systems, these values are further disaggregated and classified in this paper according to network/demand type.

This paper applies optimal power flow (OPF) to evaluate and maximize network benefits of demand-side management (DSM). The benefits are quantified in terms of the ability of demand-responsive loads to relieve upstream network constraints and provide ancillary services, such as operating reserve. The study incorporates detailed information on the load structure and composition, and allows the potential network benefits, which could be obtained through management of different load types, to be quantified and compared. It is demonstrated that the actual network location of demand-manageable load has an important influence on the effectiveness of the applied DSM scheme, since the characteristics of the loads and their interconnecting networks vary from one location to another. Consequently, some network locations are more favorable for implementation of DSM, and OPF can be applied to determine the optimal allocation of demand-side resources. The effectiveness of the presented approach is assessed using a time-sequential OPF applied to typical radial and meshed U.K. distribution networks. The results of the analysis suggest that network operators could not just participate in, but also encourage and add value to the implementation of specific DSM schemes at the optimum network locations in order to maximize the total benefit from DSM.

This paper addresses some general issues related to the difficulties and uncertainties during the assessment and characterization of micro and small-scale wind-based generation in urban areas. This paper proposes four generic wind turbine models, which could be used for the analysis and selection of optimal wind turbines in target applications, as they accurately represent the range of wind turbines currently available on the market. The analysis in this paper compares results for the expected annual energy outputs and cost-benefit analysis obtained using steady state and dynamic wind turbine models of actual and generic micro/small wind turbines, applying both low-resolution and high-resolution measurements of available wind energy resources. The presented results demonstrate the significance of the accurate assessment of wind resources in urban areas, as well as the importance of the correct modeling of wind turbine characteristics. It is shown that substantial errors, typically overestimating wind turbine performance, are obtained if standard assumptions and current recommendations are used for the analysis of wind turbine performance.