Search

In the bistatic synthetic aperture radar (BiSAR) system, the unavoidable frequency deviation between the oscillators (USOs) will result in additional phase modulation in the demodulated radar signal, which significantly degrades the quality of the SAR image and digital elevation model (DEM) product. The innovative L-band spaceborne BiSAR system LuTan-1 (LT-1) employs a non-interrupted synchronization scheme to acquire the synchronization phase error. This advanced phase synchronization scheme avoids interrupting the normal BiSAR data acquisition and further increases the synchronization frequency. However, some non-ideal factors in the transmission link like attenuation, multipath effect, interference, etc., may cause the synchronization phase to be polluted by noise. A phase denoising approach based on compressive sensing (CS) is proposed to improve the accuracy of synchronization phase. The imaging phase with high signal-to-noise ratio (SNR) is input into the K-SVD algorithm to learn the prior information, and then the noise of the synchronization compensation phase is eliminated by maximum a posteriori (MAP) estimation. The data acquired from the ground validation system of the LT-1 synchronization module are adopted for the validation experiment. The proposed phase denoising method achieves higher phase synchronization accuracy compared with traditional ones. The processing results verify the effectiveness of the proposed method and demonstrate its potential for future on-orbit applications of the LT-1 mission. [ABSTRACT FROM AUTHOR]

In the bistatic synthetic aperture radar (BiSAR) system, the deviation between two oscillators in different platforms will cause an additional modulation of BiSAR echoes. Therefore, phase synchronization is one of the key issues that must be addressed for the BiSAR system. The oscillator phase error model and the principle of phase synchronization are firstly described. The waveform diversity technology has been widely used in many fields, for example, the hearing aids device and the recognition of auditory input source in cocktail party problem. Inspired by this, an advanced phase synchronization scheme based on coherent integration and waveform diversity is proposed. The synchronization signal and radar signal are orthogonal signals which can be separated by using waveform diversity technique. After extracting the synchronization signal, the phase synchronization accuracy can be further improved by coherent integration. The transmission of synchronization signals between two synchronization antennas is analyzed, followed by the theoretical error analysis. Then, the processing of separating the echo signal and synchronization signal is described in detail. The simulation experiments are performed. The accuracy of phase synchronization can reach 1 degree, which verifies the effectiveness of the proposed synchronization scheme. [ABSTRACT FROM AUTHOR]

Phase synchronization is one of the key technical challenges and prerequisites for the bistatic synthetic aperture radar (SAR) system, which can form a single-pass interferometry system to perform topographic mapping. In this paper, an advanced phase synchronization scheme based on a pulsed signal at carrier frequency is proposed for a bistatic SAR system and it is verified by a ground validation system. In the proposed phase synchronization scheme, the pulsed signal at carrier frequency is used for phase synchronization link, and it is exchanged by virtue of a time slot between radar signals. The feasibility of the scheme is proven by theoretical analysis of various factors affecting the performance of phase synchronization, and the reliability of the scheme is verified by the test results of the ground validation system. [ABSTRACT FROM AUTHOR]

The deviation between the two oscillators in BiSAR systems will cause a residual modulation of echo signal. Therefore, the phase synchronization is an important issue that must be addressed for BiSAR systems. An advanced non-interrupted phase synchronization scheme is used for the LuTan-1 SAR satellite. The synchronization transceiver (STR) is designed for transmitting and receiving synchronization signals. In addition, STR mainly consists of master and auxiliary transceivers and switch module. Furthermore, the function and working principle of STR are introduced, and the detailed design of each part is described. The measured results are also evaluated to prove the performance of the STR. In addition, the phase synchronization accuracy is also demonstrated to verify the effectiveness of the non-interrupted synchronization scheme. The standard deviation (STD) of the residual phase is less than 0.3 degrees. The results have guiding significance for the synchronization unit design of LuTan-1 and the future BiSAR system. [ABSTRACT FROM AUTHOR]