Search

In order to meet the increasing pollutants discharge standard, the selective catalytic reduction (SCR) module in the diesel engine after-treatment system is an important means to reduce nitrogen oxide (NOx) emissions. SCR systems are prone to urea crystallization at lower temperatures, especially during the cold-start conditions of diesel engines. In this study, we use the diesel engine after-treatment system test bench to obtain the boundary parameter of the simulation modules, and the urea crystallization risk assessment model of the diesel SCR system is established. Comparing the computational fluid dynamics (CFD) results with the test bench results, it is shown that the predicted urea film distribution of the assessment model is in good agreement with the experimental results. In order to clarify the various factors that affect the urea crystallization risk, this paper conducts a simulation analysis on a nozzle and mixer structure and operating parameters. The CFD results indicate that the increase in urea spray time will increase the maximum urea film thickness on the SCR system mixer surface. Exhaust temperature is the most important influencing factor. When the diesel engine exhaust temperature increases from 190 °C to 300 °C, the maximum urea film thickness decreases by 32 and the urea film mass accumulation decreases by 5%. Exhaust flow has a small impact on urea crystallization risk. When the exhaust flow increases from 300 kg/h to 600 kg/h, the maximum urea film thickness decreases by 39% and the urea film mass accumulation decreases by about 1%. In addition, urea spray rate, nozzle numbers, spray angle, and spray cone angle are also factors that affect urea crystallization risk. [ABSTRACT FROM AUTHOR]

To achieve diesel engine ultra-low nitrogen oxide emission, light-off selective catalyst reduction (LO-SCR) has been suggested for better performance with lower exhaust temperature. An electric heater upstream of the exhaust aftertreatment system was applied to significantly decrease the NOx emission at a low exhaust temperature. With a 7.2 kW electric heater coupled with LO-SCR, the NOx emission during 200~500 s of the world harmonized transient cycle (WHTC) decreased from 282.6 ppm to 61.5 ppm, which is a decrease of 45%. Application of an upstream diesel oxidation catalyst (DOC) decreased the NOx emission by 63% at the same interval at the cost of worse cold-start performance. The urea input was also adjusted to avoid NOx emission during the latter part of the WHTC. [ABSTRACT FROM AUTHOR]

The assembly consistency of a diesel engine will affect its nitrogen oxides (NOx) emission variation. In order to improve the NOx emissions of diesel engines, a study was carried out based on the assembly tolerance variation of the diesel engine's combustion system. Firstly, a diesel engine which meets the Euro VI standards together with the experimental data is obtained. The mesh model and combustion model of the engine combustion system are built in the Converge software (version 2.4, Tecplot, Bellevue, DC, USA), and the experimental data is used to calibrate the combustion model obtained in the Converge software. Then, the four-factor and three-level orthogonal simulation experiments are carried out on the dimension parameters that include nozzle extension height, throat diameter, shrinkage diameter and combustion chamber depth. Through mathematical analysis on the experimental data, the results show that the variation of nozzle extension height and combustion chamber depth have a strong influence on NOx emission results, and the variation of combustion chamber diameter also has a weak influence on NOx production. According to the regression model obtained from the analysis, there is a quadratic function relating the nozzle extension height and NOx emissions and the amount of NOx increases with increasing nozzle extension height. The relationship between emission performance and size parameters is complex. In the selected size range, the influence of the variation of the chamber diameter on NOx is linear. The variation of the chamber depth also has an effect on NOx production, and the simulation results vary with the change of assembly tolerance variation. Thus, in the engine assembly process, it is necessary to strictly control the nozzle extension height and combustion chamber depth. The research results are useful to improve the NOx emission of diesel engine and provide a basis for the control strategy of selective catalytic reduction (SCR) devices. [ABSTRACT FROM AUTHOR]