Search

Proceedings of the 7th International Particle Accelerator Conference, IPAC'16, Busan, Korea, 9 May 2016 - 13 May 2016; JACoW, Geneva, Switzerland 3 pp. (2016). doi:10.18429/JACoW-IPAC2016-WEPOR060, We want to summarize the beam line stabilization application with MTCA.4 electronics. Presented solution is based on the compact 2U MTCA.4 crate integrating sensor and actuator cards. The optical beam position sensor is based on quadrupole SI PIN photodiode connected to low cost AMC based FMC carrier equipped with ADC card. The optical beam position correction is done using picomotorized stages equipped with active piezo elements and high voltage RTM piezo driver. The data processing and digital feedback units are implemented using Spartan 6 FPGA. The control algorithm has been optimized for low latency and high precision computations. The control electronics performance has been tested using single beam line test stand consisted of commercial laser diode drivers, supported optics and motorized stages. The first results are demonstrated and future possible applications are briefly discussed., Published by JACoW, Geneva, Switzerland

The program of low charge mode of operation is under development at free electron laser FLASH aiming in single mode radiation pulses. A short pulse photoinjector laser has been installed at FLASH allowing production of ultrashort electron pluses with moderate compression factor of the beam formation system. Here we present pilot results of free electron laser FLASH operating at the wavelength of 13.1 nm and driven by 70 pC electron bunches. Relevant theoretical analysis has been performed showing good agreement with experimental results., Proceedings of the 7th Int. Particle Accelerator Conf., IPAC2016, Busan, Korea

A new compact versatile linear accelerator named FLUTE (Ferninfrarot Linac Und Test Experiment) is currently under construction at the Karlsruhe Institute of Technology (KIT). It will serve as an accelerator test facility and allow conducting a variety of accelerator physics studies. In addition, it will be used to generate intense, ultra-short THz pulses for photon science experiments. FLUTE consists of a ~7 MeV photo-injector gun, a ~41 MeV S-band linac and a D-shaped chicane to compress bunches to a few femtoseconds. This contribution presents an overview of the project status and the accompanying simulation studies., Proceedings of the 6th Int. Particle Accelerator Conf., IPAC2015, Richmond, VA, USA

High voltage RTM Piezo Driver has been developed to support special diagnostic applications foreseen for XFEL facility. The RTM is capable of driving 4 piezo actuators with voltages up to ±80 V. The solid-state power amplifiers are driven using 18-bit DACs and sampling rates of 1 MSPS. The bandwidth of the driver is remotely tunable using programmable low pass filters. The 4-channel Piezo Driver unit provides the information of piezo output voltage and current. Three independent test setups have been built to test 4-channel Piezo Driver performance. In the paper we are presenting EOD laser lock to 1.3 GHz FLASH master oscillator using bipolar piezo stretcher (fine tuning). The piezo motor based course tuning has been applied for the long term laser stability measurements. The unipolar piezo actuator operation has been demonstrated for the Origami Onefive laser locked to 1.3 GHz LAB MO. The preliminary results of active stabilization of 3 km fiber link laboratory setup are shown., Proceedings of the 6th Int. Particle Accelerator Conf., IPAC2015, Richmond, VA, USA

A MicroTCA.4 (MTCA.4) compliant Piezo Driver (DRTM-PZT4)* has been developed to drive piezoelectric-based actuators used in accelerator instrumentation applications. More specifically, it is used for superconducting cavities fine tuning, synchronization of pulsed lasers and stabilization of fiber links. This paper briefly presents the designed system requirements and discusses the main hardware issues. The Piezo Driver performance measurements are also discussed. The first results of the prototype hardware usage for laser locking** to an external RF source and fiber link stabilization are summarized., Proceedings of the 5th Int. Particle Accelerator Conf., IPAC2014, Dresden, Germany

A new compact linear accelerator FLUTE is currently under construction at Karlsruhe Institute of Technology (KIT) in collaboration with DESY and PSI. It aims at obtaining femtosecond electron bunches (~1fs - 300 fs) with a wide charge range (1 pC - 3 nC) and requires a precise bunch length diagnostic system. Here we present the layout of a bunch length monitor based on the electro-optic technique of spectral decoding using an Yb-doped fiber laser system (central wavelength 1030 nm) and a GaP crystal. Simulations of the electro-optic signal for different operation modes of FLUTE were performed and main challenges are discussed in this talk. This work is funded by the European Union under contract PITN-GA-2011-289191, Proceedings of the 5th Int. Particle Accelerator Conf., IPAC2014, Dresden, Germany