Search

A method for cross-sectional doping of individual Si/SiO 2 core/shell nanowires (NWs) is presented. P and B atoms are laterally implanted at different depths in the Si core. The healing of the implantation-related damage together with the electrical activation of the dopants takes place via solid phase epitaxy driven by millisecond-range flash lamp annealing. Electrical measurements through a bevel formed along the NW enabled us to demonstrate the concurrent formation of n- and p-type regions in individual Si/SiO 2 core/shell NWs. These results might pave the way for ion beam doping of nanostructured semiconductors produced by using either top-down or bottom-up approaches.

The effect of the oxide barrier thickness (tSiO2) reduction and the Si excess ([Si]exc) increase on the electrical and electroluminescence (EL) properties of Si-rich oxynitride (SRON)/SiO2 superlattices (SLs) is investigated. The active layers of the metal-oxide-semiconductor devices were fabricated by alternated deposition of SRON and SiO2 layers on top of a Si substrate. The precipitation of the Si excess and thus formation of Si nanocrystals (NCs) within the SRON layers was achieved after an annealing treatment at 1150 °C. A structural characterization revealed a high crystalline quality of the SLs for all devices, and the evaluated NC crystalline size is in agreement with a good deposition and annealing control. We found a dramatic conductivity enhancement when the Si content is increased or the SiO2 barrier thickness is decreased, due to a larger interaction of the carrier wavefunctions from adjacent layers. EL recombination dynamics were studied, revealing radiative recombination decay times of the order of tens of microseconds. Lower lifetimes were found at higher [Si]exc, attributed to exciton confinement delocalization, whereas intermediate barrier thicknesses present the slowest decay. The electrical-to-light conversion efficiency increases monotonously at thicker barriers and smaller Si contents. We ascribe these effects mainly to free carriers, which enhance carrier transport through the SLs while strongly quenching light emission. Finally, the combination of the different results led us to conclude that tSiO2 ∼ 2 nm and [Si]exc from 12 to 15 at% are the ideal structure parameters for a balanced electro-optical response of Si NC-based SLs.

Amorphous sub-nanometre Tb-doped SiOxNy/SiO2 superlattices were fabricated by means of alternating deposition of 0.7 nm thick Tb-doped SiOxNy layers and of 0.9 nm thick SiO2 barrier layers in an electron-cyclotron-resonance plasma enhanced chemical vapour deposition system with in situ Tb-doping capability. High resolution transmission electron microscopy images showed a well-preserved superlattice morphology after annealing at a high temperature of 1000 °C. In addition, transparent indium tin oxide (ITO) electrodes were deposited by electron beam evaporation using a shadow mask approach to allow for the optoelectronic characterization of superlattices. Tb(3+) luminescent spectral features were obtained using three different excitation sources: UV laser excitation (photoluminescence (PL)), under a bias voltage (electroluminescence (EL)) and under a highly energetic electron beam (cathodoluminescence (CL)). All techniques displayed Tb(3+) inner transitions belonging to (5)D4 levels except for the CL spectrum, in which (5)D3 transition levels were also observed. Two competing mechanisms were proposed to explain the spectral differences observed between PL (or EL) and CL excitation: the population rate of the (5)D3 state and the non-radiative relaxation rate of the (5)D3-(5)D4 transition due to a resonant OH-mode. Moreover, the large number of interfaces (trapping sites) that electrons have to get through was identified as the main reason for observing a bulk-limited charge transport mechanism governed by Poole-Frenkel conduction in the J-V characteristic. Finally, a linear EL-J dependence was measured, with independent spectral shape and an EL onset voltage as low as 6.7 V. These amorphous sub-nanometre superlattices are meant to provide low-cost solutions in different areas including sensing, photovoltaics or photonics.

An integrated erbium-based light emitting diode has been realized in a waveguide configuration allowing 1.54 μm light signal routing in silicon photonic circuits. This injection device is based on an asymmetric horizontal slot waveguide where the active slot material is Er(3+) in SiO2 or Er(3+) in Si-rich oxide. The active horizontal slot waveguide allows optical confinement, guiding and lateral extraction of the light for on-chip distribution. Light is then coupled through a taper section to a passive Si waveguide terminated by a grating which extracts (or inserts) the light signal for measuring purposes. We measured an optical power density in the range of tens of μW/cm(2) which follows a super-linear dependence on injected current density. When the device is biased at high current density, upon a voltage pulse (pump signal), free-carrier and space charge absorption losses become large, attenuating a probe signal by more than 60 dB/cm and thus behaving conceptually as an electro-optical modulator. The integrated device reported here is the first example, still to be optimized, of a fundamental block to realize an integrated silicon photonic circuit with monolithic integration of the light emitter.

The electroluminescence (EL) at 1.54 μm of metal–oxide–semiconductor (MOS) devices withEr3C ions embedded in the silicon-rich silicon oxide (SRSO) layer has been investigated under different polarization conditions and compared with that of erbium doped SiO2 layers. EL time-resolved measurements allowed us to distinguish between two different excitation mechanisms responsible for the Er3C emission under an alternate pulsed voltage signal (APV). Energy transfer from silicon nanoclusters (Si-ncs) to Er3C is clearly observed at low-field APV excitation. We demonstrate that sequential electron and hole injection at the edges of the pulses creates excited states in Si-ncs which upon recombination transfer their energy to Er3C ions. On the contrary, direct impact excitation of Er3C by hot injected carriers starts at the Fowler–Nordheim injection threshold (above 5 MV cm(-1)) and dominates for high-field APV excitation.