Search

Bio-lubricants are the future of lubricants as a substitute for mineral lubricants; however, bio-lubricants have drawbacks, such as poor thermal-oxidative stability. In addition, during the friction process, the temperature of the lubricant increases, so the lubricant must have good thermal conductivity to conduct heat to the environment. To combat the drawbacks of bio-lubricants, some additives have been used to improve their performance as lubricants. Composites of carboxymethyl cellulose (CMC)/MXene and Span 60 as surfactants were used as additives in CPO with different compositions. The physicochemical properties of the addition of CMC/MXene and Span 60 in CPO have changed, including kinematic viscosity, TAN, thermal conductivity, and fatty acids, which have a positive impact on lubrication performance in terms of reducing oxidation processes and increasing thermal conductivity. From fatty acid composition tests and FTIR analysis, the additives work to suppress the oxidation process. A pin-on-disk test was performed to evaluate the tribological performances of bio-lubricants. The results show that CM 10 SP (0.5% wt of CMC and MXene and 1% wt Span 60) demonstrated a significant decrease in CoF and wear rate by 49% and 74%, respectively, at a load of 50 N and a speed of 1400 rpm compared to CPO without additives. An interface layer of CMC/MXene and Span 60, separating two surfaces, could induce wear on the surface of the disk and pin. [ABSTRACT FROM AUTHOR]

The encapsulation of stem cells into alginate microspheres is an important aspect of tissue engineering or bioprinting which ensures cell growth and development. We previously demonstrated the encapsulation of stem cells using the hanging drop method. However, this conventional process takes a relatively long time and only produces a small-volume droplet. Here, an experimental approach for alginate emulsification in multistage microfluidics is reported. By using the microfluidic method, the emulsification of alginate in oil can be manipulated by tuning the flow rate for both phases. Two-step droplet emulsification is conducted in a series of polycarbonate and polydimethylsiloxane microfluidic chips. Multistage emulsification of alginate for stem cell encapsulation has been successfully reported in this study under certain flow rates. Fundamental non-dimensional numbers such as Reynolds and capillary are used to evaluate the effect of flow rate on the emulsification process. Reynolds numbers of around 0.5–2.5 for alginate/water and 0.05–0.2 for oil phases were generated in the current study. The capillary number had a maximum value of 0.018 to ensure the formation of plug flow. By using the multistage emulsification system, the flow rates of each process can be tuned independently, offering a wider range of droplet sizes that can be produced. A final droplet size of 500–1000 µm can be produced using flow rates of 0.1–0.5 mL/h and 0.7–2.4 mL/h for the first stage and second stage, respectively. [ABSTRACT FROM AUTHOR]