Search

High-performance overmodulation strategies for voltage source inverters (VSIs) can further broaden the operation range of machines. Among them, Space Vector Pulse Width Modulation (SVPWM) is worth researching as it performs well in digital implementation. This paper presents a detailed comparison of various SVPWM overmodulation strategies and analysis of their performance. It firstly briefly elaborates fundamental laws of two subspaces of five-phase VSIs. Then, it focuses on several overmodulation strategies. Their corresponding basic principles and main characteristics are researched, and conclusions are given. In addition, differences and relationships between them are proved and summarized. Lastly, comparative simulations and experiments were carried out and verify that in the overmodulation region, the output voltage distortion degree increases with the increase in modulation ratio, and strategies with more control degrees of freedom (CDFs) are capable of better controlling the third harmonic subspace, which means that higher-quality output voltage waveforms would be obtained. [ABSTRACT FROM AUTHOR]

This paper studies a method for high-precision acquisition of position signals for permanent magnet direct drive servo motors at low speed. First of all, the problem of poor position feedback accuracy and sensor feedback delay in the low-speed operation of the permanent magnet direct drive servo motor is analyzed. Secondly, through analysis and simulation, it is found that the interpolation method can play a certain role in compensating the rotor position signal. However, when the speed is close to 0, the output signal of the sensor will fluctuate in a short time, which will affect the speed control accuracy. Therefore, this paper uses the observer method to achieve high-precision acquisition of the position signal of the permanent magnet direct drive servo motor at low speed. The observer method adopts the idea of combining the system model and closed-loop control. Additionally, it makes full use of the parameter information of the motor system. The control performance of the motor can be better guaranteed through the design of the observer parameters and the accuracy of the rotor position estimation result has been greatly improved. Finally, an experimental platform for permanent magnet direct drive servo motors is built, and the rotor position signal acquisition method based on the observer method is verified to have good performance through simulation and experiments. Not only the accuracy of the rotor position estimation result is improved, but also the motor control performance is improved, realizing the stable operation of the permanent magnet direct drive servo motor at low speed. [ABSTRACT FROM AUTHOR]

Direct power control (DPC) has gained increasing attention in recent years as a simple and efficient control strategy for pulse width modulation (PWM) rectifiers. In this paper, the idea of DPC is introduced into the three-phase coupled inductor-based bipolar-output active rectifier (TCIBAR) for the first time, and a virtual vector-based direct power control (VVB-DPC) strategy is proposed for TCIBAR to realize the bipolar DC power supply for more electric aircraft (MEA). First, the mathematical model of the TCIBAR is deduced, and the basic principle of the classic DPC strategy is reviewed. On this basis, the limitations of the classic DPC strategy in TCIBAR control are analyzed. Second, a set of virtual vectors are derived to establish a novel virtual-vector switching table. Based on the virtual-vector switching table, the hysteresis power control of TCIBAR can be realized without affecting the DC-side neutral-point potential of TCIBAR. Finally, a neutral-point potential control method based on DPC architecture is studied and integrated into the VVB-DPC strategy to maintain the bipolar DC voltage balance of TCIBAR under unbalanced load conditions. The VVB-DPC strategy is experimentally studied on a TCIBAR prototype, and the experimental results verify the feasibility and effectiveness of the proposed strategy. [ABSTRACT FROM AUTHOR]

This paper presents a novel direct power control (DPC) strategy based on an optimized sector division for a three-phase coupled inductor-based bipolar output active rectifier (TCIBAR) applied in more electric aircraft (MEA). First, based on the instantaneous power theory, the power model of the TCIBAR is built in the synchronous rotating coordinate system. Second, to implement the hysteresis power control of TCIBAR without causing the runaway of the zero-sequence current in the three-phase coupled inductor (TCI), a set of new voltage vectors that have the same zero-sequence voltage (ZSV) component are synthesized and adopted in the proposed DPC strategy. Third, by quantitatively analyzing the effect of the new synthesized voltage vectors on the power variation of TCIBAR, an optimized sector division method is proposed to improve the accuracy of power control and reduce the phase current harmonics in TCIBAR. Finally, to maintain the voltage balance of the bipolar dc ports in TCIBAR, voltage balance control is studied in the proposed DPC strategy. The proposed DPC strategy is researched on an experimental platform of TCIBAR, and the results show that the proposed DPC strategy is feasible and has good static and dynamic performance. [ABSTRACT FROM AUTHOR]