Search

The partial discharge inception voltage (PDIV) of low-voltage induction motor turn-turn insulation analogy is investigated for variable relative humidity (RH) of the surrounding air (temperature and pressure are kept constant close to their ambient values). Three materials, perfluoralkoxy alkane, sealed and unsealed alumina (UA), are employed as the dielectric coating (insulation) of test samples. Each material's dielectric properties change differently with RH—of these, relative permittivity is regarded as the most crucial, as it was previously proven to be, along with the coating's thickness, the key factor in determining the PDIV in dry air conditions. To further vary the value of permittivity and thus provide larger data sets for the verification study, the frequency of the excitation voltage is also varied between 1 Hz and 50 kHz. The obtained experimental data are compared against the PDIV predictions obtained by a breakdown model based on the reduced thickness of the coating (ratio of the coating thickness to its relative permittivity). Satisfying agreement between the measured and predicted PDIV are obtained for the first two materials, whereas significant discrepancies are seen for the UA material. For this case, surface conductivity is introduced into the prediction model and much better fits to the experimental data are obtained for a suitable value of surface resistance. It is hence demonstrated that the model is able to satisfactorily predict the PDIV for three substantially different materials when the RH of the surrounding air is varied between 10 % – 80 % . [ABSTRACT FROM AUTHOR]

A pressure scaling law for the partial discharge inception voltage (PDIV) of wedge-shaped, dielectric-bounded gas gaps is derived and experimentally validated. The investigated prototypical electrode geometry is of relevance in a number of practical applications, such as contacting enameled wires in electric motors or transformers. The derived pressure scaling law is of particular interest for electric propulsion in aviation systems. The results show that the PDIV can be accurately parametrized from first principles as a function of the scaling parameter p ⋅ s / ε r , where p is the gas pressure, s is the thickness of the insulating coating and ɛ r its relative dielectric permittivity. Previously published empirical relationships between the PDIV and pressure are shown to be local approximations of the presented general scaling law. In particular, the often assumed linear relation of PDIV with pressure is shown to not be generally valid. [ABSTRACT FROM AUTHOR]

A positive synergy in the electric strength was observed in a previous study in SF6/HFO1234ze(E) mixtures which was shown to result from a strong electron energy moderation capability of HFO1234ze(E) combined with thermal electron attachment of SF6 (Egüz et al 2022 J. Phys. D: Appl. Phys. 55 315203). In the present work, the electron energy moderation properties of compounds with a similar C=C−C backbone are investigated. Swarm and breakdown measurements are performed in pure gases and in mixtures with SF6. Compounds with a trifluoromethyl group (−CF3) showed lower characteristic energy and as a consequence a positive synergism with SF6. Descriptors related to electron energy moderation are identified and computed; a clear trend is found from the analysis of descriptors related to inelastic processes which suggest(s) that vibrational excitations may be the main source of electron energy loss in the compounds showing positive synergy. [ABSTRACT FROM AUTHOR]