Search

A wideband MMIC power amplifier at W-band is reported in this letter. The four-stage MMIC, developed using 0.1 μm GaAs pseudomorphic HEMT (PHEMT) technology, demonstrated a flat small signal gain of 12.4 ± 2 dB with a minimum saturated output power (Psat) of 14.2 dBm from 77 to 100 GHz. The typical Psat is better by 16.3 dBm with a flatness of 0.4 dB and the maximum power added efficiency is 6% between 77 and 92 GHz. This result shows that the amplifier delivers output power density of about 470 mW/mm with a total gate output periphery of 100 μm. As far as we know, it is nearly the best power density performance ever published from a single ended GaAs-based PHEMT MMIC at this frequency band.

Two broadband detectors at W-band and D-band are analyzed and designed with low barrier Schottky diodes. The input circuit of the detectors is realized by low and high impedance microstrip lines, and their output circuit is composed of a radio frequency (RF) bandstop filter and a tuning line for optimum reflection phase of the RF signal. S-parameters of the complete circuit are exported to a circuit simulator for voltage sensitivity analysis. For the W band detectors, the highest measured voltage sensitivity is 11800 mV/mW at 100 GHz, and the sensitivity is higher than 2000 mV/mW in 80–104 GHz. Measured tangential sensitivity (TSS) is higher than —38 dBm, and its linearity is superior than 0.99992 at 95 GHz. For the D band detector, the highest measured voltage sensitivity is 1600 mV/mW, and the typical sensitivity is 600 mV/mW in 110–170 GHz. TSS is higher than −29 dBm, and its linearity is superior than 0.99961 at 150 GHz.

W-band quartz based high output power fix-tuned doublers are analyzed and designed with planar Schottky diodes. Full-wave analysis is carried out to find diode embedding impedances with a lumped port to model the nonlinear junction. Passive networks of the circuit, such as the low pass filter, the E-plane waveguide to strip transitions, input and output matching networks, and passive diode parts are analyzed by using electromagnetic simulators, and the different parts are then combined and optimized together. The exported S-parameters of the doubler circuit are used for multiply efficiency analysis. The highest measured output power is 29.5 mW at 80 GHz and higher than 15 mW in 76–94 GHz. The highest measured efficiency is 11.5% at 92.5 GHz, and the typical value is 6.0% in 70–100 GHz.