Search

The energy loss inside a centrifugal pump has a significant effect on its performance characteristics. Based on the structural characteristics of the humpback pectoral fin, a new tongue was designed to improve the performance of the centrifugal pump. The influence of three sinusoidal tubercle volute tongues (STVT) and one original volute tongue (OVT) on energy dissipation using the enstrophy analysis method was investigated. To accomplish this, the pressure fluctuations and performances of four centrifugal pumps were analyzed. The results indicate that enstrophy is primarily distributed at the impeller outlet and near the tongue. The total enstrophy of the profiles of STVT was smaller than that of the profiles of OVT. This difference was more obvious near the tongue. The reductions in the total enstrophy of the pumps were 8% (STVT−1), 8.2% (STVT−2), and 9% (STVT−3). The pressure fluctuations of the STVT profiles also decreased to different degrees. The average pressure fluctuations at the monitoring points decreased by 20.6% (STVT−1), 21.7% (STVT−2), and 23.3% (STVT−3). The performances of the bionic retrofit pumps increased by 1.5% (STVT−1), 2% (STVT−2), and 2.45% (STVT−3) under the design flow rate. This study guides the structural optimization of pumps. [ABSTRACT FROM AUTHOR]

Although the energy change field in the centrifugal pump has been investigated under quasi-steady conditions (QSC), equivalent information is not yet known during the rapid starting period (RSP). A centrifugal pump loop system is constructed to investigate the energy change field in the centrifugal pump during RSP. The RSP is selected as a linear rotational speed from 0 rev/min to 2900 rev/min (design rotational speed) and a constant valve opening of 0.569. Results show that the flow rate lags behind the pump head value with the linear increase in rotational speed. The large values of partial derivations of mechanical energy in normal and tangential components are mainly concentrated at the impeller outlet, whose position is insensitive to rotational speed. The region of dominant energy loss is negatively correlated with rotational speed, and an opposite phenomenon is observed in the region of dominant energy increase. With the rotational speed increasing, the mean energy gradient function in the pump impeller and pump volute gradually increases, and the slope of the former is less than that of the latter. After reaching the design rotational speed, the energy change field gradually approaches that under quasi-steady conditions. [ABSTRACT FROM AUTHOR]

Pressure pulsations may cause high-amplitude vibrations during the process of a centrifugal pump. The trailing edge shape of the blade has a critical influence on the pump's pressure fluctuation and hydraulic characterization. In this paper, inspired by the humpback whale flipper, the authors research the impact of applying the sinusoidal tubercles to the blade suction side of the trailing edge. Numerical calculation and experiments are carried out to investigate the impact of the trailing edge shape on the pressure pulsations and performance of a centrifugal pump with low specific speed. Two designed impellers are tested, one is a sinusoidal tubercle trailing edge (STTE) impeller and the other is the original trailing edge (OTE) prototype. The detailed study indicates that the sinusoidal tubercle trailing edge (STTE) reduces pressure pulsation and enhances hydraulic performance. In the volute tongue region, the pressure pulsation amplitudes of STTE at fBPF decrease significantly. The STTE impeller also effectively changes the vortex structure and intensity in the blade trailing edge area. This investigation will be of great benefit to the optimal design of pumps. [ABSTRACT FROM AUTHOR]