Search

This article presents a method for assessing the radionuclide surface contamination density (SCD) on open sites and in premises of a radiation hazardous facility based on measurements of the ambient dose equivalent rate (ADER). The method is intended for use at the initial stage of the assessment of the radiation environment at facilities. The assessed SCD at a given location on the surface can differ from the directly measured SCD at that location, since sources located on the surface and distributed by the depth contribute to the ADER value. The method makes it possible to estimate SCD with reasonable accuracy without increasing the number of measurements, and thus avoid additional occupational exposure and the use of additional resources. SCD and ADER as spatial variables have different support of measurement data. For ADER, measured at a height of 1 m, the support of measurement data can be taken to be a circle in the centre of which a gamma-ray detector is located, with a radius of several tens of meters. In contrast, SCD has the support of measurement data, close to the overall dimensions of the beta detector (100 cm2). To solve the problem of SCD calculation on the basis of ADER measurements, the method of conversion coefficients (MCC) is usually applied, based on the use of conversion factors; however, this method provides an adequate estimate only under conditions of an SCD with low gradient over the surface. The method proposed in this article is applicable for an arbitrary distribution of SCD, and designed to deal with heterogeneous contamination patterns. The developed method is based on the numerical solution of the Fredholm equation of the first kind. The measurement data always contain an error, therefore, the task of the SCD calculation is an ill-posed problem, and the Tikhonov regularisation method (ridge regression) was used to solve it. The article presents the method developed and examples of use. Validation of the method was performed using 38 measurements of the radioactive contamination from 137Cs in soil. It is shown that the method proposed in the article demonstrates a significant superiority in comparison with the MCC method, because it allows more accurate localisation of areas contaminated with radionuclides and is applicable for an arbitrary distribution of SCD.

Radiation doses received by workers during their movement within areas contaminated as a result of events and activities, leading to emergency or existing exposure situations, may provide a substantial contribution to total external exposure during remediation work. This paper describes an approach to minimise worker external exposure in these circumstances, based on graph theory. The paper describes several tasks, including: searching for a route with the lowest dose, searching for an optimal bypass with a given set of control points and searching for the optimal road network coverage. Classical graph theory algorithms have been used (Dijkstra's algorithm, Chinese postman problem and travelling salesman problem). Algorithms for solving the above mentioned problems have been developed and were included in the information-analytical system for radiation safety. This software has been applied for optimisation of protection during remediation work at the Andreeva Bay site of temporary storage for spent fuel and radioactive waste in the Kola Peninsula, both in the context of existing exposure situations and improving the preparedness for emergency exposure situations.

Andreeva Bay in northwest Russia hosts one of the former coastal technical bases of the Northern Fleet. Currently, this base is designated as the Andreeva Bay branch of Northwest Center for Radioactive Waste Management (SevRAO) and is a site of temporary storage (STS) for spent nuclear fuel (SNF) and other radiological waste generated during the operation and decommissioning of nuclear submarines and ships. According to an integrated expert evaluation, this site is the most dangerous nuclear facility in northwest Russia. Environmental rehabilitation of the site is currently in progress and is supported by strong international collaboration. This paper describes how the optimization principle (ALARA) has been adopted during the planning of remediation work at the Andreeva Bay STS and how Russian-Norwegian collaboration greatly contributed to ensuring the development and maintenance of a high level safety culture during this process. More specifically, this paper describes how integration of a system, specifically designed for improving the radiological safety of workers during the remediation work at Andreeva Bay, was developed in Russia. It also outlines the 3D radiological simulation and virtual reality based systems developed in Norway that have greatly facilitated effective implementation of the ALARA principle, through supporting radiological characterisation, work planning and optimization, decision making, communication between teams and with the authorities and training of field operators.